2009 Chevrolet Equinox Logo

Related Topics:

Refugio Posted on Mar 15, 2017

2009 chevy equinox purge solenoid fuse location.

5 Related Answers

mikehumble

  • 124 Answers
  • Posted on Dec 18, 2008

SOURCE: purge solenoid location

purge solenoid is on the intake on the passenger side with a plastic line going to it

Ad

Ronnie Wilson

  • 1596 Answers
  • Posted on Jan 24, 2009

SOURCE: location of the evaporative cannister solenoid? 2003 saturn vue

Depends if the engine is 3.0 or a 2.2?
3.0 purge is on the top, back side of the intake. Black, cylinder. Looks the same on a 2.2, but is located next to the air filter.

Nicholas Csorba Jr.

  • 148 Answers
  • Posted on Feb 17, 2009

SOURCE: purge solenoid location

which vehicle are you actually looking for the purge solenoid on? you have 2 vehicles listed in your question. i'll answer both, lol

the locations are described as if you are looking at the engine from the front of the car with hood open.

on the blazer:

it is located on the left side of the intake manifold just under and behind the throttlebody. it is a canister looking device.

on the silverado:

it is located on the intake manifold on the left side in about the same spot as the blazer. providing the silverado has the 5.3 or 5.7 liter engine. if it also has the 4.3 then obviously it will be the same.

hope this helps!

ddegroote

Dan De Groote

  • 35 Answers
  • Posted on May 25, 2009

SOURCE: fuses of chevy equinox

needle nose plyers, or look for the little white fuse puller on the cover, or under the hood.

airjer995

Jeremy W.

  • 5332 Answers
  • Posted on Sep 29, 2010

SOURCE: diagram for where the canister

3.8 liter - remove the engine cover. As your standing in front of the vehicle it will be located on the passenger side of the engine inbetween the intake plenum and the valve cover. It will have three wires going to it and to vacuum hoses.

3.4 liter - it will be either mounted to the intake plenum in between the throttle body and the EGR valve. It could also be mounted to the coil/module bracket on the backside of the motor in betweent the motor and the firewall. I think its new enough that it should be in the first location I described.

Also on the under side of the hood (if its the original hood) there should be a sticker with a vacuum diagram and the basic location of that solenoid. The sticker could also be mounted on the upper radiator support or the strut tower on the passenger side.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

2009 Chevy Malibu. Where is the evap solenoid location on it please?

https://www.youtube.com/watch?v=34WJXJMNtfY https://www.youtube.com/watch?v=PErhl_mIwGA
0helpful
1answer

Where is the EVAP ONTROL CIRCUIT ON 2010 CHEVY EQUINOX LS 2.4 MOTOR

Where is the EVAP ONTROL CIRCUIT ON 2010 ????? Which part ? Purge solenoid , vent solenoid , fuel tank pressure sensor etc... Your best bet , take it to a qualified repair shop.
0helpful
3answers

Replaced purge valve cannister & tube on 2009 chevy impala ss plus 10amp fuse, gas cap code is p0449; now the check engine light has not went out been 4 days since replace now what 2 do...help help

gas cap code p0449 ??? This is not a gas cap code ! DTC P0449: Evaporative Emission (EVAP) Vent Solenoid Control Circuit.. your best bet , take it to a qualified chevy repair shop .


Wells EVAP Training with Sgt Tech P0440 P0441 P0442 etc
0helpful
1answer

2009 chevy equinox purge solenoid has no powe to the connector. What fuse is it that's bad or does the solenoid get power from another source?

I don't know .
What problem or code are you getting .
I will tell this I'm not a big fan of Chevy fuel systems sense the mid 90's .You have a vent solenoid and a purge solenoid the purge is on the intake manifold and burns the excess fuel vapor from the tank through the vent solenoid you also have filters and a charcoal tank that adsorbs the vapor.You need to look at it closely before you buy parts you may not need or fix the problem .
0helpful
1answer

Where is the location of the Vapor Canister Purge Solenoid on a 2006 Buick Rendevous

Here is a link for locating/replacing the canister purge solenoid on a 2006 Chevy Impala. I couldn't find a video for your Buick, but I suspect it may be located in the same area - near the fuel filler neck. How To Install Evaporative Emissions Canister Purge Solenoid 2006 12 Chevy...
0helpful
1answer

Where is the purge valve solonoid for a 2000 chevy cavalier?

How do I test a purge solenoid? / Diagnosing an EVAP ...

www.ericthecarguy.com/.../13335-how-do-i-test-a-purge-solenoid-diagn...
My brothers 2000 Chevy Cavalier has a P0440 code. ... the PCM will test the circuit condition of the purge valve solenoid and vent valve solenoid so with the key ...

P0446 2000 chevy S10 4WD Replacing EVAP Vent Valve ...

? 7:54
https://www.youtube.com/watch?v=EVWDc9sM1Co
May 7, 2014 - Uploaded by omar ERA
code .P0446. ... Chevy Truck Hard To Fill Gas Tank - GM EVAP Codes P0442, P0446, P0455 or P0449 ...

EVAP Purge Solenoid Removal - YouTube

? 4:24
https://www.youtube.com/watch?v=Xj605HENFno
Feb 26, 2008 - Uploaded by richpin06a
EVAP Purge Solenoid Removal Saturn S-series. ... Hi, is thispurge can solenoid in the same location for ...

0helpful
2answers

Where is the started relay located on my 2007 equinox

The relay should be in the fuse box. fuse box may be located under the hood. or under the passenger side dash down by your feet.
Not finding what you are looking for?

788 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...