Question about 2006 Honda Civic

Open Question

Honda Civic 2006, have a smashed window. Need to get dashboard air vents out to remove glass. How can I remove without breaking?

Posted by on

Ad

6 Suggested Answers

  • 78 Answers

SOURCE: Forgot my username cant log into laptop, help

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Sep 22, 2014

Ad
  • 17 Answers

SOURCE: 1995 Honda Civic Hatchback Rear window

It is possible to change this window on your own. But it is a pain in the ***. So im gonna tell you the easiest thing to do is either go to a junkyard and buy the whole hatch which is relatively cheap. Or you can just call any general glass repair shop and they will come fix this for around $125to 200 bucks. If it were me i would go to the salvage yard.

Posted on Sep 04, 2008

Ad
Brian032472
  • 150 Answers

SOURCE: How to change the HEPA cabin filter in a 2006 Honda Civic

Open the glove box and there are push out tabs on the left and right side pop them out. Now watch it because you are about to dump the contents of your glove box on the floor. let the box hang freely from the lower hinge and look in the back. You will see a white panel that pulls out the panel has a tray attached with the filter element in it remove old element and replace with new 20ish bucks at the parts store lots more at the dealer. re-install filter tray and reverse your removal steps to re-install. Recommended approx 15k or annually

Posted on Nov 04, 2008

  • 57 Answers

SOURCE: I have a 2006 honda civic ex. My power window

probably a broken wire near the drivers door where it opens and closes when you find the almost broken wire it is important to have it soldered and shrink tubed

Posted on Jul 12, 2009

  • 1596 Answers

SOURCE: I need to replace my struts and rear shocks on my

Removal

  1. Raise the rear of the vehicle, and support it with safety stands in the proper locations.
  2. Remove the rear wheel.
    1. Position a floor jack at the connecting point of the trailing arm (A) and the knuckle (B). Raise the floor jack until the suspension begins to compress.
    2. Remove the flange bolt (C) from the bottom of the damper. Discard the bolt.
    3. Remove the trunk side trim panel.
    4. Remove the self-locking nut (A) while holding the damper shaft (B) with a hex wrench (C).
      1. Compress the damper unit (A) by hand, and remove it from the vehicle.
      Inspection
      1. Push on the damper as shown.
      2. Compress the damper assembly by hand, and check for smooth operation through a full stroke, both compression and extension. The damper should extend smoothly and constantly when compression is released. If it does not, the gas is leaking and the damper should be replaced.
      3. Check for oil leaks, abnormal noises, or binding during these tests.
      Installation
      Install the damper mounting bushing (A) onto the damper unit. Position the damper assembly (B) between the body and trailing arm. Be careful not to damage the body

      1. Position a jack under the trailing arm to support the suspension, then install a new damper mounting bolt (A).
      2. Loosely tighten the damper mounting bolt.
      3. Raise the rear suspension with the jack until the vehicle just lifts off the safety stands, then tighten the damper mounting bolt to the specified torque value.
      4. Install the damper mounting bushing (A), the damper mounting washer (B), and a new self-locking nut (C) on the damper shaft.
      5. Tighten the self-locking nut to the specified torque value while holding the damper shaft (A) with a hex wrench (B).
      6. Remove the trunk side trim panel.
      7. Install the rear wheel. NOTE: Before installing the wheel, clean the mating surface of the brake disc or brake drum and the inside of the wheel.
      8. Check the wheel alignment, and adjust it if necessary

Posted on Sep 11, 2009

  • 1 Answer

SOURCE: unlock code for my 2006 Honda civic radio

I have an '06 Honda Civic. The most common places where the code is found is on the left side of the glove box, in the trunk somewhere along the gasket or underneath where the speakers are, under the fuse box panel, under the ashtray and sometimes under center console lid. I happen to find my in the left side of the glove compartment. The first five digits are the code and under that, you should see and 11 digit code which is your radio serial. So once you have the code if you haven't already, turn on the radio. It will ask you for the code and you punch it in using the number on the buttons you use to change your radio stations. As you punch in numbers "CODE" will start to fill in. Just like the asterisks used in passwords. If you punch it incorrectly, it will say "error 1" or something to that effect. Do not push anything else, just start over by punch in the first number of the code and then the rest. Be careful, if you attempt too many times, the radio will lock itself and you will need to leave the radio on for an hour for it to reset itself. When successful done, the radio will turn back on to the last station you were last on. Hope that helps.

Posted on Dec 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 Honda Civic Coupe


Air filter, ECU, O2 sensor, bad EGR valve, or clogged cat converter.

Onboard diagnostic computer should be throwing codes. Autozone can check these free (as will other part stores).

Feb 15, 2013 | 2006 Honda Civic Coupe

1 Answer

How do I remove window glass from passenger side window on 1996 Honda Accord 2 door


To remove the regulator to access the door glass watch the video at the YouTube link

Sep 06, 2012 | 1996 Honda Accord

2 Answers

Does anyone have a print out or do it yourself guide on removing a dashboard on 1990 honda civic 4 door?


http://www.autozone.com has a free online repair guide for your car. You can use it to
enlarge stuff like the JPEG images below, and get detailed instructions.

archaeology_53.jpg

1988-91 Honda Civic Sedan (4-door) Dashboard Assembly Removal

archaeology_54.jpg

1988-91 Honda Civic - non-sedan Dashboard Assembly Removal.

Apr 17, 2011 | Honda Civic Cars & Trucks

1 Answer

I need to install a window in my vw polo. It is the back seat pasanger side window, i have already purchased it and have the inside panel off. My issue is fitting the window inplace without it smashing,...


We don't have Polo in the States but it would be the same design as a Golf or even a Jetta, even a Passat.
  1. Remove nuts from glass clamping jaws, press jaws apart, an access port would reveal both nuts at the same level
  2. Lower door glass into door, pull window channel (Window rubber gasket) out of door frame and remove center connector (metal channel strip that separates vent window. A screw on top and a hex head screw at bottom)
  3. Pull door glass upward, tilt toward front and lift out of window slot
  4. Install in the reverse order of removal
Note: Clamping jaw hex nuts torque spec.......10Nm (7ft-lb)

May 04, 2010 | 1998 Volkswagen Golf

1 Answer

Electrical issues - Dashboard occasionally turns off completely even though engine can run just fine.. when dashboard turns off the hand "break" turns on without the hand break being applied. Someone...


Sounds like a bad ground somewhere... check all the wiring under the hood, make sure everything is tight. A bad ground can cause all sorts of weird problems.

Mar 22, 2010 | 2001 Honda Civic

1 Answer

My dashboard shows a wrench like ikon. Can you tell me the proble


https://techinfo.honda.com/rjanisis/pubs/om/NV0606/NV060606INDXA.pdf


It is a mainteniance minder for oil change and other regular mainteniance.

Here's a link for owner's manual, it is in pdf form.
Just incase you don't have one.

Dec 27, 2008 | 2006 Honda Civic Hybrid

1 Answer

1995 Honda Civic Hatchback Rear window


It is possible to change this window on your own. But it is a pain in the ***. So im gonna tell you the easiest thing to do is either go to a junkyard and buy the whole hatch which is relatively cheap. Or you can just call any general glass repair shop and they will come fix this for around $125to 200 bucks. If it were me i would go to the salvage yard.

Sep 04, 2008 | 1995 Honda Civic

Not finding what you are looking for?
2006 Honda Civic Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Marvin
Marvin

Level 3 Expert

83940 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22441 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...