Question about 1999 Lincoln Town Car
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
You DO NOT need to remove the fuel tank to replace this filter.
My 1999 Signature Series Town Car did not require the special tool. It has two push out clips which hold the fuel lines in place. New clips came in the box with the filter. The clips are off-white in color and look like skinny versions of the plastic safety plugs moms use to keep toddlers from sticking objects into electrical outlets in your home.
The fuel filter is located just below the rear passenger side door - along the outside rail of the frame. It May or MAY NOT require the special tool.
BEFORE YOU BEGIN.
Be sure to depressurize the system by turning the off fuel pump - either by unplugging the cord in the left side of the trunk next to the hinge mount or removing the fuse (#14 20 amp in the fuse box under the hood).
It's a good idea to take a picture of the assembly before starting to refer to when you reassemble it.
Spread some shop towels or rags on the ground to catch any fuel which runs out of the filter when you remove it.
There is a hose clamp holding the filter in its housing - loosen with a screwdriver.
Pop out the two clips then pull the fuel lines out of the filter at each end.
Wiggle the filter out of its mounting bracket, then install the new filter and reinsert the fuel lines into it.
Be sure the clips are inserted correctly to avoid leaks. TIghten the hose clamp.
Replacement took about four minutes and required only a flat-blade screwdriver. Clips pop out and back in with only finger pressure.
Posted on Mar 24, 2009
answer , very carefully ...
drain coolant , remove and mark all vacuum lines , make a schematic to diagram your hose routing, disconnect and plug all fuel lines, remove distributor and mark location of rotor, disconnect battery, remove any necessary cables, brackets and or accesseries, remove intake mounting bolts, note length of bolts and reference location, pry up on intake , remove intake, scrape old gasket off , must be very clean to reinstall new gasket or you will cause a leak..
Posted on Nov 02, 2009
Tips for a great answer:
Apr 17, 2016 | Lincoln Cars & Trucks
Apr 23, 2015 | 1999 Lincoln Town Car
Apr 18, 2013 | 1999 Lincoln Town Car
Feb 26, 2013 | 1998 Lincoln Town Car
Oct 18, 2012 | 1999 Lincoln Town Car
Aug 05, 2010 | 1998 Lincoln Town Car
Mar 29, 2010 | 1986 Lincoln Continental
Dec 25, 2009 | 1999 Lincoln Town Car
1,948 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: