Question about 2000 Ford Focus

2 Answers

My Friends 2000 Ford Focus Se is not blowing air but the cluch on the compressor is engaging but it is not throwing air out of the vents.... I checked the fuses but dont know how to get to the fan what should we do next?

Posted by on

  • teranhomero Jul 23, 2009

    i Realy appriciate the input and will be sure to look at the fuses and the wires but i looked at the fuses and they are all good but i have a strong feeling that it would be the swich to activate and deactivate the fan on the dash bord if you have any info on the swich pleas reply
    Thank you all.

×

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 117 Answers

I am experiencing the same problem with my truck. if you have gone through the fuses, the next step would be to locate the fan motor ("usually") underneath the passenger side dash area....usually...to test, look for broken wires going to the fan motor/housing. if you see broken wires..fix...if no broken wires, test using 12v to see if the fan engages or not using a direct connection. if the fan does not engage when you apply 12v directly to it, then your fan is shot, and you will have to replace it..good luck,

hope that helps

Posted on Jul 23, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 103 Answers

The blower motor is located under the passenger side of the dash. Disconnect the wire harness, key on,heater on, check for power and ground using a volt meter or a test light. If either are missing further checks are required,,, if both are present, replace the blower motor.
Please rate this.

Posted on Jul 23, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Climate control


check your fuses then the blend door motor

Apr 02, 2014 | 2005 Chevrolet Malibu

1 Answer

Why does air conditioning only blow out defrost vent on 2000 ford focus zx3


You have a broken vacuum line in your engine compartment that feeds the a/c ducts air

Jun 26, 2012 | 2000 Ford Focus

2 Answers

Ford 2002 focus blower motor only works on switch


You may have 2 separate problems, check the bower motor resistor first, if it's bad replace it and THEN you should have the fan blowing on the lower settings.

If the ac turns on after you fix this then problem solved, if not it may be unrelated have a pro look at the ac.

Apr 03, 2010 | 2000 Ford Focus

1 Answer

My air conditioning went out to where my vents do not blow air when the AC is on.


If it is blowing warm air then you need to add freon to the compressor. If it does not blow air at all then you have either a blown fuse or a bad fan.

Aug 05, 2009 | 2000 Ford Focus

3 Answers

2000 ford taurs a/c dont work it blows cold when i power up the compressor.its running 45 lbs on my gage on the low side.


Hi...
Perform the following basic Checks and Information
1. Check Drive Belts,If belt is intact proceed to the next step.
2. Check for Compressor Clutch Engagement - Turn the air conditioner to the "on" position and set controls to the coldest setting. Start the engine and allow to idle. Then open the hood and inspect the clutch at the front of the compressor, is it turning? "Engaged" if so, the system has enough refrigerant to activate. If the system is low on refrigerant it will not work properly. In this case an air conditioner recharge kit is needed to recharge the system. If the compressor clutch is not turning proceed to next step.
3. Inspect for Refrigerant Leaks
4. Check under dash panel and under hood power distribution center
5. Check Temperature Control Vents - The vents inside your car are controlled by a cable, electrical servo or vacuum servo. If the vent door is not functioning properly it will cause warm air from the heater to exit the vents. To check this start the car and allow the engine idle, next turn the blower motor speed on low, switch the temperature control from warm to cold while your ear is close to the vents. You should hear the door move inside the heater box as it swings from open to close. If not, inspect for a vacuum leak or a shorted motor in the servo, repair the leak or replace the servo motor.
Thanks
Smith

Jul 31, 2009 | 2000 Ford Taurus

1 Answer

Air conditioning will not cool. Can smell freon thur the vents. This is a 2000 ford focus.


you need to see a A/C tech. you my have a leak throw a seal or evaporater needs replacing

Jul 12, 2009 | 2000 Ford Focus

1 Answer

2000 ford focus se the ac isnt blowing and the motor is good what should i ckeck next


If all the freon is in the system and there are no leaks, then then next point to check will be the electrically driven clutch inside the pulley that drives the A/C compressor. The clutch itself is what turns the A/C on or off. So if the clutch is OK, then probably the switch that drives the clutch is defective.

Jul 07, 2009 | 2000 Ford Focus

1 Answer

Truck AC Blowing hot air. Compressor is turning


defective air temperature control blend door motor.

Jun 26, 2009 | 2000 Nissan Frontier

1 Answer

How do I check the pressure of my compressor?


no that our radiator in the dash (heater core ) thats leaking prestone the fume you got in the window is evaporating prestone you have to get the heater core replace because you gonna run out of prestone(coolantfor the engine) and the engine will overheat and with all the fume you wont see were our going pierre

Oct 04, 2008 | 2000 Ford Focus

Not finding what you are looking for?
2000 Ford Focus Logo

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5522 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...