SOURCE: 2000 buick lesabre stall after starting or after running for 30 minutes
I have a 1996 Lesabre. I had a similar problem that slowly got worse. I brought it to two different mechanics that did diagnostic checks and could only "suggest" what to replace to fix the problem. Their problem was that it wouldnt stall out while they had the mv. After replacing a bunch of sensors and the fuel pump/ filter, I solved the problem by replacing the Crank Sensor. Its located behind the lower crank pulley on the 3.8 lt motor. Hope this helps!
SOURCE: 2000 Buick LeSabre Struts
Yes there are struts on the front and shocks on the back. 2 of each. They are around $50-100 for the fronts. $30-100 for the rears depending if the car has air ride or not.
SOURCE: PCV location on a 2000 buick lesabre
Open hood, top left side between the valve covers. There is a "funky" plastic housing that turns counter-clockwise (less than 1 inch of travel). then pull straight up to reveal the "missing" pcv valve.
SOURCE: 2000 buick lesabre - water pump replacement
first disconnect the battery then check how the serpentine belt is lined up so u can take it off and put back on. Then the pump should be on the side of the motor with 9or12 bolts there could be more! after taking out take razorblad and skrap the old gasket clean wipe of then put new gasket and pump back on dont over tighten the screws cuase the pump my be aluminum.
SOURCE: 2000 Buick Lesabre custom liscense plate bulb
kind of tricky, took me an hour to get it figured out, but you got to opend the trunk and take out the 10 or so 10mm nuts sticking out of the backside of the lid, then the whole solid piece where the lights are on the back will slide off, then you can change the bulbs above the license plate and put it all back together
289 views
Usually answered in minutes!
×