SOURCE: change brakes on a 05 hyundai tucson
rear pad replacement is basically the same as front. 14mm bolts holding caliper and mount on hub then the piston just pushes in
SOURCE: how do i change right headlight bulb on a 2007
You change it like you'd change any headlamp bulb. There is an access cap behind the headlamp assembly -- remove it, then remove the connector to the bulb, then remove the retaining clip/spring holding the bulb in place. Then install/insert the new bulb in the same 'ORIENTATION' as the old one. Reinstall in reverse order... ALAKAZAM!... .done!
SOURCE: 2007 Hyundia Sonata Brake Lights
There was recall for the 2006 and 2007 Hyundai Sonata Brake Light Switch assembly. www.promanuals.net
SOURCE: How do I remove rear rotor from 2005 hyundai
What you have to do is first remove the screws that hold the rotor on to the hub, let off the hand brake shoes(they are located inside the rotors) there is a rubber plug on the face of thr rotor, take that off and loosen the hand brake adjuster! remove the brake caliper and caliper carrier and the rotor should come off! hope this helps
SOURCE: how do I replace brake pads on 2007 tucson. I
use a 14mm wrench or socket to remove the caliper bolts/slides. remove caliper. note how old pads came off, match the new pads with same location of old pads ( check for hardware or indicator location). press the caliper piston in . the correct way is to use a caliper press, apply a little pressure to piston, open bleeder screw, press piston all the way in, tighten bleeder. (or grab a 'c' clamp and slowly push the piston in. i would recommend having the rotors machined to for proper wear and to eliminate vibration. for this remove 2 17mm bolts holding caliper bracket on and rotor will slide off.
39 views
Usually answered in minutes!
×