Question about 2008 Cadillac Escalade Ext

1 Answer

05 escalade rear level switch, where is it located?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 118 Answers

Is mounted on the rear axle, drivers side

Posted on Jul 23, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is AC/Heater blower motor located in a 05 Cadillac Escalade?

Passenger side under the dash behind the glove compartment

Mar 06, 2015 | 2005 Cadillac Escalade

1 Answer

The AC in Rear want blow in my2002 Escalade

Yes there are two fuses and there are relays in the blower motor resistor assembly ! One fuse is located in the under hood fuse / relay box marked RR HVAC Fuse #21 30A Rear Heater, Rear Blower Relays. The other is located in the left Instrument panel fuse block marked IGN 3 10 amp. Fuse # 2. The Blower Motor Resistor Assembly - Auxiliary is In the right rear side panel above the wheel well ! The Fuse Block -Left I/P is On the lower left side of the I/P.Fuse Block - Underhood At the left side of the engine compartment near the battery .

Feb 11, 2015 | 2002 Cadillac Escalade

1 Answer

Escalade rear

Look about the drivers seat and you will see a small round grill, it is the interior temp sensor. This might be your problem.

Mar 28, 2014 | 1999 Cadillac Escalade

1 Answer

Brake light is working but not the tail light?

There are three fuses involved.
There is a 25 amp fuse before the brake switch located in the fuse box under the hood. Then there are two 15amp fuses after the brake switch in the box inside the cabin. One is for the lower brake lights and the other is for the high mount light and the trailer connector.
You would need to know if the 15amp fuse for the lower lights has power when the brake pedal switch is applied.

Feb 01, 2014 | 2004 Cadillac Escalade Esv

1 Answer

2005 escalade rear a/c blowing cool air .front a/c blowing hot

More than likely, you have a blend door actuator problem. Locate the faulty actuator under the dash, usually on the firewall, and replace.

Jul 19, 2010 | 2005 Cadillac Escalade Esv

1 Answer

Could i replace mirror cover on 05 escalade?if so how?

the mirror cover is sold as a mirror in whole with all attaching parts. the inner door trim would be removed to get the old one off. start with the screws behind the inside door handle, remove wiring and all switches must be removed. next the trim can come off

Feb 11, 2010 | 2005 Cadillac Escalade

1 Answer

Problem with alc {automatic leveling control} not comeing on

Check relay switches. Light Grey from factory any browning or yellowing replace.

Mar 20, 2009 | 2004 Cadillac Escalade

1 Answer

Speed sensor on a 05 escalade

Hey Joe, unfortunately, because your escalade is so new (05), there is not much info available yet online as far as free info goes. I checked a couple of sites and no luck. However, for about the cost of a manual, u should be able to access the speed sensor info and MUCH more online @ either 'alldata' or 'eautorepair'. I will do some more research on it tonight to see if I can find that info, but I'm not too hopeful. Is the escalade AWD?

Jan 05, 2009 | 2005 Cadillac Escalade Ext

1 Answer

My 05 Escalade rear air heat is not working- blowing cold air onl

Try blowing ou tthe heat exchanger with compressed air. Make sure it's cool b4 removing hoses..

Dec 02, 2008 | 2004 Cadillac Escalade

1 Answer

Automatic leveling suspinsion

There is a load sensor that tells the computer to turn the pump on and level the car, this is not adjustable on most systems, but the sensor itself may be giving an incorrect signal and hence the low in the rear condition, or high in the front, so the dealer is correct in his answer, but the low ride height condition indicates a problem in the system, and that can be fixed.

Sep 18, 2008 | 2008 Cadillac Escalade Ext

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts


Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides