Question about 1993 Ford Mustang

1 Answer

Installed a 93 2.3 Mustang motor in a VW and have everything hooked up and I have spark to the plugs and 39 PSI fuel pressure but get no start

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,071 Answers

Is there apulse from the crank sensor

Posted on Jul 23, 2009

  • Robb Feb 17, 2012

    Not sure, how can I check that?

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 5.7 vortec installed in 1984 1 ton will start but not run. Fuel pressure is 50 psi. Wiring is installed on motor but from computer to steering column not so much.


You would need to have everything hooked up like it was in the 1998 engine . All computer powers and grounds and all signals from engine to pcm.

May 31, 2015 | Cars & Trucks

1 Answer

2000 chevy tahoe z71 5.7 v-8 won't start. Turns over and fires but will not start. Check fuel pressure and it's 55 psi. WHat's next?


When you say it fires, are you checking for spark at the plugs ?
In most cases you have to figure out if it is spark, fuel, or compression to proceed. A mechanic would also check the computer for trouble codes but you would need a scanner or code reader to do that.

Dec 04, 2012 | 2000 Chevrolet Tahoe

1 Answer

Not starting


Gets fire? So you checked for spark, and you had a good blue spark at the spark plug? And does the engine spin over at the normal rate of speed when you are trying to start it?
If there's a theft deterrent device on your van, some systems immobilize the fuel injector circuit, preventing the car from starting. Any possibility an alarm has been tripped?
The fuel pressure at the injectors needs to be "really high" for the injectors to work properly and for gas to enter the cylinders. Around 40 psi, check a manual for manufacturer's specs. The only way to know your fuel pressure for certain is to hook up a fuel pressure gauge tester to the test port on the fuel rail. Just turning the key on will prime the system and give you a high reading on the gauge, if the fuel pump and filter are good. Cheers.

May 16, 2012 | 2002 Chrysler Town & Country

1 Answer

I have a 1996 mustang 3.8 with 5 speed. it turns over,getting fuel,getting spark,but it will not start


it sounds like its not getting enough fuel pressure that it need to run it

Mar 25, 2012 | 1996 Ford Mustang

1 Answer

1996 4.3 wont start. Turns over, Spark OK, fuel 55psi


Fuel pressure is a little low. Will it start with a couple shots of carb spray in the throttle body? If it does and continues to run than the fuel pump is not providing enough pressure to to open the mechanical poppet valves on the end of the injectors. minimum fuel pressure is 58 psi. One PSI below spec is enough to make it not start.

Also check to make sure there is spark at each cylinder. just because there is spark at the ignition coil does not mean it is getting the the spark plugs. you may have a bad cap or a rotor that is burned through.

Nov 13, 2011 | 1996 Chevrolet S-10 Pickup

1 Answer

Ford mustang tries to start but will not continue running. We checked the battery, spark plugs, starter, and alternator. We believe the problem is either with the fuel pump driver module or the pump...


try spraying starting fuid into the throttle body and see if it runs then for a few seconds. If yes, check fuel pressure. It should be 34 psi with engine running, 40 psi key on engine off. More liley th pump in the fuel tank.

Sep 08, 2011 | 2001 Ford Mustang

1 Answer

Replaced ignition module, spark plug wires, distributor cap, fuel filter, and thermostat. car starts then after a while you turn it off and try to restart it, but all it does is crank, will not turn over....


COULD BE FUEL PUMP.CHECK FUEL PRESSURE SHOULD BE 40 - 47 PSI. WITH NEW FUEL FILTER. IF FUEL PRESSURE OKAY.YOUR SPARK PLUGS COULD BE FOULING OUT BY LEAKING FUEL INJECTORS.CLEAN FUEL INJECTORS BY ADDING A CAN OF SEAFOAM TO 3/4 TO FULL TANK OF GAS.WHEN YOU HOOK UP FUEL PRESSURE TESTER WITH IGNITION SWITCH ON ENGINE OFF FUEL PRESSURE SHOULD READ 40 PSI. TURN OFF IGNITION SWITCH IF FUEL PRESSURE DROPS FAST YOUR FUEL PUMP CHECK VALVE BAD.IF FUEL PRESSURE DROPS SLOWLY IN TEN MINUTES TIME FUEL INJECTORS IS LEAKING A NEED CLEANING.INJECTORS SPRAYING TIP CLOGGED WITH CARBON BUILD UP CAUSING THEM TO LEAK DOWN WHEN ENGINE OFF.

Jul 25, 2011 | 1991 Oldsmobile 88

1 Answer

1997 dodge dakota want start in morng finly get it to crank ran fine till shut it off now next morning want start


First check to see if you have spark at the sparkplug then if you have spark check your fuel pressure it should be between 44-54 psi with key on engine off also ,check fuel filter for restriction.If pressure is below 39 psi then replace fuel pump.But if you don't have spark at the plug then there is a ignition problem. ( coil, ignition coil pickup )

Apr 19, 2011 | 1998 Dodge Dakota

Not finding what you are looking for?
1993 Ford Mustang Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...