I own a 2003 Chevrolet Express 3500 cargo van. The check engine light came on and the local hardware store, break out box indicates that the knock sensor circuit is the problem, bank 2. Which side of the engine is bank 2? To change the knock sensor, do I need a special tool? Where is the knock sensor located?
OK, bank2 is the side where the #2 piston is on. Usually its the pasanger side. To be sure open the hood and see which cylinder head is more forward than the other. the cylinder head set back is the bank 2 side. The knock sensor is located on the bank side of the block. You dont need a special tool. only a wrench. Make sure you clear all codes after installation of sensor.
I have a 2001 v70xc. Just today the heat in the car will only blow warm air if the thermostat knobs...
(More)
I have a 2001 v70xc. Just today the heat in the car will only blow warm air if the thermostat knobs are turned all the way to 80. Anything less and the air blows cool. Any thoughts on what the issue may be?
One of the dash board lights on my 2007 toyota rav 4 won't cut off, what is wrong with it? It's not...
(More)
One of the dash board lights on my 2007 toyota rav 4 won't cut off, what is wrong with it? It's not the oil light
Pontiac GTO 2004 RWD V8 What is the best method of changing the diff oil in my 2004 Pontiac GTO?...
(More)
Pontiac GTO 2004 RWD V8 What is the best method of changing the diff oil in my 2004 Pontiac GTO? There is no drainage plug near the base of the diff housing (only a plug for inspection and top up). Thank you. Thanks