Question about 2000 Jaguar S-Type

1 Answer

2000 s=tpye jag door ajar signal when door is closed

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

Your spacer may be damaged try as new one may fix problem

Posted on Jul 23, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to diagnose which door is causing the door ajar warning on dic for 08 pontiac g6 4cyl 4dr


It should tell you which one .
Driver Door Ajar Malfunction
Passenger Door Ajar Malfunction
If not a scan tool would be the best way.
Ignition ON, observe the scan tool Driver Door Ajar Sw parameter while opening and closing the driver door. The parameter should change between Door Closed and Door Ajar
? If the parameter does not change, refer to Driver Door Ajar Malfunction.
With the passenger doors closed, observe the scan tool Door Ajar Switch parameter while opening and closing each door. The parameter should change between Door Closed and Door Ajar.
? If the parameter does not change, refer to Passenger Door Ajar Malfunction

Ignition OFF, disconnect the harness connector at the driver door latch.
Test for less than 5 ohms between the ground circuit terminal 8 and ground.
? If greater than the specified range, test the ground circuit for an open/high resistance.
Ignition ON, verify the scan tool Driver Door Ajar Sw parameter is Door Closed.
? If not the specified value, test the signal circuit terminal 6 for a short to ground. If the circuit tests normal, replace the BCM.
Install a 3A fused jumper wire between the signal circuit terminal 6 and the ground circuit terminal 8. Verify the scan tool Driver Door Ajar Sw parameter is Door Ajar.
? If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
If all circuits test normal, test or replace the driver door latch

Dec 26, 2016 | Pontiac Cars & Trucks

1 Answer

What color are the wires that go from door switch to dome lights on a 2005 mustang v6 conv.


The door switch doesn't go to the dome lights , the switch (door ajar switch ) is an input to the SMJ - smart junction box or body control module take your pick .
Principles of Operation
When the SJB detects a request for lighting, it turns on the interior lamps by supplying power to the lamps. The request for lighting can be an open door signal from a door ajar switch, an interior lighting on command from the instrument panel dimmer switch or an unlock command from a remote keyless entry (RKE) transmitter.
The door ajar switches are hard-wired directly to the SJB. The 2 door ajar switches are normally closed when the doors are closed. The decklid ajar switch is normally closed when the decklid is closed. All door ajar switches receive voltage from the SJB and each has its own ground circuit.
The instrument panel dimmer switch receives a ground signal from the SJB. The instrument panel dimmer switch provides variable resistance for backlighting the instrument cluster and a toggle ON/OFF function for the interior lights.
The RKE receiver is contained inside the SJB. When the SJB receives an unlock request from an RKE transmitter, it unlocks the doors and turns on the interior lamps. There could be DTC'S diagnostic trouble codes stored in the SJB ! You can not access these codes with a OBD2 code reader , need a factory scan tool .
B1319 Driver Door Ajar Circuit Failure Go To Pinpoint Test D . B1327 Passenger Door Ajar Circuit Failure Go To Pinpoint Test D . B2021 Dome Lamp Input Return Circuit Failure Go To Pinpoint Test A . B2550 Dome Lamp Output Circuit Short to Ground Go To Pinpoint Test A . B2554 Dome Lamp Output Circuit Failure Go To Pinpoint Test D . Do you know B-codes -body control .
Your best bet is to take to a ASE certified repair facility or a Ford dealer .

Jan 01, 2016 | 2005 Ford Mustang V6

1 Answer

How to disconnect door ajar signal on dash ?


one thing you can try is to take out the fuse for the door ajar button . this will take it off for sure. you can even try putting it back to see if it may reset

Jul 14, 2014 | 1998 Lincoln Mark VIII

1 Answer

Car ajar light and alarm goes off on 2005 tribute


Pits one of the five door ajar switches. They are located in the door latch mechanism that holds the door closed. The best way to figure out which one it is is to scan the body control module. With all the doors closed. It will tell you which door is giving the open signal. This will need to be done with a high end scan tool that any good shop or the dealer will have. The most common one to fail is the driver front door.

Apr 04, 2013 | 2005 Mazda Tribute

1 Answer

Frequently the door ajar alarm will not turn off even after you close the door .


{: ) Some models use the front doors only, others use all doors for any ajar signals, and may even indicate a message on the DIC that a door is ajar or open. You can try to slam the doors one by one to get that real tight closed door and you may manually make the adjustments.
However if there are wiring or components issue, it can take you long time to search and diagnose. Using a scan tool is the fastest way to locate the main cause.
The three most possible and common cause are the doorlatches, improper adjustments, and shorted signals on the wirings.

Jul 18, 2011 | Chevrolet Silverado Cars & Trucks

1 Answer

I have a 2003 jag x type and the door indicater is on is that bad?


Lubricate the door latches, the sensors for 'door ajar' are located there and can get hung up-after spraying, allow it to sit for a couple of minutes, then open and close the door 6 to 12 times (each door) to free the sticking mechanism.

May 24, 2011 | 2003 Jaguar X-Type

1 Answer

05 JAG no turn signal interior dome lights door ajar light on


Thank you so much for your follow up about the loose connection under the glove box..

I had exactly the same problem and the local ford dealer could not fix it. Was going to take it to the Jag dealer but did a search and your question and follow-up saved me a trip and $

Apr 23, 2009 | 2004 Jaguar X-Type

1 Answer

My passenger's door open indicator is on but the door is closed. Where is the indicator located? 2005 freestar. Thanks


Normal Operation When any door or the liftgate is opened, the ajar switch provides a ground signal to the smart junction box (SJB). When the door or liftgate is closed, the ajar switch opens, removing the ground signal. The SJB uses the multiple inputs from the ajar switches to determine whether the doors or the liftgate are in the open or closed position. The SJB then provides a message to the instrument cluster over the communication network. The message center uses this information to display the door/liftgate ajar message.

I suspect your door switch is not closing all the way.

Mar 28, 2009 | 2005 Ford Freestar

1 Answer

2000 lincoln continental door open


all fords/lincoln/mercury have a door ajar switch on all 4 door latches you can change just the switchs & some have a door conrtol module i have seen somw fords internal wiring & just pull the door ajar bulb out or just ignor it

Mar 02, 2009 | 2000 Lincoln Continental

1 Answer

Back window


lube lock and latch area with WD 40.open and close gate or window several times,this may free up the door ajar switch.

Oct 18, 2008 | 2000 Ford Expedition

Not finding what you are looking for?
2000 Jaguar S-Type Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75077 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...