Question about 2005 Jeep Grand Cherokee

1 Answer

How do I get to the registor so I can fix the problem?

My AC only works on high velocity.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Jeep Master
  • 76,630 Answers

Replace the blower motor speed control resistor

Posted on Jul 22, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Reasons for excessive fuel consumption for 407 hdi

Gas leak, under inflated tires, excessive bearing friction, high speed operation, clogged air filter, improperly working computer, heavy junk in trunk or truck bed, open windows at high velocity, clutch or transmission slippage.

Aug 20, 2016 | Cars & Trucks

1 Answer

2005 Ford E-350. With MAX. AC full on, pulling a trailer at 70 mph. While going uphill, the ac air velocity both front and back slowly dies to zero, AND rear heat goes ON full blast. This effect will...

This is a problem with your cooling unit and it needs to be taken to a shop to get fixed. Different variables could be involved in why it is doing this.

Apr 17, 2011 | 2005 Ford F 350 Super Duty

1 Answer

My truck is a 99 gmc sonoma and it has 2 high velocity drive shaft yokes on it, and the rear one went last night. can i put a regular drive shaft on? or do i need to put one in with the high velocity...

Hello, the constant velocity joint shaft was used to remove vibration in this wheelbase truck. sometimes it worked well, sometimes it made matters worse. You can replace this shaft with a 1 piece, 2 joint shaft, and not have any safety issues, as long as the correct length shaft is used. I have seen some vibration issues doing this, but I have also seen this work without an issue. You can buy constant velocity joints still, in case you want to have yours rebuilt. Good luck...Coop

Sep 30, 2010 | 2001 GMC Sonoma Extended Cab

1 Answer

The ac only work on high velocity

you will need to replace the blower motor speed control resistor, it is located on the outside of the air duct near the blower motor.

Jul 21, 2009 | 2005 Jeep Grand Cherokee

2 Answers

Ac not working properly

freon is low. needs to be emptied. checked for leaks. fixed. refilled.
after it's filled they should check the pressures to make sure the compressor is ok.

Jun 26, 2009 | 1996 Chevrolet Cavalier

2 Answers

Week air flow

I had the same problem, found out it was the filter which is located in the glove box, open the glove box and the back panel should lift up and out and u will see the white plastic guard for the filter, take it off and pull out the filter and replace it.

May 27, 2009 | 1995 Lexus LS 400

2 Answers

2005 Dodge Dakota AC and Heater both dead but the blower works!

I would suggest changing the control head. You should be able to source a used unit from a local salvage yard.

Apr 28, 2017 | 2005 Dodge Dakota

2 Answers

Air Conditioner

My problem with the AC is a little different but I bet it the same solution. The AC blower mudule. When mind went bad my blower would not turn on. It's about a $85.00 part and about $75.00 to have it put in. And hard to get a hold of. Good luck!

Jul 14, 2008 | 2003 Nissan Pathfinder

1 Answer

1994 Hyundai Excel Air conditioning RADIATOR´S FAN works always very fast

this not really a problem as the fan speed is controlled by the high preasure switch in the ac system the hotter it is outside the higher the preassure will be in the system as hot as its been the preasure is high already when the compressor cycles it pulls suction on one side and outputs high preasure on the other the fans cool the condenser the higher the ambient temp the faster they go so all is fine...

Jun 08, 2008 | 1994 Hyundai Excel

Not finding what you are looking for?
2005 Jeep Grand Cherokee Logo

102 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides