Question about 2001 Volkswagen Beetle

1 Answer

After driving for a while and u stop put it in park it will not go back in reverse

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,071 Answers

Sounds like a vlve body problem may be cheaper to buy used transmission

Posted on Jul 23, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car in park turn key starter engages engine starts and you can hear the Bendix still spinning in the ring gear put car into drive and then they stop spending


Does the starter engage again when you go back to park ?
Shifting from park to drive would cut the circuit from the key switch to the starter. The neutral safety switch prevents you from cranking the engine in drive or reverse.
I would say the key switch is not turning off power to the starter when you go from start to run.

Sep 14, 2015 | Cars & Trucks

1 Answer

I have a 1991 Toyota Camry 4 cylinder automatic transmission. I was driving about 10 mph when it just stopped moving. The engine starts and runs fine but when I put it in drive or reverse it won't drive....


You have internal problems with it. Clutches are bad, or could be a hard part broken. The grinding is from the inside of the transmission turn and you put it in park. This is a normal sound, if you were driving and slammed it in park. Except your not moving.

Dec 30, 2014 | Cars & Trucks

1 Answer

Transmission for 1999 cara van


did you check the fluid in the transmissin it could be low or also it could need a new transmission filter i wouldnt try to drive it it anymore without checkin or changin it because it will burn it up

Feb 16, 2013 | 1999 Dodge Grand Caravan

1 Answer

I have a problem with my shift gears, in order for me to drive (D) I have to put in on 1 or 2, to reverse (R) I have to put in on (D) drive, to park (P) I have to put it on reverse (R). Tell me what's


sounds like the cable from the gear stick to the gearbox selector switch has been put on wrong ,put the car into reverse so that the reverse light is on , turn the ignition off and find the gear selector on the gearbox , pop the end of the cable off it then put the gearstick into the "R" position and refit the end of the cable back onto the selector switch , hope this helps

Feb 11, 2013 | Cars & Trucks

1 Answer

When I try to shift from park to drive it gets tight at reverse as if doesn't want go but once out of reverse it shift normally until shifting back to park when I have to go threw reverse then it tightens...


Is it only when you go from park to reverse? Or is it just as bad going from neutral to reverse? I've noticed on mine that it's often tight if I park on even a slight slope. If it only happens when going from park to reverse, try this. Hold your foot on the brake, and put the car in drive. Keeping constant pressure on the brake, go back to park, then back into drive. Did you feel the stiffness when you had your foot on the brake?

Oct 18, 2010 | 2004 Pontiac Grand Prix

1 Answer

Trans in park computor read out on dash reads it is in drive


You most likley have a bent/damaged shifter cable. Unhook it at the trans, and move the linkage, with the park brake set. Push it all the way forward, that is park. The display should change and it should start. If so you will need the cable. Good Luck

Jun 05, 2009 | 2004 GMC Envoy

Not finding what you are looking for?
2001 Volkswagen Beetle Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75066 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...