Question about 1985 Ford Ranger

1 Answer

My son's 1985 ford ranger v6 starts, runs for less than a minute and then stalls when stepping on gas pedal - fuel pump problem?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Yes it is the fuel pump. the fuel pump is usually underneath the driver side door.

Posted on Jul 22, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford ranger 1996 4.0L v6 single cab long bed it runs but you have 2 have your foot on the gas it does not stay in idle for more than 5min less than that usually it does not take much gas pedal pressure to...


I would suspect that you have a failing fuel pump, the fuel pump pressure is bleeding off due to a faulty check valve, this causes hard starting esp when cold or after sitting. The fuel pump is located inside the fuel tank, the fuel tank must be removed to replace the fuel pump assembly.

Feb 09, 2012 | 1996 Ford Ranger SuperCab

1 Answer

I got 1985 ford ranger V6 2.8 i can put fuel in the gas reservor on the carb and start it it will stay running tell that gas runs out i checked the fuel filter and it was good the fuel pump is on the motor...


pull the fuel line off the carb be careful have some one crank the motor quick other wise you will have fuel every ware now if the pump is working you shood see fuel shoot out of the line the motor will have to make atleast 1 full revalotion to check if nothing comes out thare you have it fuel pump let me no if you need any thing else bob

Apr 26, 2011 | 1985 Ford Ranger

1 Answer

My 1986 ford ranger 2.9 v6 engineafter driving for a while it sputters from gas and stalls.does it have (2) fuel pumps? 1 in the outside frame and 1 in the tank?


Yes there are two (2) fuel pumps on these pickups, one low pressure one in the tank that gets the fuel to the high pressure pump which is in the inside of the drivers frame rail beneath the cab towards the front of the cab.

Jul 01, 2010 | 1987 Ford Ranger

1 Answer

My 1985 ranger 2.3 gas FI 4x2 starts and then idles rough, with fluxuating rpm and then stalls. Usually the second time I start it, it runs fine until I turn it off again. Occasionally it will stall while...


Did i answer you before? Anyway, try cleaning the throttle body with a little carb spray on a cloth shop towel wraped on a screwdriver.With the engine off,remove the tube to the t-body,hold the throttle alittle, and spray a couple of squirts inside.Spray some to wet the towel, and pushing it in and out gently of the t-body.becareful not to bend the plate inside or leave any towel inside.look at it with a flashlight to see if it's clean. Hope this helps

Oct 02, 2009 | 1985 Ford Ranger

2 Answers

Truck stalls while driving, will start again if wait ten minutes


if it is a flex fuel vehicle, it most likely is the flex fuel sensor and/ or connector- it's located on the driver's framerail just behind the door.hope this helps and good luck

May 29, 2009 | 2005 Ford Ranger

1 Answer

Will not stay running


put a pump back into the tank --and this will take care of the fuel delivery problem

Jan 05, 2009 | 1992 Ford Ranger

1 Answer

Motor bogs down at stoplight when pushin gas pedal


The fuel pump relay will cause a stalling or no start condition. You are likely having mass airflow sensor, fuel pump, or fuel pressure regulator issues.

Bret
RepairPal.com

Nov 08, 2008 | 1985 Volvo 740

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

445 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...