You're more likely have to remove the transmission. Loosen one motor mount use an engine hoist to hold the engine up in order to remove the plan.
SOURCE: i have a 1999 gmc
If you have front end problems like an pitman arm or idle arm needs to be replaced, it may not got into 4 wheel drive. Go to the nearest muffler shop or mechanic to have them lift up your truck to see if something needs to be replaced.
SOURCE: 1999 gmc jimmy w 4.3 v6. cannot find oil filter
look under the front of your blazer, just below the bumper, and you will see a little access door in the plastic guard. Open this door, and you will find your oil filter.
SOURCE: how do I change the transmission fluid and filter?
Its not really that hard. You just need to take your time and a very large pan. Your filter is just in side the trans pan. The pan will have to be dropped. A ratchet and socket will make short work of it. Just undo the bolts on the trans pan( undo 3 corners and the bolts on that side, allowing the pan to lean to drain some of the fluid). Hold pan steady, and undo remaining bolts. Lower the pan. Now its time to scrape the old gasket off the pan and trans case. Please clean to metal, don't want leaks. Remove the old filter, and replace with the new one. Install the gasket to the pan, and bolt the pan back into place. If you put 4 bolts from around the pan, makes it easier to put the rest in. Now to refill the trans, you need a funnel and add the fluid ant the dipstick. Bring it back up to level. This job will take a beginner about one hour. Hope this helps
99 views
Usually answered in minutes!
×