Question about Ford Cars & Trucks

1 Answer

The heat completely stopped blowing in my 2005 Ford Focus ZX4 what could be the problem?

Posted by on

  • Danielle Cox Jan 24, 2017

    Thanks Super Juli Mazimo but the heat isn't blowing at all there is no air blowing out of vents. Could that possible be Heater Blower Motor fuse?

  • superjulimaximo
    superjulimaximo Jan 24, 2017

    Absolutely. I answered a similar question a few hours ago where the owner had a failing blower motor but that scenario is unlikely. In your scenario, I'd look at fuses, loose connectors, stuff pertaining to getting power down to the motor. Don't forget to check fuses under the hood too. Sometimes they tie things into other circuits so it wouldn't hurt to check all the fuses, in and out.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 319 Answers

If it's just temperature, like you're getting cold air, make sure your engine is warming up. If it isn't, check coolant level. If that's good, you might need a thermostat (especially if it takes a long time to warm up). If the fan isn't blowing at all, check fuses for the blower motor. If you only get hi speed out of the blower Motor but not low or medium, your resistor block is the likely problem.

Posted on Jan 24, 2017

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1168 Answers

SOURCE: what type of antifreeze is used with a 2005 Ford Focus

Hello mk12x.

Ford specification is Motorcraft Premium Engine Coolant VC-4-A (in Oregon VC-5, in Canada CXC-10) or equivalent meeting Ford specification ESE-M97B44-A (green color) with a mix of 50-50 coolant and clean water.
I hope your repair goes well for you.

Kl

Posted on Dec 17, 2009

  • 149 Answers

SOURCE: how to install ford focus 2006 zx4 serpentine belt?

what is your question? what dont you know how to do? do you have tools? belt diagram available from parts stores. you have a tensioner, so you need to turn it to release tension. other than that i need more info.

Posted on Mar 07, 2010

2coolrick
  • 560 Answers

SOURCE: diagram on how to install ford focus 2006 zx4 serpentine belt?

Autozone or a similar parts retailer will print one for you for free.

Posted on Mar 07, 2010

c17hydro
  • 2989 Answers

SOURCE: how can i add freon to my cars' air conditioner

Charging the System

  1. Lubricate the refrigerant system with the correct amount of clean PAG oil.
  2. Connect an R-134a A/C service center to the low-side and high-side service gauge port valves following the operating instructions provided by the equipment manufacturer.
  3. Set the refrigerant charge amount, and charge the refrigerant system following the instructions provided by the equipment manufacturer.

Posted on May 23, 2010

saailer
  • 1871 Answers

SOURCE: I need the diagrams of

Hello! Here are the diagrams you requested...Guru...Saailer

dceda97.gif
9409e4b.gif
7723f42.gif
e0878d9.gif
8f6351c.gif

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

Posted on Oct 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i remove a dash on a 2005 ford focus zx4?


there is going to be a whole lot of screws, take a few pitchers as you go unless you can remember everything from start to finish take the battery connections off then you can get going, take the glove box out,kick panels off drop the steering column down but don't pull it out just unbolt it remove the center console, just pay Attention to how you take the dash apart.

Dec 15, 2016 | 2005 Ford Focus ZX4

1 Answer

I got a zx4 2005 ford focus that will not engage when I put it in to gear. What can I do?


broken cable. try operating the gearshift while looking for the operation on the transmission itself. raise hood and observe the transmission.

Apr 16, 2015 | 2005 Ford Focus ZX4

1 Answer

Air condition


What does "evaporator is working" mean ?
Are the compressor and radiator fan running ?
Is the system full of freon ?

Jul 20, 2013 | 2005 Ford Focus ZX4

1 Answer

Diagram for heater control box for ford focus 2005 zx4 se


what do you need ? the one going to the blower motor or blower resister or the blend door motor

Jan 06, 2013 | Ford Focus Cars & Trucks

1 Answer

2005 ford focus zx4 ac compresser making noise when ac is turned on


Yes, it could be the ac clutch or the compressor itself.

Jul 08, 2012 | 2005 Ford Focus

1 Answer

2005 ford focus zx4 fuze diagram/ fuze diagram


No fuse? Or no slots? If 53 has little metal terminals inside the slots to accept a fuse, then fuse it! Someone pulled it out and put it into 52. If there was a previous owner who blew his heated seat fuse, maybe he traded his back-up lights for a cozy heated seat!
If, however, #53 has nothing there, like just an empty place of the fuse box-not wired, then indeed, strange. Is that the owner's manual you referred to? That should be accurate, if it's the owner's manual. Look closely at that #53
Good luck..

Jun 27, 2012 | 2005 Ford Focus ZX4

1 Answer

Need to know if my 2005 ford focus zx4 se is a timming belt or chain?


Timing belt, good for 100,000 miles before replaicng. They go to 150,000 easy and it is a freewheeling engine, no dmamge to valves or pistion if it breaks

Gerry from Ford.

Apr 22, 2011 | 2005 Ford Focus

2 Answers

My Ford Focus 2005 ZX4 - cruise control stopped working


Welcome to FixYa.com,
Have you checked the fuse ?
Let me Know, Lee

May 27, 2010 | 2005 Ford Focus

1 Answer

What type of antifreeze is used with a 2005 Ford Focus


Hello mk12x.

Ford specification is Motorcraft Premium Engine Coolant VC-4-A (in Oregon VC-5, in Canada CXC-10) or equivalent meeting Ford specification ESE-M97B44-A (green color) with a mix of 50-50 coolant and clean water.
I hope your repair goes well for you.

Kl

Dec 17, 2009 | 2005 Ford Focus

1 Answer

2005 Ford Focus ZX4 AC switch in dash does not move the blend to control where the heat goes in car.The AC switch which attaches to the button and to the mechanism under the dash but the new switch stopped...


Sounds like there is a foreign object in the heater case. The only way to reapair it is to remove the object by possibly removing the heater case.

Nov 08, 2009 | 2005 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

gerry bissi

Level 3 Expert

4387 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...