SOURCE: 1992 Honda Accord LX won't start - ignition problems
you have to replace the main relay located inside the car, its located underneath the cruise control module, on the drivers side
SOURCE: spark plug diagram conection for a honda accord lx
The firing order is 1-3-4-2.
The diagram below will apply to all of the 4 cyl motors Distributor rotation is clockwise
1.8L
SOURCE: 1996 Honda Accord Rough Idle Even After tune up
Perform a valve clearance inspection and adjust if necessary. Tight or sticking valves will cause a misfire or rough running concern. Note: Perform valve adjustment when the engine is stone cold. 4cyl: INT 0.26mm EXH: 0.30mm (V6 engine are hydraulic and no adjust necessary.) Also check for a sticking or stuck open EGR valve. For diagnostic purposes only: Remove the EGR valve. Place a business card over the EGR passage and bolt the EGR valve back on. This plugs the EGR ports and if the misfire goes away the EGR valve is partially stuck open and is defective.
Check for low fuel pressure. Check for low compression. Check cam timing. Check for a weak ignition coil. Also don't over look the possibility of worn or broken engine mounts which cause excessive engine movement and engine vibration. -hope this helps
SOURCE: My 1993 Honda Accord LX was having problems to
The Main relay on your vehicle is defective. When the relay is operating while the engine is started and running, it gets hot. Add the hot weather to the relay and they break inside. The relay is located on the side firewall driverside above the left kick plate inside the car,and is secured with a 10mm hex cap screw (bolt). Replace this relay, and your vehicle should start.
It looks like this;
SOURCE: What is the firing order and which is the number 1
Check this out
Testimonial: "the information was exactly what I needed, thanks"
75 views
Usually answered in minutes!
×