Question about 2013 Chevrolet Impala

Open Question

2013 Chevrolet impala's location of bank 2 sensor 2.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
dttech
  • 4803 Answers

SOURCE: where is the bank 2 sensor 1 located.

Oxygen sensors are always numbered like this:

Bank 1 sensor 1
Bank 2 sensor 1
Bank 1 sensor 2
Bank 2 sensor 2

some manufacturers use a kind of shorthand that reads different, but means the same thing:
Sensor 1/1 or O2s 1/1
Sensor 2/1 or O2s 2/1
Sensor 1/2 or O2s 1/2
Sensor 2/2 or O2s 2/2

Bank 1 is always the side of the engine where cylinder number 1 is located and, of coarse, Bank 2 is the opposite side.
On a 4 cylinder engine, there is only 1 bank and it is always referred to as Bank 1.

Sensor 1 is always the upstream sensor (The one located BEFORE the catalytic converter)
Sensor 2 is always the downstream sensor (the one that is located AFTER the catalytic converter.

Most GM engines have #1 cylinder located on the left bank, (or Driver's Side) of the engine,

So, the answer to your question would be that you are looking for the sensor located before the catalytic converter on the right (or Passenger Side) of the truck.

Posted on Oct 17, 2009

Ad
roniecon
  • 6927 Answers

SOURCE: were bank 1 sensor 2 located on a 1997 tahoe

bank 1 is the drivers side,and it is the down stream sensor,the one after the cat,converter,If this was helpful,please let us know,thank you.

Posted on Jan 03, 2010

  • 1857 Answers

SOURCE: Code p0141 02 Sensor Heater Circuit Malfunct Bank #1 Sensor2

after the catalytic converter on the driver side in the exhaust pipe.

Posted on Jul 07, 2010

Testimonial: "Awesome info. Thanks!"

  • 335 Answers

SOURCE: where is the coolant temperature

Hello and welcome. here is a picture of the coolant sensor. the coolant sensor is mounted just below the thermostat housing in the intake manifold.





2eb9d84.gif

Posted on Oct 04, 2010

SOURCE: i need a diagram showing

Why would you need a diagram?

You simply need to educate yourself

O2 Sensors have been on vehicles over 25 years,and in the same place

Sensor 1--in exhaust pipe before converter or in converter
Sensor 2 in outlet of converter

An O2 Sensor Code---Does Not mean replace it

Posted on Oct 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where are the 02 chevy impala 3.8L o2 sensor locations, I only see three. the top bank one sensor 1 is stripped out, how do i get that one out?


you can apply pressure to the sensor while undoing it to force it out or you will have to cut out the thread area and get an O2 sensor bung hole replacement at an auto supply store and weld into place and install a new O2 sensor. bank 1 sensor 1 is located in the front pipe off the manifold that has cylinder #1 on and bank 2 sensor 1 is on the side that cylinder #2 is on like sensor 1. sensor 3 is the one just before the cat.

Sep 17, 2014 | 2002 Chevrolet Impala

2 Answers

Where is heated oxygen sensor bank 2 sensor 1 located 2005 galant 3.8


On the back side of the motor follow the manifold down to the exhaust pipe and then it is the 1st sensor you come to.

Jul 08, 2014 | 2005 Chevrolet Impala

1 Answer

I have a 96 impala o2 sensor out bank1 sensor2 where is that located


Sensor 2 should be in or immediately after the catalytic converter for bank 1, assuming that its true dual exhaust and dual cat.

Sep 09, 2011 | 1996 Chevrolet Impala SS

3 Answers

I am trying to locate the Oxygen Sensor on my 2003 Impala?


Chevrolet Impala comes equipped with two oxygen sensors, one on either side of the catalytic converter. Locating the sensors is as simple as crawling under the vehicle.

  1. Location
    • The bank 1, sensor 2 oxygen sensor is located downstream of the catalytic converter. To get to the sensor, crawl underneath the vehicle and trace the exhaust pipe until you reach the catalytic converter. Continue to follow the exhaust pipe until you reach the bank 1, sensor 2 oxygen sensor.

    Identification
    • You should be able to identify the oxygen sensor as a single wire about 3 to 6 inches long. The oxygen sensor is mounted to the exhaust pipe and should slightly protrude from the pipe.

    Function
    • The oxygen sensor is an important part of the vehicle exhaust system. The sensor tests the amount of air in the exhaust stream. It then sends this information to the engine control computer, which determines how much fuel is necessary to maintain a proper air-to-fuel ratio.


If this free advice was helpful, a vote with the thumbs up would be greatly appreciated.
Thanks

Aug 25, 2011 | 2006 Chevrolet Impala

1 Answer

Where is the location of the o2 sensor in a 2002 chevy impala 3.8l engine?


if you look on the back side of the engine closest to the firewall there will be one in the exhaust manifold. That one will be the bank 1 sensor 1 O2 sensor.

If you look under the car there will be one right after the catalytic converter. That will be the bank 1 sensor 2 O2 sensor

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Jul 06, 2011 | 2002 Chevrolet Impala

1 Answer

Po141 sensor heater circuit malfunction bank 1 sensor 2, where is this sensor located?


Its your bank 2 oxygen sensor, its located after the catalytic convertor. They call it downstream in the parts house.

Jun 20, 2011 | 2001 Chevrolet Impala

2 Answers

Where is the O2 sensor Bank 1 on a 2005 chevy impala


BANK 1 UP STREAM OXYGEN SENSOR LOCATION IS LOCATED ON THE REAR EXHAUST MANIFOLD.

May 18, 2011 | 2005 Chevrolet Impala

2 Answers

Where is the oxygen o2 sensor located on 2004 impala bank 1


I have a 2002 Impala with 3.8L, and just replaced my Bank1 O2.
It is located between the firwall and the middle of the engine, straight down past the spark plugs. Maybe 12 inches from the top of the engine.
As I recall the plug for the sensor is clipped to a bracket at about spark plug level.
I recommend using the crow foot style wrench to remove and install.

Jan 04, 2011 | 2005 Chevrolet Impala

2 Answers

Knock sensor where is it located 2004 impala 3.8l


There are two knock sensors one for each cylinder bank

Knock Sensor (Bank 1) (3.8L VIN K)On lower left side of engine, near starter.
Knock Sensor (Bank 2) (3.8L VIN K)On lower right side of engine. See Fig. 3



emissionwiz_49.jpg

Nov 30, 2010 | 2004 Chevrolet Impala

1 Answer

I would like to know the Location of the P0036 on a 2005 Chevy Impala LS. Motor: 3800. Also how to replace it.


P0036....HO2S Heater Control Circuit (Bank 1 Sensor 2)
location is Bank 1 is on the side of number 1 cylinder. Sensor 1 is on the exhaust manifold. i would change the oxygen sensor on the exhaust manifold i believe thats the one closes to the front of the car with the hood up. good luck

Apr 16, 2010 | 2005 Chevrolet Impala

Not finding what you are looking for?
2013 Chevrolet Impala Logo

Related Topics:

782 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Jonah Oneal

Level 3 Expert

14053 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...