Question about 2000 Buick LeSabre

1 Answer

How do i replace front lower sway bars on my 2000 BUICK LeSABRE ?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,865 Answers

Take off the old one, and install the new one

Posted on Jul 22, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2000 Buick Century grinding sound coming from the front end and while turning either direction can feel a thumping in floor. Cv boots are good noticed that right side of sway bar has been removed. ?

need to check c/v axles not just look at the boots -- boots cover the joints and joints wear out have to check for play --check and inspect hubs [wheel bearings] --and as to sway bar replace mising part or whole if its damaged

Dec 14, 2016 | Buick Cars & Trucks

1 Answer

How do you replace the front sway bar on a 98 buick lesabre

The sway bar has quite a bit of tension. You may want to consult a shop repair manual before attempting the repair. Please make sure to follow all the safety precautions. Auto Zone has some online repair manuals for free.

Dec 28, 2010 | 1998 Buick LeSabre

1 Answer

Auto parts place says I need the rear sway bar replaced - is this the same as the links and bushings? It's a bar in the middle of the car that leads to both wheels in the rear. If it does need to be...

yes, unless the bar is broken. Are the links broken? Just replace whatever is broken or worn out. Usually the bushings under the holddown clamps and the links and/or link bushings.

Sep 13, 2010 | 2000 Buick LeSabre

1 Answer

When replacing the front sway bar on a 99 Buick Lesabre with 3.8V, does the engine have to be lifted or does the front contrl arms have to be removed? Thanks Jim B

You should be able to fish it out after removing the mounts on each side and the linkages. If not, remove the two engine carriage bolts "18mm" on each side in the back to lower the engine a couple inches, and don't let the steering shaft slide out too far.

Apr 22, 2010 | 1999 Buick Regal

1 Answer

How to replace right front axle 2000 buick lesabre

Lift the passenger side of vehicle. Remove tire/wheel assembly. Remove the axle nut. Remove the tie rod end nut. Smack the side of the housing the tie rod end goes into to pop the tie rod end loose and out. Remove the sway bar link. Remove the lower ball joint nut. Smack the housing the lower ball joint goes into to pop the ball joint loose. Pry the lower control arm down to pop the ball joint out. swivel the rotor and strut assembly to the side. Pop the axle out. Reassemble in the reverse order.

Jul 05, 2009 | 2000 Buick LeSabre

1 Answer

2002 Buick LeSabre, Has noise in back when driving & swaying

stabalizer bar links are brobk its a commem problem with these cars

Apr 20, 2009 | 1997 Buick LeSabre

1 Answer

Left front sway bar has lost the lower bolt. Replace bolt & rubber or the whole thing?

You can buy a kit with everything you need from any auto parts store. If you mean replace the sway bar its self no you do not, unless its broke or bent.

Apr 15, 2009 | 2000 Ford Ranger SuperCab

3 Answers

How do i find a diagram showing my front end sway bar bushings?

The sway bar bushings are under the large clamps that hold the bar to the frame. The ends of the sway bar are connected to the struts by the sway bar links. When the links wear out, they clunk--not squeak. The bushings are under the retainer in the pic below.


Aug 06, 2017 | 2000 Dodge Dakota Quad Cab

1 Answer

2000 buick front a-arm mount

remove the road wheel ,unbolt the lower knukle joint first and then the anti sway bar bolt .and so on.look ,observe and think about it do not remove the dampers

Aug 15, 2008 | 2000 Buick Century

Not finding what you are looking for?
2000 Buick LeSabre Logo

Related Topics:

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides