At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Mercedes 2002 clk while driving esp light would come on and loose all power. Switch off the engine and restart it start and run and little while later it will do the same thing
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The ESP and BAS warning lights may illuminate due to a failed brake light switch. Replacement of the failed switch should correct this concern. A recall on certain 2000-2002 models have been recalled for a related issue
need to check for power to the top. also check signal from open/close switch to the roof control module located in the right rear corner of the engine compartment.
Sounds like the crankshaft position sensor needs to be replaced. They are a common problem with the Mercedes. That sensor is the one that the engine control module looks at to see if the engine is running. When they get hot and stop producing a signal the engine control module thinks the engine is not running and shuts of the fuel. After waiting awhile they cool down and the vehicle will start up again. I've changed many of them when I worked at the dealer. Tricky part is when there working and the car is running there will be no check engine light on or code stored. Usually will only have the code when the car won't start. Let me know what you end up finding out on it but that would be the first place to look and probably the cheapest.
The BAS stands for Brake Assist System, don't remember what ESP stands for. But the first thing to do is make sure the brake lights go on when you hit the pedal. If not, then replace the brake light switch above the pedal. If that is not it, it could be many things, such as a bad lateral acceleration switch.
start the car, if stop like after half an our to one our, and then after one our again start fine and can drive another 15 minute, again same thing happen and continue the same. is the problem same in your car, faulty crank angle sensor replace crank angle sensor,
you need a Brake safety switch replaced.This is located behind you brake pedal.it's a common problem. The warning lights will reset after a few engine starts.
most probable cause could be a faulty ignition switch. Does the lights on the dash come on when you turn the key to the on position ? Do they turn off when you turn the car to the start and are about to crank the engine ? If that does not happen you will have to replace the Ignition switch. They don't have a fuse for the dash lights.
Have a problem with my A/C. was leaking not holding proper charge. When that happens the Eoconomy light comes on and can't turn it off until system is prpoerly charged. Is their a reset on this system to turn that off once the proplem is corrected?
×