Question about 2002 Chevrolet S-10

1 Answer

2002 s-10 have to hold gas pedal all way down to start when it does start sounds like old modle a john deer let of gas moter dies

Posted by on

  • 1 more comment 
  • lazyhowe Jul 21, 2009

    it is a 4 cyl

  • lazyhowe Jul 21, 2009

    it is a 4 cylinder, checked the fuel presure it was 52 psi

  • Jeff May 11, 2010

    Is it the Inline 4 or a V-6 engine?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Sounds lie your pressure is ok, but I am curious about the Volume. When was the last time you changed your Fuel Filter? If it is a flex fuel vehicle, and you use a standard gauge on fuel pressure, it will read a bit high.
Second, How old is your battery? Mine did the same thing over the winter, and I found out that my 2000 S-10 only had one replacement battery 4 years ago. It didnt have the Cranking Amps it needed , resulting in hard starts, and low voltage to the Spark Plugs, which made it run rough.

Posted on Jul 21, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine runs for about 30 seconds and shutdown like an electrical shutdown as opposed to a fuel related shutdown.


Engine fired up, ran normally for 30 seconds, then shut down ...

www.thedieselstop.com > ... > 7.3L IDI Diesels (Not Power Strokes)
Sep 25, 2012 - Engine fired up, ran normally for 30 seconds, then shut down. ... it fired up and has been running since... if it just ran out of fuel jump it, and keep ...

Viewing a thread - cummins m11 starts then dies - AgTalk Home

talk.newagtalk.com/forums/thread-view.asp?tid=332921...flat...1

Sep 24, 2012 - 9 posts - ‎9 authors
98 KW with a cummins m11 will start and run for 5 seconds then dies. ... anything else like that, because it would run for 30 seconds and then die, not 5. ... The engineprotection system will not shut down the engine unless the ...

[PDF]John Deere Engine Safety Shutdown with "Black Box" (prior ...

www.tuckerbilt.com/.../John%20Deere%20Engine%20Safety%20Shutdo...
John Deere Engine Safety Shutdown with "Black Box" (prior to Tier II ECU ... Ifengine fails to start in 30 seconds, the Low Oil ... Test #1 (Engine not running).

1800 RPM for 30 sec before shut down [Archive] - Pilots of America ...

www.pilotsofamerica.com > ... > Pilot's Lounge > Technical Corner

Jan 01, 2016 | Cars & Trucks

1 Answer

Replaced the idal control valve moter and now wont start..


If its a gm car it has to relearn idle you may have to clear flood start by pushing gas pedal all the way down and hold till it starts then keep it running with pedal until it learns how to idle.

Mar 30, 2015 | Cars & Trucks

1 Answer

Bleed clutch hydraulic system John Deer 4300 Tractor - year 1998


two of you needed here ,put a big screwdriver into the operating arm and pull it back so the piston goes in ,slacken bleed nipple then helper pushes clutch down -hold it down then tighten nipple .repeat a few times and you will feel pressure on the clutch arm ,now get helper to push pedal down and hold it down ,pull bar to push piston in as it moves you open nipple then close it after a squirt of air comes out and repeat this a few times and it should have a hard pedal

Dec 06, 2014 | Cars & Trucks

1 Answer

John Deere high performance technology g4 crankshaft OHV twin 23 gross horsepower manufactured by Briggs and Stratton whenever I run over big weeds the mower dies once it dies it will not start for 20...


if the engine is a briggs and Stratton then check the valve clearance as B&S engines have a history of the valve stems stretching early in use and when hot hold the valve partially open until cooled down

Sep 16, 2014 | Cars & Trucks

3 Answers

MY truck is fuel injected what would make it so i have to hold down gas pedal to finally get it to start then die


Sounds like you have some injector problems or the fuel pressure regulator. If the check engine light is not on, I would look for something allowing extra fuel into the engine.

Jun 28, 2013 | 1992 Dodge Dakota

1 Answer

Car starts after taking foot off gas car shuts down 2001 mit 3.0 v-6 spider


For this problem, i suggest you to go through this help links.Click the link below to go through the troubleshooting procedure :----Car Idles rough and quits when gas pedal is pressed less? http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html-----------Car only starts when gas pedal is pressed? http://technoanswers.blogspot.com/2012/01/car-only-starts-when-gas-pedal-is.html
-----------Car won't start without hitting the gas pedal? http://schematicsdiagram.blogspot.com/2011/12/car-wont-start-without-hitting-gas.html
---------Car dies when gas pedal is pressed? http://schematicsdiagram.blogspot.com/2011/12/car-dies-when-gas-pedal-is-pressed.html
------------Pushing on the gas pedal, but the car slows down? Gas pedal to the floor and the car slows down? http://technoanswers.blogspot.in/2012/02/pushing-on-gas-pedal-but-car-slows-down.html
-----------This will help.Thanks.

Feb 15, 2012 | 2001 Mitsubishi Eclipse Spyder

1 Answer

04 Galant will start but not stay on. I have to hold down the gas. Mechanic said the accelerator was deprogrammed and I have to take it to a dealership. True?


its sounds like your IAC (idle air control) motor isn't working correctly. It controls the amount of air that enters the engine when the throttle body is closed. If it is not working, the engine will start but dies from insufficiant air flow. Your car doesn't die with the gas pedal pressed because pressing the pedal opens the throttle body allowing air to enter the engine.

Jul 14, 2011 | Mitsubishi Galant Cars & Trucks

1 Answer

1986 Toyota Extra cab truck won't start and have to hold down gas


on 1987 modles are equiped with a cold start inyector check harness or inyector malfunction

Jul 11, 2009 | 1987 Toyota Pickup

Not finding what you are looking for?
2002 Chevrolet S-10 Logo

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...