Question about 1994 Oldsmobile Cutlass Ciera

1 Answer

How do I put a headlight assembly and sidemarker on passenger side of my 1994 cutlass ciera car? I was in a wreck and need to put a new one on

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Oldsmobile Master
  • 2,984 Answers

Headlights REMOVAL & INSTALLATION Non-European Style

  1. Remove the headlamp trim panel attaching screws.
Fig. 1: Remove the headlamp trim panel attaching screws

Remove the headlamp bulb retaining screws. Do not touch the two headlamp aiming screws, (at the top and side of the retaining ring), or the headlamp aim will have to be readjusted.
Fig. 2: Remove the headlamp trim panel assembly from it's mounting location Using a screwdriver, remove the retaining ring screws.

Once the retaining ring screws are removed, the ring can be pulled away

Pull the bulb and ring forward then separate them. Unplug the electrical connector from the rear of the bulb.
Fig. 5: Pull the bulb out and unplug the electrical connector
  1. To install:
  2. Plug the new bulb into the electrical connector.
  3. Install the bulb into the retaining ring and install the ring and bulb.
  4. Install the trim panel.
If you would like the photos (I can't post them here...too large of files) email me at greg.bernett@mcchord.af.mil

Posted on Jul 21, 2009

  • Greg Bernett
    Greg Bernett Jul 21, 2009

    Side Marker Lights


    1. Remove the marker light housing screws and the housing.
    2. Disconnect the twist lock socket from the lens housing.
      NOTE: To remove the bulb, turn the twist lock socket (at the rear of the housing) counterclockwise 1⁄4 turn, then remove the socket with the bulb; replace the bulb if defective.
      To install:

    3. Connect the socket to the back of the lamp assembly.
    4. Position the lamp housing to the vehicle, then attach with the mounting screws.





    Fig. 6: The front and rear side marker lamps are removed using the same procedure



×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I fix headlight


You can't fix the headlight, you can only replace the assembly or change a bulb. First you must remove screws that hold side marker light and set aside. Then remove six screws that hold grill. Set aside. Now remove four 10mm bolts, two on each side of headlight assembly, and remove. Twist and remove bulb and reinstall in new assembly. Reinstall in reverse of disassembly.

Jul 11, 2014 | 1996 Oldsmobile Cutlass Ciera

1 Answer

1994 oldsmobile cutlass ciera headlights


You have bad wires some place and could cause lights to short out. I'd get it fixed before they go out on the highway at night. Safety Item

May 30, 2014 | 1994 Oldsmobile Cutlass Ciera

1 Answer

Where is the thermostat located on a 1994 Cutlass Ciera with a V6?


The thermostat is on passenger side right center of engine .Stand at passenger side with hood open look down and over at center and toward the right at the intake manifold...it is hard to see without removing engine components....Follow upper radiator hose from radiator to the intake where the other end of hose connects and that is where the thermostat is.....Be sure engine is not running and cool to the touch for safety reasons while looking........SAFETY FIRST
Hope this will help you......................................................Metalpoet

Feb 28, 2011 | 1994 Oldsmobile Cutlass Ciera

1 Answer

Where is the fuel pump rlay?


The fuel pump relay for the 1989 Oldsmobile Cutlass Ciera is under the hood on the passenger side in front on the frame wall by the headlights. There are 5 relays in a row the first two is your fuel pmp and fuel sensor.

Apr 17, 2010 | 1989 Oldsmobile Cutlass Ciera

1 Answer

Ignition lock 1994 cutlass ciera


You need a new ignition lock cylinder. One of the tumblers inside probably broke.

Aug 04, 2009 | 1994 Oldsmobile Cutlass Ciera

1 Answer

1994 old cutlass ciera 3100 blown head gasket.


Get a Chilton's book on the car. It will take you thru the whole job, and give you the torque specs for putting it back together. You will need a torque wrench, foot pounds, and a good socket set.

May 04, 2009 | 1994 Oldsmobile Cutlass Ciera

1 Answer

Trying to find where fuel pump fuse is located on 1994 cutlass


Passenger side of car next to radiator are 5 relays . Underneath metal support beam is a connection into module, unplugg connector ,15 amp fuse inside connector.

Mar 31, 2009 | 1994 Oldsmobile Cutlass Ciera

2 Answers

How do I change out headlight bulb on 91 olds cutlass cierra


Behind the headlight, you should see the nylon bulb holder. Turn it counter clockwise, about a 1/4 turn, and it should come out. Pull the old bulb straight out, and replace it with the new one. Don't touch the glass part of the new bulb with bare fingers, or you'll be replacing it again. Use cotton gloves or a paper towel. Put the holder back in the headlight, turn it clockwise until it locks.

Mar 09, 2009 | 1991 Oldsmobile Cutlass Ciera

1 Answer

94 olds cutlass ciera headlight lens


First you have to remove the corner turn signal and grill. Both should be held on with just some hex screws (3 in signal, about 6 in grill). Then you should see 4 black bolts. Unscrew those and the assembly comes right off. : )

Oct 27, 2008 | 1994 Oldsmobile Cutlass Ciera

Not finding what you are looking for?
1994 Oldsmobile Cutlass Ciera Logo

300 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...