C180 Auto car doors not responding to remote commands from key
The car is doors cannot respond to the remote key control and even after replacing the remote control key batteries, the car does not still respond. I cannot open the doors and each time I try to open it mannually the alarm goes off and i cannot drive it. What could be the problem, please help>
Re: C180 Auto car doors not responding to remote commands...
Tried to reset remote by putting the key in the ignition then turn to start, remove key and press down on the remote key open botton for 30 seconds facing the sensor. then tried to start, but wont start. light on the remote key flashes for a second when button is pushed down for 30 secs when trying to reset. Remote opens car but will not start it. got it to work other times by just reseting remote,but no such lock anymore. what can i do to get it working again?
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need. goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Run self test on heater control head. With the key press off and floor buttons at the same time for 2seconds then release and press auto button for a second.this will put system into self test.if no code all the blend door actuators are ok and I would think vacuum leak from main vacuum, black line going through fire
Firstly, open your glove box and make sure Valet Mode is not enabled, if it is not, follow these steps.
Step 1: Open drivers door and leave open. Step 2: Lock and unlock the driver’s door using the power door lock switch on the door. Step 3: Insert key into the ignition. Step
4: Turn key to on position and return to off position. (IMPORTANT - use
ON position NOT ACC position). Do this 3 times within 10 seconds. Leave
key in the ignition. Step 5: Open and close the driver’s door 3 times. (Door should be left open after this step). Step 6: ECU should respond by locking and unlocking the doors. Step 7: Press any button on remote #1 twice. ECU responds by locking and unlocking the car doors. Step 8: Press any button on remote #2 (etc.) twice. Each time the ECU will respond by locking & unlocking the doors. Step
9: Remove the key from the ignition and the ECU will respond a final
time with a series of door locks and unlocks. You're done!
Open passenger door manually with key, then pop bonnet and remove plastic cover on passenger side at bulkhead. You will then see a connector from battery which can be mated to a slave battery in order to work remote to open boot.
i have Nissan Primera s manual,03 reg. Battery went dead two days ago, today i tried to open the car with my remote key, it didn't respond as battery was totally dead. I tried to open the door manually with the key,it wont open. Can any one help me please.....?