Question about 1997 Pontiac Grand Prix

1 Answer

How to remove and replace blower motor?

Blower motor 1& 2 speeds not working and motor is making a noise

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,071 Answers

Remove trim under dash on passenger side 3 - 5 bolts hold motor in can be done in 10 min

Posted on Jul 21, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 kia spectra blower only blows 1 & 4 speeds


Could be the blower motor resister,it's located by blower motor,2 screws hold it on,easy to remove,click here to see part.

Dec 30, 2012 | 2005 Kia Spectra

1 Answer

Where is located the fan speed control stratus 01


Could be your blower motor resister,it's located by blower motor,easy to remove.Click here to see blower motor resistor.

Dec 26, 2012 | 2001 Dodge Stratus

1 Answer

2002 Honda Accord heater blower ok in positions 1 and 2, starts making noise in position 3, and is really loud in position 4. Does this imply need for replacement, or just some sort of tightening?


Remove blower motor most cars there under the left side of the dash. normally 3 screws & a wireing plug. Remove motor & clean debris (posibly leaves, toilet paper, lollies etc... you would be suprised with what i have found in them

Oct 09, 2012 | Cars & Trucks

2 Answers

Blower motor speed not working


This is usually due to 1 of 3 possible problems.

  1. Bad blower motor resistor - attaches to blower motor and regulates fan speeds. Not uncommon to lose 1 speed at a time until you get stuck with only 1 speed
  2. Bad blower motor
  3. Bad heater control module - less likely but still possible the module is bad and the whole unit requires replacing

Oct 16, 2011 | 2000 Kia Sportage

2 Answers

My blower motor only works on 1 & 2 & 3 speeds dont work on 4 & 5. I was told to buy a blower motor. Need to know where this is located to replace on my 2005 Chevrolet Trailblazer


If your blower works at some speeds and not others, the likelihood of the blower motor needing to be replaced is low. The more common problems would be either the switch or the resister that regulates the motor speed. The resistor is usually located in the air duct under the dash.

Jun 17, 2011 | 2005 Chevrolet TrailBlazer

3 Answers

THE BLOWER MOTOR IS MAKING NOISES AND SMELLS


your bearing failed and is causeing friction replace motor

Jun 05, 2009 | 2001 Honda Accord

2 Answers

Blower motor or resistor?


I had a truck about the same year with the same problem, it was the wiring harness, but id check the resistor and the fan first before replacing anythings,

May 20, 2009 | 2002 Chevrolet Silverado 1500

2 Answers

The blower motor makes horrendous noises on the higher speeds. On speed 1, I don't hear any noises. There's a little rumble on 2, and the 3 and 4 shake the whole car. This is happening when the heater is...


Sounds like the bearings that are on the shaft which the fan turns on are in severe need of lubrication. You can remove the fan unit and shoot some WD40 onto the shaft and bearings.

Apr 09, 2009 | 2006 Pontiac Solstice

1 Answer

Blower motor or resistor?


If it was the motor that went out then it would not blow at all. The resistor is the culprit that starts killing off speeds. It should be about $25 to $30 at an aftermarket store like autozone or advanced auto parts.

Jan 09, 2009 | 2000 Chevrolet Malibu

Not finding what you are looking for?
1997 Pontiac Grand Prix Logo

Related Topics:

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...