Question about Mazda 626

1 Answer

I need to connect airflow meter, distributor and other loose plugs but dont have colour codes. I need a wiring manual or diagram with clear colour coding.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 404 Answers

As much as I remember from my Mazda most of the plugs don't have to many colours and they are different size and have different pins and sockets, try to match few of them and you will see it is not a big deal

Posted on Jul 21, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 95 Landcruiser with 1FZ-FE engine runs but misses very badly, will not idle.

Sounds like a vacuum leak.

Search for it VERY CAREFULLY by spraying a shot of carb cleaner here and there. When it revs up or smooths out, you'll have located the leak.

Keep a fire extinguisher handy when doing this, and don't spray into electrical parts like the alternator or distributor!

Mar 08, 2015 | Toyota LandCruiser Cars & Trucks

1 Answer

Why dont it start ?

It means low air flow entering the inlet manifold, blocked air filter?, loose wiring connection to mass airflow meter?, blown fuse?, all could be causes or the mass airflow meter itself could be faulty. Good luck hope it helps.

Aug 05, 2014 | 1996 Oldsmobile Cutlass Ciera

1 Answer


Hi there, C if u can go 2 a wreckers & get that lead & replace it by slicing it into the wiring loom or U might get lucky 2 replace that whole piece from end 2 end!!!! This should work 4 U!!!! Good luck!!!!!!

Nov 23, 2013 | 1997 Suzuki Vitara

1 Answer

I have a 92 oldsmobile cutlass ciera and i need to change the plug wires and spark plug only problem is wires have been cut so how do i do it. dont know where they go

Go to literary and look for auto repair Manuals. You should find a diagram for wires to the distributor and plugs.

Oct 28, 2013 | Cars & Trucks

1 Answer

1996 isuzu npr medium duty truck gas engine , only starts up when i spray starter fluid but shuts down immediately after starts up, it dont stay idle even if i press gas while starting, i change...

maf can cause the problems you describe, but a maf code can also be caused by a backfire, check to make sure you have sufficient fuel and fuel pressure to the engine before you start replacing parts if not repair the problem clear the codes and ttry again

Sep 01, 2013 | 1995 Isuzu Trooper

1 Answer

Have a 94 toyota camry , check engine light comes on when stop at light or car sits at idle. got codes 12 , 22, am very confused !!

Code 12. RPM signal.
Problem area: Loose connection, broken rpm signal wire from distributor to ecm to rpm meter, rpm meter, distributor assembly or ecm defective.
Code 22. Water temperature signal.
Problem area: Loose connection at water temperature sensor connector, broken wire between the sensor and the ecm, defective sensor or ecm.

Aug 25, 2013 | 1994 Toyota Camry

1 Answer

Dont know what the problem is

Check fuel pressure and check for spark and check that the airflow meter is operating, check for timing as well. Check for any wiring problems(loose connections, corrosion, condensation in distributor cap. Check distributor cap+rotor plug wire from coil to distributor. Check for any worn or damaged wiring or bad ground wire contacts. Air, Fuel, Spark and Timing are the key elements for an engine to run.

Apr 18, 2009 | 2004 Chevrolet Astro

1 Answer

Q45 airflow meter wiring.

That's not going to work. You can't install a air flow meter into a Pulsar from a Q45. Totally different animals. Air flow meters are car specific. I don't think its gonna work, but good luck with that.

Sep 28, 2008 | 1998 Nissan Maxima

2 Answers

Wiring diagram

why would you need a distributor on a diesel engine???
when you removed the engine, you probably left the distributor wire touching the body.

Jun 20, 2008 | 1988 Suzuki Samurai

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8572 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides