Question about Cars & Trucks

Open Question

Put a new blower on 2-71 ,run it about an hour , everything seemed right. shut off, next morning would not turn over, thanks, kenny

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 6982 Answers

SOURCE: 1988 cherokee 4.0 I6 wouldn't start. turns over

The biggest roadblock to working on your car is that there is no user friendly computer testing (unless one of the parts stores that do computer scans (free) has the correct scanner for this)You can get a manual with individual volt/ohmeter tests for components. Most common items are ignition control module and crank sensor which are heat sensitive. some, like the coil, make their own heat, not related to engine temp. Crank sensor can shut down spark as can the hall effect setup inside the distributor under the bottom plate. Check everything carefully for loose or corroded connections. Wish I could give you more, but the disadvantage to doing this is I can't see what you are working with, and knowledge without input for verification makes this really difficult, especially with electrical problems where it's not a how to attach or remove an item question! Good luck..

Posted on Jun 09, 2009

Ad
  • 90 Answers

SOURCE: heater blower will not shut off after ignition is

could be a faulty relay , pull relays out one by one and see if stops running

Posted on Mar 08, 2010

  • 40 Answers

SOURCE: 2002 sub. battery goes dead

Your battery is no good and you need to buy a new one. Alex.

Posted on May 19, 2011

GARYca
  • 672 Answers

SOURCE: 1996 T100 4wd 3400 four

Have the charging system checked!! Alternator may may have failed!!

Posted on May 23, 2011

jturcotte
  • 8274 Answers

SOURCE: I drove about 200 miles,shut

cannot seem to get the wiring diagram to post on the other thread, so trying here. Check continuity of crankshaft sensor wires.

jturcotte_2041.gif

Posted on Aug 07, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When I turn the engine off the blower motor keeps running and will not shut off


Most likely the resistor has shorted to hot. It is close to the blower.

Nov 28, 2015 | 2004 GMC Envoy

6 Answers

Have a 2000 dodge durango w/new batter, blower all lights work but battery wont take charge??????????????????????


If you have changed the battery, have it load tested to make sure it is not defective.
A tech can also check the voltage output and regulator. I am assuming you have already had these two check done as well as ECM error codes. The PCM, powertrain control module would be my next component to have checked. A dealership should have the software to check this. I believe that the OEM part runs around $8 to $900.00 dollars. You may be able to get an aftermarket replacement for around $200, but once installed electrical components are not returnable. Do not get stranded somewhere, have a dealship check this problem out!

Mar 18, 2015 | 2000 Dodge Durango

1 Answer

Put in a new battery, it was dead the next morning, whats using the power


I was having the same issue with my car not sure if yours is the same issue but check out the alternator amp fuse

Feb 22, 2013 | 1990 Ford F250

1 Answer

2004 900 efi mountain cat no start, seems like no spark


try unplugging the throttle switch to see if its ok. then of course replace...thats a quick sled

Sep 01, 2017 | Arctic Cars & Trucks

1 Answer

1998 gmc jimmy fuel pump


did you change connector at fuel pump?

Dec 12, 2012 | 1998 GMC Jimmy

1 Answer

Fan on high setting all the time, and won't quit


You need to replace the blower resistor/relay.

Mar 02, 2009 | 2000 Pontiac Grand Prix

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...