Question about Dodge Avenger

Open Question

2009 Dodge Avenger 2.4 Spark Plug Location

Everyone knows that spark plugs must be gapped properly. However, for some spark plugs the gap is set at the factory and should not be changed. When I purchased the plugs for my 2.4 Dodge Avenger, I got plugs that fall into this category and should not be regapped.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 61 Answers

SOURCE: SPARK PLUG INSTALLATION ON 2006 DODGE CHARGER 2.7L

In my experience with the 2.7L engine, the spark plugs are located on the top of the engine below the individual ignition coils. The coils are placed between the intake manifold and the valve covers, 3 per side. The coils are held in with "torx" screws. Simply remove the screws, and disconnect the connectors to remove the coils. The spark plugs will be underneath. Be sure to properly gap the spark plugs for maximum life and emissions compliance. Also, an improperly gapped plug can shorten the life of the coil packs.
Hope this helps!

Posted on Jul 25, 2009

Ad
  • 5 Answers

SOURCE: location for turn signal relay

It depends on the model of avenger you have, coupe or convertible. It can either be in the steering column with the multifuntcion switch(basically the turn signal lever and wiper control asembly) or it is in the center console behind the radio.

Posted on Sep 08, 2008

  • 1 Answer

SOURCE: 2008 dodge avenger spark plug location and socket size.

  • 2008+ Dodge Avenger 2.4L 4cyl.
  • Remove plastic cover on top of engine, just pull on each corner for it is friction fit.
  • Once removed you will see 4 black spark plug covers with one hex type screw holding each.
  • Remove Hex screw and place aside, pull upward to remove plug boot from plug.
  • To remove the plug, use a 5/8 socket with a 6" extension. Once plug has been turned out all the way and you cannot get the plug up and out of the hole, just press the plug boot back on the plug and pull it back up.
  • Gap and replace 4 plugs with the same or equavalent type,. Drop plug down the hole and use socket to align and tighten until just snug, then torque to manufactures specifications.

Posted on Feb 23, 2010

  • 8 Answers

SOURCE: What is the spark plug gap for a 2008 dodge

There should be a data plate on the radiator support or a decal on the under side of the hood that has the reccomened plug gap.

Posted on May 27, 2011

ZJLimited
  • 17970 Answers

SOURCE: Location Of input an output Speed Sensor on 1996 dodge avenger

According with repair manual, output speed sensor is located on the Transmission, generally positioned over the park gear and monitors transmission output shaft rotating speed; check some details in the next image...

zjlimited_819.gif

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

Posted on Oct 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the spark plug gap for a 2009 Kia Spectra


044 (In thousandths of an inch)Caution! Gap is not adjustable on certain plug brands
.044(in thousandths of an inch) caution !!! gap is not adjustable on all plug brands

Mar 01, 2015 | 2009 Kia Spectra

1 Answer

Spark plug gap 2008 avenger 6 cylinder


check your owners manual it there as well look under the hood its on a decal on the rad support or the underside of the hood

Aug 09, 2014 | 2008 Dodge Avenger

1 Answer

Spark plug gap on a 2009 307 jeep


Spark plug gap should be on the emission control sticker under the hood

Jul 09, 2014 | 2009 Jeep Grand Cherokee

1 Answer

What is the spark plug gap for a 2008 dodge avenger with a 4 cylinder?


There should be a data plate on the radiator support or a decal on the under side of the hood that has the reccomened plug gap.

May 27, 2011 | 2008 Dodge Avenger

1 Answer

Need do know the spark plugs gap


If you're replacing the spark plugs in your car engine, you'll need to set the gap before reseating the spark plug. The gap is the distance electricity arcs between the ground electrode and center electrode. The gap must be set correctly to ensure maximum performance. Here's how to set the gap of a spark plug.

  1. Remove the spark plug wires. Use a socket wrench to remove the spark plugs from their chambers.
  2. Clean the spark plug if you are not replacing it with a new one. Remove all dirt and debris from the spark plug.
  3. Check the owner's manual for your car (or any appliance with spark plugs) to find out the recommended gap setting.
  4. Use a gap tool to check the gap of the spark plug. Slip the tool between the ground electrode and center electrode. The gap tool should fit snugly at the recommended gap width indicated on the tool.
  5. Push the tool between the electrodes a few times to ensure proper gap. If the gap is too wide, push the ground electrode firmly against a flat surface to narrow the gap and then check again with the gap tool.
  6. Repeat Step 5 as necessary until you reach the correct gap. Reseat the spark plug and reattach the spark plug wires
Good Luck

Dec 10, 2010 | 1997 Pontiac Grand Am

2 Answers

Spark plug gap 1987 dodge Dakota 3.9L-2


  • Engine:3.9L V6
  • Spark Plug:RC12YC
  • Gap .035" (0.9 MM)
  • Sep 01, 2010 | 1987 Dodge Dakota

    1 Answer

    Just replaced spark plugs and filled all fluids...started her up twice..came out this morning..won't start at all..turns over but doesn't catch..replaced fuel pump, same thing


    DID YOU SET SPARK PLUG GAP AT.0.033- 0.038 -THIS IS THE 2.0 ENGINE. IF YOU HAVE A 2.5 ENGINE YOUR SPARK PLUG GAP IS 0.039 -0.043.IF ALL IS GOOD REPLACE DISTRIBUTOR CAP + WIRES AND ROTOR.SEE WHEN YOU REPLACE PLUGS ALSO GOOD TO REPLACE CAP AND ROTOR ALSO.

    Aug 16, 2009 | 1997 Dodge Avenger

    1 Answer

    SPARK PLUG INSTALLATION ON 2006 DODGE CHARGER 2.7L


    In my experience with the 2.7L engine, the spark plugs are located on the top of the engine below the individual ignition coils. The coils are placed between the intake manifold and the valve covers, 3 per side. The coils are held in with "torx" screws. Simply remove the screws, and disconnect the connectors to remove the coils. The spark plugs will be underneath. Be sure to properly gap the spark plugs for maximum life and emissions compliance. Also, an improperly gapped plug can shorten the life of the coil packs.
    Hope this helps!

    Jul 25, 2009 | 2006 Dodge Charger

    1 Answer

    Spark plug setting


    I have never seen a car come back because the gap was wrong on the plugs. Contact plug manufacturer.

    Jun 13, 2009 | 2001 Dodge Neon

    4 Answers

    2008 dodge avenger spark plug location and socket size.


    • 2008+ Dodge Avenger 2.4L 4cyl.
    • Remove plastic cover on top of engine, just pull on each corner for it is friction fit.
    • Once removed you will see 4 black spark plug covers with one hex type screw holding each.
    • Remove Hex screw and place aside, pull upward to remove plug boot from plug.
    • To remove the plug, use a 5/8 socket with a 6" extension. Once plug has been turned out all the way and you cannot get the plug up and out of the hole, just press the plug boot back on the plug and pull it back up.
    • Gap and replace 4 plugs with the same or equavalent type,. Drop plug down the hole and use socket to align and tighten until just snug, then torque to manufactures specifications.

    Feb 14, 2009 | 2008 Dodge Avenger

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    18 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Dodge Experts

    yadayada
    yadayada

    Level 3 Expert

    76051 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8265 Answers

    Are you a Dodge Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...