Question about Hyundai i20

Open Question

While I'm driving to work I keep getting a beeping noise going of for a couple of seconds now all my seatbelts are locked in also all my doors are closed. It's an hyundai i20 plz help

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

SOURCE: Interior Lights and Door Ajar light stay w/beeping noise.

Try spraying WD-40 into the door latching mechanism (door side). I learned this fix after two battery replacements, but have only had to spray twice in the more than seven years of ownership

Posted on Jan 29, 2009

Ad
chrisK1997
  • 103 Answers

SOURCE: "Door Ajar" signal on dash panel stays on even when doors are clo

there should be a switch mounted( or more than one) in the door jamb that tells the car when the car door is open...i will probably look like a little plastic plunger...might be broken off or bad internally

Posted on Feb 22, 2009

chrischronic
  • 235 Answers

SOURCE: door ajar light stays on

go to your local parts store and buy a can of PB BLASTER lubricant then open each door and spray the latch assembley really good then close and open the door 10 to 15 times. do this with each door. the door ajar light switch is located in the door latch assembley and cannot be seen so soak the latch assembleys really good so lube reaches the switch. these switches sometimes get stuck but this usually frees up the switch

Posted on Mar 25, 2009

  • 1 Answer

SOURCE: BEEPING NOISE

in the back of the fridge there is a panel. Remove the cover plate. Look for the buzzer and remove it. This will cancel the annoying beeping noise.

Posted on May 05, 2009

  • 1 Answer

SOURCE: door ajar light will not go off and all doors are closed

I had this problem. I had to have a sensor in the door replaced.

Posted on May 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When i drive my car there is a constant beeping noise but it stops beeping when i come to a complete stop. please help!! Peugeot 206cc 2003


It sounds like it could be a seat belt sensor. These only work when the car is moving. Do you have anything on the passenger seat that could make the car think there is a passenger there?
Try fastening all the seatbelts and see if the beeping continues. If there is no beeping, try unfastening the seatbelts one by one & see if you can find which one is causing the problem.
if it turns out it is a seatbelt sensor, you could drive with that belt fastened until you can get the sensor replaced.

Nov 12, 2017 | Peugeot Cars & Trucks

1 Answer

How do I eliminate the beeping noise that occurs even when I'm driving?


Is there a door ajar light on? How about a seatbelt light on? These will cause the chime to sound. Possible door switch causing issue. You can unplug the chime module from under the dash. Listen for the noise to locate it and unplug it.

Oct 12, 2015 | 2003 Pontiac Aztek

1 Answer

My Jetta beeps while i drive.


I HAVE THE EXACT SAME PROBLEM! DID YOU FIX IT?

Oct 17, 2012 | 2000 Volkswagen Jetta TDI

1 Answer

Keyless entry locks the car, but then it unlocks again a couple seconds later??


That happened to me. I disconnected the battery and let it sit for a while and then reconnected it. That seemed to reset things and it worked fine after that.

Dec 17, 2017 | 2001 Hyundai Accent

1 Answer

My 1998 Dodge Caravan will periodically beep four times in succession while driving. Does anyone what this indicates? Thanks


usually indicates a door is open or seatbelt is undone. if no door ajar light or seatbelt light comes on when you hear the beeps then most likely the BodyControl Module has a bad circuit for that function.

Jul 20, 2011 | 1998 Dodge Grand Caravan

1 Answer

Beeping noise from dash


The problem went away on its own! I took it for a 10 km drive and there was no beeping sound.

Dec 10, 2009 | 2001 Volkswagen Jetta TDI

2 Answers

After driving several miles my 2004 pacifica starts to beep - 3 beeps every 30 seconds and doesn't stop. No lights are on - engine or otherwise. Once I've stopped and the engine has been turned off for...


if you drive slowly does it not start? ensure you do not having anything resting on your passenger seat. if there is a weight sensor in the seat for the seatbelt warning the car assumes sombody is in the passenger seat. or the sensor is defective to isolate this plug the passenger seatbelt into its lock and see if the problem goes away. (when driving slowly this may not start. the alarm may be set to go of after a certain speed)

note: keep all clutter away from the driver position after cornering or breaking, debris may fall into the foot well and interfere with the pedal movement. or fall onto the driver.

Nov 13, 2009 | 2004 Chrysler Pacifica

4 Answers

Beeping noise from a 2000 Ford Expedition


Replace your air bag light. It's prob. burned out.

Apr 22, 2009 | 2000 Ford Expedition

1 Answer

Door will not slide automatically; emits loud beeping noise


Something similar to that was happening with our Odyssey...the beeping when you are driving whether it's ongoing or intermittent is the "safety alarm" letting you know the door is not closed. The power lock is not engaging. What I do when I get the beeping while driving is hit the Door Close button. It causes the door to attempt to engage again. To fix it...we first cleaned out the space below the side running board (kids were hiding crayons and things in there), then looked for any obstructions along the top and bottom tracks. I sprayed a lubricant along the tracks (I'd suggest the dry lube kind...I used WD40 the 1st time and had streaks of it dripping down after driving), use a lube that has a long straw to spray in small places...and spray up into the track that runs the length of the middle of the car. Manually open and shut it a few times to get the tracks lubed, then try it out.
If you press the open OR close button by remote or in the car and get nothing...no movement/no noises/no beeping...then it could be the electrical circuit itself, the signal itself may be impeded...or the motor shot. Have you tried any of these suggestions before?

Mar 16, 2009 | 2000 Honda Odyssey

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...