Question about Hyundai Motor 2005 XG350

1 Answer

In my 2005 hyundai xg350l there's a fuse box around kick panel..the "Start fuse " has no power but fuse is good. Fuel pump is new engine crank but wont start..help please..thank you

Posted by on

  • Fernando Soto
    Fernando Soto Jan 07, 2017

    Thank you Frank..."Start " fuse will light up test light only while cranking engine. .thanks again

  • Fernando Soto
    Fernando Soto Jan 07, 2017

    Also ,no power in harness that connects to the throttle motor...is there a relay for this motor, if there is where is it located, do you know ?..thank you so much

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Hyundai Master
  • 1,062 Answers

You should have pwr w the key on at all times at that fuse. Bad relay or short in ignit system.

Posted on Jan 06, 2017

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: MY 01 Nissan Altima does not want to start.

Sounds like either the fuel pressure regulator or a clogged fuel filter.

Posted on Oct 14, 2008

  • 2 Answers

SOURCE: my 1996 hyundai accent wont crank at all with a good battery

first make sure your battery is good.....one possibility may be your starter.. try hit the starter with a hammer or something similar a few times then try starting it... if that works then u need to replace your starter

Posted on Jan 23, 2009

  • 1 Answer

SOURCE: my 197 range rover wont start -replaced fuse box

hi i have a range rover p38 2.5 diesel it starts but wont drive when you put in drive

Posted on Aug 31, 2009

  • 147 Answers

SOURCE: I have 2005 Nissan altima that wont start. It

Nissans are known to have problems with ignition coils which would not show up on code reader. I would start with that. Pull a plug and hold it to ground to see how strong the spark is while turning engine over. If the plugs are wet when you take them out then you can be sure it is in all probability related to coils.

Posted on Nov 24, 2010

fb96
  • 1 Answer

SOURCE: 2000 Chevy express van no fuel to engine - pump is good

Have you checked the fuel filter? Have you changed it EVER?

Posted on Mar 27, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2011 Hyundai Sonata my fuel pump ain't kicking on does it have a reset button


No it doesn't . Has fuel pump relay controlled by the PCM - powertrain control module . The PCM needs to have inputs from crankshaft position sensor before it will energize the relay . Does the vehicle have spark at the sark plugs or coil's ? If there is spark the crank sensor is good . Would need to do fuel pump electrical circuit testing , like this
Testing Electric Fuel Pump Problems with Voltage Drop Test Look at the fuse / relay box under the hood in engine bay . Find fuel pump relay . Do you know about relays an how they work ? Videos on youtube .

Mar 26, 2017 | Hyundai Cars & Trucks

1 Answer

Where is the ECM fuse and Fuel pump relay on a 2000 Hyundai Tiberon?


images for Where is the ECM fuse and Fuel pump ..

ECU fuse keeps blowing - New Tiburon Forum : Hyundai Tiburon ...

www.newtiburon.com/.../tiburon.../217243-ecu-fuse-keeps-blowing.html

Sep 8, 2012 - 18 posts - ‎8 authors
Edit: Instead, pull the fuel pump relay, and see if the fuse still blows when ... ControlRelay, Fuel Pump relay, A/T control relay, Generator, ECM ... Official "Check Engine Light" Thread - New Tiburon Forum ...
Jul 22, 2014
Fuel pump Relay
Apr 26, 2013
Starting problem. Fuel pump doesn't prime with key on.
Mar 9, 2013
Fuel pump not starting intermittently
Oct 6, 2010
More results from www.newtiburon.com

Car Cranks But Will Not Start - Hyundai Forums : Hyundai Forum

www.hyundai-forums.com/...2000.../85246-car-cranks-but-will-not-start...

Jan 17, 2008 - 10 posts - ‎6 authors

Jan 06, 2016 | Hyundai Cars & Trucks

1 Answer

No power to fuel pump?


check the fuel pump inertia switch behind the passenger side kick panel. Also make sure connections are tight and not corroded. Then you might consider a new ignition switch from autozone for $25.

Mar 18, 2014 | 2001 Oldsmobile Aurora

1 Answer

No fuel to engine


check to see if it has fuel cutoff reset behind the kick panels . Many Fords do

Mar 16, 2017 | Cars & Trucks

1 Answer

My f150 cranks and wont start, plugged in a computer and nothing shows up, screen is blank


Crank no start could be
1. Fuel inertia switch ( passenger side kick panel )
2. Fuel pump relay or fuse ( fuse replaceable relay is built into the fuse panel )

3. Most common for crank no start is the FPDM ( Fuel Pump Driver Module ) on the cross member by the spare tire.
Lower the spare, and check to see if the module is cracked.
This is what mine looked like on my 2006, the housing was cracked, but the PCB was still good ( I did not have a problem yet )
e3d0c60.jpg
The cable on the right side of the picture is the spare tire lift, and the picture is taken facing the front of the truck.

Sep 03, 2010 | 2005 Ford F-150

2 Answers

No power to the fuel pump


Once you check the fuel inertia switch in the passenger's side kick panel, next is to check the fuel pump fuse, engine compartment fuse # 10.

If this checks OK ( power on both sides ), you can pull the fuel pump relay, and jumper it.

The engine compartment fuse panel is where the fuel pump relay is located at ( relay # 301 ). Pull the fuse pump relay out of the socket, and using the diagram below, with the red line, momentarily jumper the Normally open contacts, you shoud hear the fuel pump run. ( mind the pin orientation when doing this ) :
86000f6.jpg

I had a bad fuel pump relay on my 2001 F-150 @ ~ 36K miles. Replaced with the trailer tow battery charge relay ( relay #302 next to it ) and it worked again.
The symptom I had was a crank no start ( theft light on dash went out ).

If the fuel pump does not run, and power is on pin #30 in the relay socket, next is to check the output of the fuel inertia switch in the passenger side kick panel. The output of this is the Pink w/ Black stripe wire. The connector to the fuel pump inertia switch should be a 2 pin connector, the other color in the connector is Dark green w/ Yellow stripe wire ( that is from the pin #87 in the relay socket in the engine compartment ).

If that circuit has power at the passenger side kick panel, next is to check for power at the fuel pump at the fuel tank. The fuel pump motor is the same Pink w/ Black stripe wire. The connector is a 4 pin connector with black ( ground for the fuel pump ) black w/ orange stripe ( ground for the fuel level ) and yellow w/ white stripe ( to the instrument cluster for the fuel gauge ).
When testing by the fuel tank, make sure you have a good ground for the meter ( extension from neg on the battery or trailer tow adapter ) as that could also be a problem under the truck.

Sorry for war and peace, hope it helps.

Nov 17, 2009 | 2001 Ford F150 Styleside SuperCrew

1 Answer

Fuse box layout


First of all, Hyundai did not produce the XG350 until 2002. You wrote 2001 Hyundai XG350L. The engine in the 2001 is 3.0 (XG300). Cant help you.

May 09, 2009 | Hyundai XG350 Cars & Trucks

2 Answers

Location of fuel pump relay (1990 hyundai sonata)


The fuse box is located low on the left side of the dashboard behind a cover, or at the left side kick panel, behind a cover.

Relay Box -is located under the left side of the dash as well.


3a53806.jpg

May 07, 2009 | 1999 Hyundai Sonata

1 Answer

2005 Hyundai XG350L Fuel Filter


Hi there, 
If you can get under the car just head to the petrol tank and look for the lines running to and from the tank,
There should be several thin copper looking metal tubes running from the tank to the engine bay,
Generally somehwere along that line should be the fuel canister that should look almost the same as your new one, 
Its then a simple process of unscrewing the old one and screwing in the new one, Be aware not to use any sort of flame light ie lighter when under there as fuel will run out when you remove the old one. If its not under ther then it will be mounted in the engine bayas before just follow those tubes.
You may need to turn the igition on and off a few times once installed to prime the lines if the car does not automatically do this.
If it still wont start try pumping the gas/accelerator once or twice,
Be carefull not to flood the car and you should be away.
Hope this helps
Cheers
Steve

Apr 03, 2009 | Hyundai Motor 2005 XG350

Not finding what you are looking for?
Hyundai Motor 2005 XG350 Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...