Question about 2011 Ford Transit Connect

Open Question

Where are the temperature sensors located on my 2011 ford transit connect xl?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 31 Answers

SOURCE: engine temperature sensor located on a 1998 Ford Mustang GT

Left hand side (if facing it), behind distributor, above oil fill.

Posted on Apr 22, 2009

  • 169 Answers

SOURCE: sensor locations

air intake look at snorkel it could be part of mass air flow check intake for eng coolant

Posted on Aug 29, 2009

archaeology
  • 662 Answers

SOURCE: location of engine coolant temperature sensor

Automobiles: 2000 Ford Escort ZX2 4-cylinder 2.0L MFI DOHC

NOTE
The "left" side of the engine is the driver's side.

The Engine Coolant Temperature (ECT) sensor is a thermistor (a device which changes resistance or voltage as temperature changes). The sensor detects the temperature of engine coolant and provides a corresponding signal to the PCM (Powertrain Control Module - aka "the car's computer").

The ECT sensor is mounted in the following locations (small Ford engines):

1.8L engines: in the cylinder head
1.9L engines: threaded into the heater hose inlet pipe
2.0L engines: at the left rear of the engine

2.0L Zetec Engine

(1) Partially drain the engine cooling system using a clean container. If coolant is in good condition, retain for reuse.
(2) Disconnect the battery ground cable.
(3) Disconnect the electrical wiring connector from the engine coolant temperature (ECT) sensor.
(4) Remove the retaining clip and the ECT sensor.


12_5_2011_5_38_05_pm.jpg

Fig. 1 Escort ZX2 ECT sensor - The retaining clip is removed (at the solid arrow). Withdraw ECT sensor by gently wiggling/pulling in the direction of the dashed arrow.

To install:

NOTE
Coat the ECT sensor O-ring with clean coolant prior to installation.

(1) Replace the retaining clip and the ECT sensor.
(2) Connect the electrical wiring connector from the Engine Coolant Temperature (ECT) sensor.
(3) Connect the battery ground cable.
(4) Refill the engine cooling system. An inexpensive plastic "Radiator Funnel" will help with this task.

Posted on Dec 05, 2011

alicantecoli
  • 22095 Answers

SOURCE: where is the battery on a 2011 ford transit

Has to be under the bonnet somewhere like with a big plastic cover on it what about under the drivers seat as thats another favourite place as ford do not like paying for parts so its sure to have the shortest run of cable possible from the battery to the starter motor ,under the floor pan even ?? cant beat a 1966 transit with the 2lt V4 engine ,a decent tune up and it could outrun any old panda car except the V8 rover lowline of course

Posted on Mar 10, 2012

  • 4 Answers

SOURCE: 2011 ford fiesta air bag sensor location

Which sensor are you looking for? Or are you looking for the control module where all the sensors connect to? The airbag control module (known as the Restraints Control Module (RCM)) is located under your center console (see picture below).

2011-ford-fiesta-air-bag-sensor-location-s3zwbyrgjkpkbjrh2ou4v3xw-2-0.jpg

If the vehicle has been in an accident, you will need to have this module recoded/reset. Ford can do it, or you can mail it off to several sites that will recode it for you (I had it done recently for $45).

Hope this helps!

Posted on Oct 29, 2014

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2011 ford transit connect xl. I have replaced the cooling fans and thermostat and relays and fuses. But cooling fans still aren't coming on.


Hopefully they are not controlled,or given the signal, by the PCM (or ECM)? Some cars must get their signal from the computer......it's an inane,over-engineered system,I know. don-ohio (:^)

Jan 03, 2017 | 2011 Ford Transit Connect

1 Answer

2011 ford transit Code PO116 & P1299


P0116: Engine Coolant Temperature Sensor 1 Circuit Range/Performance
http://www.autocodes.com/p0116_ford.html

P1229: Supercharger Intercooler Pump Not Operating Condition
http://www.autocodes.com/p1229_ford.html

Oct 14, 2016 | 2011 Ford Transit Connect

1 Answer

2011 ford transit clearance warning system not working what fuse number and location is the fuse?


The drivers manual will show the location of the fuse box and the location and rating of the fuse.

Mar 03, 2016 | Ford Cars & Trucks

1 Answer

My windshield wipers wont shut off on my 2011 Ford Transit Connect


Usually the problem is inside the wiper motor. If you can see any contact points or can spray a little WD40 on what you see, it may help. Sometimes backing off the mounting screws and retightening them will allow the grounds to be reestablished.

Feb 26, 2014 | 2011 Ford Transit Connect

1 Answer

Ford Transit Connect back up sensor problem? We


May have to have the computer reset after disconnecting and reconnecting

Nov 01, 2013 | 2010 Ford Transit Connect

1 Answer

Speed sensor located


On the outside of the transmission case.

Jun 11, 2013 | Ford Transit Connect Cars & Trucks

1 Answer

My 2011 ford transit connect won't shift into reverse, how do I solve this?


I have a 2011 Ford Transit Connect, my daily driver. Today I drove and parked. I went to drive again and could not get the vehicle out of PARK. I called a tow truck in and the driver showed me the problem. There is a black cover near the gearshift lever that is similar in size and shape to a dime. It can be removed with a small screwdriver. Once removed, there is a white switch revealed. When you push down on the switch while pulling back on the gearshift lever, you will be able to shift out of PARK.

Aug 06, 2012 | 2011 Ford Transit Connect

1 Answer

Ford transit 55 plate heaters when on hot they blow hot and cold and tempreture is up and down


There is air in the coolant system. check the resevoir and fill as needed

Nov 19, 2010 | 2011 Ford Transit Connect

Not finding what you are looking for?
2011 Ford Transit Connect Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5471 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...