Question about Cars & Trucks

Open Question

Has anyone got a fog light wiring diagram for LDV Maxus 2005 please?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 88 Answers

SOURCE: need wiring shematic for fog lights 2005 toyota corolla

im pretty sure these cars were already prewired for fog lights .there should be some plugs behind the bumper to fit them.if not get back i will explain how to wire them up.best of luck.

Posted on Oct 17, 2008

Ad
ButtFuzz
  • 463 Answers

SOURCE: i need a wiring diagram for fog lights oem to my toyota

The link below is a Typical fog lamp / driving lamp hookup. Keep in mind that in most states, for these lamps to be 'legal' (and thus pass inspection), you must wire them such that:

1. You can cut them off (in other words, there must be a switch installed to turn them off)

and

2. They may only be operated with the low beams. (therefore, you must power your on/off switch from the low beam circuit)

http://www.accessconnect.com/fog_driving_lights_wiring.htm

Posted on Feb 28, 2009

  • 775 Answers

SOURCE: 56 plate LDV Maxus, right hand indicator makes the rear fog lights flash along with the indicator

Hi,when this happens its normaly falty bulb or falty lamp holder which is creating bad earth,to find out if its a bulb swap all the bulbs at the back, so take the bulbs from left and put them in right and vicer vercer,if still blinking then take the board to have tested.
hope this was some help.

Posted on Apr 12, 2015

  • 3828 Answers

SOURCE: Today i bought ldv maxus van 3.5 2005 keeps jumping out 4th gear

will assume a used van
any warranty ? go back to place of purchase

if a manual ..worn syncros or adjustment to shifter cables

if an automatic a shift soleniod or worn drive clutches

26308726-vt3chhdyttrsn1qpus3sq421-4-0.jpg

Posted on Oct 12, 2016

  • 3828 Answers

SOURCE: Today i bought a ldv maxus van 3.5 2005 it jumps out 4th gear. I was told it's linkage cables by man I had it off

could be linkages
would need to track the shift cables to the gearbox

if no better worn syncros or automatic shift solenoids

looks like you are going to need a repair manual
ebay has a few



26308725-vt3chhdyttrsn1qpus3sq421-4-0.jpg

Posted on Oct 12, 2016

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Help needed have a Ldv Maxus, put a new plastic grommet into clutch pedal today as the old one broke, now having trouble getting it into gear unless I pump the pedal Any Idears please.


Sounds like there is now air in the system. If there is a bleed nipple on the slave cylinder, bleed the clutch with new fluid. If not, it is a sealed system and both the master and slave must be replaced as a pair and ensure you follow the instructions otherwise you will get air in the system again.

Jun 01, 2017 | Cars & Trucks

1 Answer

Fuel light is not working on my 09 ldv maxus


If you mean low fuel light then you may have a problem in the fuel level sending unit inside the gas tank, if I were you I would just live with the light not working.

Oct 13, 2016 | Cars & Trucks

1 Answer

Today i bought ldv maxus van 3.5 2005 keeps jumping out 4th gear


will assume a used van
any warranty ? go back to place of purchase

if a manual ..worn syncros or adjustment to shifter cables

if an automatic a shift soleniod or worn drive clutches

26308726-vt3chhdyttrsn1qpus3sq421-4-0.jpg

Oct 12, 2016 | Cars & Trucks

1 Answer

56 plate LDV Maxus, right hand indicator makes the rear fog lights flash along with the indicator


Hi,when this happens its normaly falty bulb or falty lamp holder which is creating bad earth,to find out if its a bulb swap all the bulbs at the back, so take the bulbs from left and put them in right and vicer vercer,if still blinking then take the board to have tested.
hope this was some help.

Apr 12, 2015 | Cars & Trucks

1 Answer

How to fix 5th gear on my ldv maxus


Its likely you have a problem with the clutchnot completly disengageing or problems with disk or pressure plate

Jun 13, 2013 | 1997 Chevrolet Cargo Van

2 Answers

Help!!! how to reset a LDV Maxus key fob?


Hi
I know from experience that you cannot really re synch these fobs on the LDV Maxus vans.
What actually is the fault is an onboard component on the pcb has failed and we normally just replace that with a new one..the fob will be tested for operation and sent back. OR its the Relay in the ESA unit - under the left hand front glovebox on the bulkhead - black with cables going into it. We have those relays (soldered to the pcb) we can supply those or do the work for you. The fob connects to that ESA and the unit then fires the relays to open/close the doors. Sometimes that unit is installed upside down which causes water (condensation) to enter the box and have fun with your electrics.
The fob is SYNCHED to this unit via coding we can use your old fob to clone to a new fob and that will work with the ESA and the vehicle.
We have the parts on this link Items for sale from remobilise ltd

Here is a link to how to program the fob to the vehicle via the programmer - NOTE how you MUST have a working fob to program another (text at the start of the video... LDV Maxus flv

We can fix most problems on the LDV Maxus that occur with faults to do with the Central locking/fobs/ESA/ETACS - three relays are in the ESA and they control ONLY the central locking - two more relays are in the ETACS unit (behind the ashtray) and they control the fogs and intermittant wipers.

Any help or info needed please contact info@remobilise.co.uk
or tel 01792 896404.

We are based in Swansea UK.

Aug 30, 2012 | Cars & Trucks

2 Answers

I need a wiring diagram for fog lights oem to my toyota


The link below is a Typical fog lamp / driving lamp hookup. Keep in mind that in most states, for these lamps to be 'legal' (and thus pass inspection), you must wire them such that:

1. You can cut them off (in other words, there must be a switch installed to turn them off)

and

2. They may only be operated with the low beams. (therefore, you must power your on/off switch from the low beam circuit)

http://www.accessconnect.com/fog_driving_lights_wiring.htm

Feb 28, 2009 | 2005 Toyota Corolla

1 Answer

Need wiring shematic for fog lights 2005 toyota corolla


im pretty sure these cars were already prewired for fog lights .there should be some plugs behind the bumper to fit them.if not get back i will explain how to wire them up.best of luck.

Sep 04, 2008 | 2005 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75842 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...