Lost ignition and door key for a 1999 Mercury Villager how do I get replacement?

Has nothing to do with the electric lock opperation.A spring is off on the ratchet gear inside the latch.Have a mechanic fix this,it is literall a pain in the butt to even get to.Let alone replace or repair it.Good luck Brother.

IGNITION KEY WILL NOT RELEASE

It can be faulty ignition lock cylinder. I suggest to wiggle the steering wheel a bit and see if the key gets released out. If that is not helping then first turn steering wheel to right and try removing the key, or next turn steering wheel to left and see if you can remove the key.

----------

Spray wd-40 in the ignition key hole and let it remain there for few minutes, after that once again try to remove the key and see if that helps.

---------

But if that is not helping then ignition lock cylinder has to be removed out and key has to be manually removed.

-----------

For more troubleshooting on these types of issues, I suggest you to refer the help links mentioned below. Its the accurate solutions mentioned in it. That will help you to narrow the problem: -----

Click the link below: ------

-----------

1999 Toyota Camry: Key Will Not Come Out Of Ignition?

http://whatisbyme.blogspot.in/2012/05/1999-toyota-camry-key-will-not-come-out.html

---------------

2001 Toyota Tacoma: Ignition Locked?

http://technoanswers.blogspot.in/2012/04/2001-toyota-tacoma-ignition-locked.html

------------

Ignition Switch Will Not Turn Off?

http://schematicsdiagram.blogspot.in/2012/04/ignition-switch-will-not-turn-off.html

-----------

Car will not turn the ignition to start?

http://technoanswers.blogspot.com/2012/01/car-will-not-turn-ignition-to-start.html

-----------

Ignition Key OFF but engine still running?

http://howtobyme.blogspot.in/2012/03/ignition-key-off-but-engine-still.html

--------------

Chevrolet Malibu: Key Stuck in ON position?

http://technoanswers.blogspot.in/2012/04/chevrolet-malibukey-stuck-in-on.html

2012 Dodge Ram: Ignition Key will not release?

http://whoisbyme.blogspot.in/2012/07/2012-dodge-ram-ignition-key-will-not.html

-----------

Ignition locked up on Mercury Villager?

http://technoanswers.blogspot.in/2012/01/ignition-locked-up-on-mercury-villager.html

-------------

Key won't turn in the ignition on Toyota land cruiser?

http://technoanswers.blogspot.in/2012/02/key-wont-turn-in-ignition-on-toyota.html

-------------------

How to remove ignition switch on VW Car models?

http://schematicsdiagram.blogspot.com/2011/12/how-to-remove-ignition-switch-on-vw-car.html

-------------

How to Replace Ignition Switch on Chevrolet Caprice Classic?

http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-ignition-switch-on.html

-----------------

1995 Ford Taurus: Ignition switch not turning OFF?

http://repairhelpcenter.blogspot.in/2012/06/1995-ford-taurus-ignition-switch-not.html

-------------

Ignition Problem Troubleshooting

http://whoisbyme.blogspot.in/2012/07/ignition-problem-troubleshooting.html

------------------

These will help.

Thanks.

Maybe.
Most dealers do not keep key blanks for more than 5 or 6 years.
You don't have an ignition key which is the same ?
The Villager is the same as a Nissan Quest so you could check with a Nissan dealer too.

what do you want to know?

go here

http://groups.yahoo.com/group/villagerquest/

YOU HAVE TO GO TO THE MERCURY DEALERSHIP.SINCE YOUR VECHICLE HAS THEFT SECURITY SYSTEM. THEY HAVE TO SPECIAL MAKE KEYS BEFORE KEY SWITCH AND IGNITION IMMOBILIZER MODULE WILL WORK ALLOWING VECHICLE TO CRANK.

If you have the factory alarm system, you can put your key into either door and lock and unlock the door, that signals the computer to deativate the alarm. If you have an aftermarket alarm system installed, it will have to be removed and the wiring that the alarm ties into must be restored to factory design.

may be lock actuator. remove trim panel & check.

go here

http://groups.yahoo.com/group/villagerquest/

The door switch is faulty or the wire leads are damaged. Try manually depressing the switch rapidly to see if the switch will actuate. Easy to replace.

SECTION 501-14A: Handles, Locks, Latches and Mechanisms 1999 Villager Workshop Manual REMOVAL AND INSTALLATION Actuator —Power Door Lock, Front Removal

1. Remove the front door latch. For additional information, refer to Latch—Front Door .

1. Remove the power door lock actuator from the front door latch.
   1. Release the locking tabs.
   1. Remove the power door lock actuator from the front door latch.

go here too

http://groups.yahoo.com/group/villagerquest/

even if can do what u propose the van will not start, the security system will not recognize the key, you need to take this to a dealer not a locksmith