Question about 2007 Ford Fusion

1 Answer

2007 FORD FUSION, RIGHT REAR WINDOW POWERED DOWN, THEN IMMEDIATELY WOULD NOT POWER UP AGAIN, NO NOISE, JUST DEAD. ALSO NOTICED THAT THE SWITCH IS NOT ILLUMINATED, ALL OTHERS ARE FUNCTIONING PROPERLY

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 119 Answers

If u r referring to the control box usage then that particular switch in the control box established corrosion u can clean by dismantling the unit that switch clean the contact if u r know legible however u need to test for voltage from the control box to the window motor by pressing the switch up and test for voltage at the motor and press down and test for voltage at the motor also if no power try to clean the switch contact at the control box if able or replace a used one make sure ur wiring in order and test for voltage again if voltage established plug it to the motor and switch up and down see if problem is resolved if not check for window rail alignment if ok most likely your motor is bad. Good Luck

Posted on Jan 03, 2017

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Windows are not working roght


Put some silicone spray or dry lube in the window frame where the glass runs and this will free up the window and take the load off the motor.
All "Henry"window winder switches are a problem they don't last lone at all. I have replaced my Ford winder switches about every 18months to 2 years. They are a money maker for Ford Motor Coy

Sep 02, 2015 | 2003 Ford Explorer Sport Trac

1 Answer

How does the hydrulic system for 2007 ford fusion push back the clutch pedal


you did it wrong, the actual clutch pushes back with about 60 lbs force, and reduces by linkage 6 to 1 to see 10 lbs at foot (pedal spring nada,) ASE basics 101 , clutch hydra.
the slave and mc are in hyraluic lock ( dot3/4 fluid is not compressible, ) so you do have air there.
and bleed it right.
or on some cars, the slave has an adjust able rod and was set wrong. (read FSM)
or the pedal top shackel was never attached, so master is dead. (look at master for rear)

this system likes to fight you in bleeding air out, in the wrong direction.
bubble float up. you bleed down so..... yes, sux.
i use a vacuum tool to suck at bottom. and suck lots of fluid through even a quart if that is what it takes.

to prove the case?, push the pedal, see the rear mc, piston move in far, sure,
then with 2 guys, see both ends move, if the slave is dead,
you HAVE AIR. for sure.
all this is no different from brakes, not a word. master /slave.

Jan 08, 2015 | 2007 Ford Fusion 1.6

1 Answer

Estimate to replace power steering pressure switch on v6 2007 ford fusion


The switch will be on the pump. the part is not too expensive. you just need to unscrew it, replace and plug back in...

Sep 25, 2014 | 2007 Ford Fusion V6

2 Answers

I have a 2010 ford fusion and the driver power window will let it go down but not up. It will allow it to go partiallup and then the window will go back down. What causes this?


replace window motor it should come with the window regulator as well. it takes more power to push window up then down. wore out motors will act like this. the fact that it trys at all tells you the switch,relay and circit breaker are good

Apr 16, 2013 | 2010 Ford Fusion 2.5

2 Answers

Driver window wont go up or down 2010 ford fusion


Do the other windows work ok?
There might be something wrong with window motor, itself? With most vehicles, the driver door window is rolled up and down much more than the others.

Jan 23, 2013 | 2007 Ford Fusion I4 SEL Sedan

1 Answer

Why cant i get my power windows to go up?


Try this website to download a free manual



http://ezinearticles.com/?Find-the-Free-Auto-Repair-Manual-You-Need-Online&id=92717

May 01, 2010 | 2007 Ford Fusion I4 SEL Sedan

1 Answer

2007 ford fusion sunroof wont open what would be the cause of this


CHECK FUSE IF OKAY.CHECK TO SEE IF POWER GOING TO SUNROOF MOTOR SWITCH IF YES SUNROOF MOTOR COULD BE FAULTY OR IT NEED ADJUSTMENT.SWITCH COULD BE BAD.IF SWITCH IS GETTING NO POWER FUSE IS GOOD THERE IS A BROKEN WIRE FROM FUSE TO SWITCH.

Feb 22, 2010 | 2007 Ford Fusion I4 SEL Sedan

2 Answers

Driveline vibration


first i wound check for mud build up on the inside of the wheels

Dec 28, 2009 | 2007 Ford Fusion I4 SEL Sedan

Not finding what you are looking for?
2007 Ford Fusion Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...