All are near cam, so it can sense it.
all are 2 or 3 wires, not counting shield wire cover.
unless on pre DIS systems with distributor its in the old distributor base.
no engine stated, just 4cyl. (size matters )
my book shows DIS system
2.2L gas /petro not the 2.2 diesel
A new 2.2-liter X22SE engine built by Holden in Australian engine ! in USA car...
step 15,
see that ? , see that wire, It is there.
see PDF here
see pdf page 61,
step 1 to 7 , out of real book
http://automotrizenvideo.com/wp-content/...
I just googled for X22SE engine manual, and it landed in my lap.
helps to know real name of engines,
big time! help.
pretty much ,if the rear of cam has no wires.
it be on front.
that small wire bundle is it. a dead giveaway
best is to replace that belt there.
cam drive. not run it to the end and boom.!
and if the belt slips(or is loose) guess what? , you will get cmp errors. after all a jogging belt and cogs causes timing to bounce and report errors. (by design, btw)
just for skipping belt service.
×
SOURCE: thermostat on 1998 Isuzu Amigo
Yes, It's under the intake manifold. The manifold would need to be removed
Lower hose from radiator is attached to steel pipe leading to it.
It will not be an easy mission,and the new thermostat is rated for I believe 170 degrees.
That's not much help to keep the interior warm with a rag top when it's 20 below zero.
You can boost the heating level by adding vinyl cover over the front portion of grill.
Any boat interior shop has the material.
Modify any large air leaks.
Use the fan to keep fresh air filling vehicle, not recirculate.
SOURCE: 1998 amigo timing 2.2 liter
The timing marks on the cam shaft sprockets are easily to see when you get the timing cover off. When the two cam shafts are lined up (pretty much at the top), then the crank should be almost down at the bottom.
Get yourself a good shop repair manual - I got mine from E-Bay for less than $15.00 (used).
Also, if your going to change the timing belt, have the water pump replaces at the same time.
SOURCE: Cam Shaft Position Sensor 1998 Saturn SL
Have a look at this link, scroll to your engine & click on picture to expand for better view.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528017e904
SOURCE: Adding freon to 98 Isuzu Amigo
You need to add the freon on the low side which is usually indicated by a blue cap. The red cap is the high side port. Never add freon using the high side port. Typically if you are buying a guage set from your local auto parts store, it will only attach to the low side service port because they are diffent types of connections. Another easy way to tell is to turn your AC on and feel the lines that the ports are attached to. The low side should be cold/cool and the high side will be hot.
SOURCE: cam position sensor broke
ok easy fix. this is common on ALL ford w this style cam sensor,3.0 eats them for lunch. the sensor base has bushings like a real distributor, they get wore and fail. you can get new from ford, or reman at auto parts about 100 bucks. they come w the sensor installed but as with either, you need the allginment tool, looks like a little hockey puck, that only come from ford to set up or check engine light wont shut off. it will run without this but poorly. if you need more advice just post a comment to this and ill do my best to advise you
82 views
Usually answered in minutes!
×