Question about Nissan Cars & Trucks

1 Answer

Have a 91 Nissan truck just purchased, it's stuck in reverse and 5th gear, how do I fix

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 1,927 Answers

If the problem is in the shifter lever assembly, you can remove that from the top of the transmission after you remove the floor mat/carpeting, slide up the boot, and remove the six bolts holding it to the transmission. But, if everything seems to be free and moving smoothly in that assembly, the transmission will have to be disassembled to find which shift forks or associated rods are bound up or broken.

Posted on Jan 02, 2017

  • Michael Cripps
    Michael Cripps Jan 02, 2017

    It moves but when I crank it it's either in reverse or moves to 5th. Can't get it in any other gear

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 8 Answers

SOURCE: 1990 Toyota 4runner wont go into 5th or reverse

They had a problem with this plastic washer that is in the shifter tower it sits just under the shifter it self and gets worn out and causes this to happen- hope that helps.

Posted on Nov 06, 2008

  • 84 Answers

SOURCE: wont go into 5th gear

I am going to assume this is a manual transmission, if it is 5th and reverse are on the same selector set, the only solution is to strip the transmission and check out whats broken.

Posted on Dec 22, 2008

  • 51 Answers

SOURCE: 5th gear doesn't lock

5th gear is gone, it'll be cheaper to find a good second hand one with a waranty than to get your one fixed sorry to say. The inside of gearboxes are only a place for gearbox specialists and they arent cheap unless you know someone.

Posted on Jan 12, 2009

  • 158 Answers

SOURCE: 91 toyota celica transmission problem

it sound to me that you have to much end float in the cluster gear have you put all the correct shims and set the tollarances correctly also have you reraced the gear box get back to me with more info Please Lindz

Posted on Mar 20, 2009

  • 1 Answer

SOURCE: transmission stuck in 5th gear???

i had same problem it is your cam positioning sensor

Posted on Jun 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

91 Nissan truck 5spd transmission , only gear that works is reverse and 5th gear, doesn't have a reverse Lockout or a reverse sleeve. Trying to rock back and forward of truck no luck, any suggestion?


if the gear lever is into the top of the box, remove the turret and pivot ball and see why the shifter rails are not lining up
if it is a column shifter , check all linkages for adjustment or fallen off

Jan 02, 2017 | Nissan Cars & Trucks

1 Answer

200 Nissan sentra linkage cluck no 5th grar


Transmission case + 5th gear fix - SR20 Community Forum - The Dash



www.sr20-forum.com > ... > HowTo's > General Maintenance

Dec 28, 2010 - 25 posts - ‎6 authors

How to recognise and repair 5th gear pop-out in a B13 or B14 ... Dont worry about the shift rod linkage and other parts in the old ... bad 5th gear and the notch gets larger and lager then you have no 5th gear . ..... BenFenner's 2000 Black M-Coupe ... NISSANB13 (Sunny/Sentra Genesis) Kumpul2 di sini yuk!


ugh stuck in 3rd gear (5spd LD) P10 g20

21 posts

Jun 13, 2012


No 5th gear

30 posts

Jan 1, 2011


How to: Fix your P11/B15 tranny with QG18 gear ...

39 posts

Sep 11, 2009


Thread: How to recognise and repair 5th gear pop-out in ...

36 posts

May 15, 2009


More results from www.sr20-forum.com

Oct 21, 2015 | Nissan Cars & Trucks

1 Answer

Samurai 5th/reverse rail fork stuck


Hi Amanda

This sounds very much to me like a linkage problem. I think your best bet would be to take it to your mechanic for him/her to have a look at it and fix it properly.

Hope this helps.
-Steve

Apr 02, 2015 | 1992 Suzuki Samurai

1 Answer

Gear shifter cable


sounds like a stretched gear shift cable or the linkage on the tranny may need some adjusting i would start with the linkage first jack vehicle up and do a visual while some one goes through the gears make sure to use jack stands so that the power wheels are off the ground.....good luck

Nov 09, 2013 | Nissan 200SX Cars & Trucks

1 Answer

How do I get my car out of being stuck in 5th gear?


Here's a link ,check it out,may or not be it,is your Nissan a stick shift.If it's a stick shift,go check your clutch master cylinder's fluid.if low or empty,then your clutch slave cylinder is bad.here's a link on it.You can add fluid and bleed it for a temporary fix.

Jul 08, 2013 | 1996 Nissan Maxima

1 Answer

No 5th gear or reverse


I have a 1998 Nissan Frontier, 2wd. I was driving back from lunch one day, and the 5th gear stopped working. Then the next day, the reverse stopped working. It switches into 1st, 2nd, 3rd, and 4th just fine. Please help. What do you think it could be. I have no money to take it to the shop

May 28, 2012 | 1998 Nissan Frontier

1 Answer

I lost 5th and reverse shift in my 91 samurai. I pulled the trans and found that the arm where the shifter goes into 5th and reverse is sticking in the up position, instead of dropping back down. I have...


You know the thing is 20, 10 years beyond its service life. Something has lasted twice its projected life and you are disgusted? Find a used transmission with much lower mileage and install it, obviously you have the skills to R&R, or find a rebuild kit and rebuild the transmission. It may be cheaper in the long run to scrap it and find another vehicle.

Jun 28, 2011 | 1991 Suzuki Samurai

1 Answer

Transmission stuck in 5th gear???


i had same problem it is your cam positioning sensor

May 30, 2009 | 2004 Nissan Maxima

1 Answer

300Zx will not shift out of 5th gear


is there any pedal pressure when you step on the clutch? I had a similiar problem with my 91 300zx tt....it was stuck in third gear, no pedal pressure on the clutch whatsoever....i had cracked the pivot ball and the clutch slave 'popped out'. i had to pull the trans to fx the problem because i could not reattach the clutch fork onto the release bearing with the trans in the vehicle....you need to bleed the system...gravity bleed the slave until there are no air bubbles. make sure you top off the clutch master cylinder in the process.....then bleed the clutch operating cylinder.....it is in the passenger front hood near the power steering resivoir....top off the clutch master cylinder again. i hope this helps.

Apr 03, 2009 | 1990 Nissan 300ZX

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14251 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...