Question about Cars & Trucks

Open Question

We cannot turn on the sound affects or lights ? How do I properly connect it to get the buttons yo work ?

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2008 Dodge Grand Caravan. I just had new front brakes put on, replaced the front bumper and a lightbulb for the rear blinker. Now my cruise control doesn't work.


Au contrer . the brake pedal should be up all the way, or your sw that turns on brake lights also affects cruse....when your brake pedal is slightly pushed it disconnects the cruise. Did you bleed brakes properly?

May 15, 2017 | Dodge Cars & Trucks

1 Answer

No brake, turn, or hazard lights on rear of 2008 ford taurus


sounds like a wiring loom connector may have come apart as affecting all rear lighting trace loom back from light cluster to see if all are connected properly

Mar 29, 2014 | 2008 Ford Taurus SEL

1 Answer

What does the ecm control?


This could be a major project for someone.
The engine computer controls most anything connected to the engine, but the body computer affects the other things on your list.
So it could be one or both computers, or wiring harness problems.

Feb 06, 2014 | Chrysler 300M Cars & Trucks

1 Answer

No power at all when ignition was turned. Tried again, checked battery then got back in car and noticed the door lights and ignition locator light were on. The car stared right up. Everythng worked...


I don't think the door lights would be affected by the key switch.
It sounds like a bad connection at the battery or farther down the line. Maybe even a ground connection.

Jul 26, 2013 | 2002 Subaru Outback

1 Answer

1999 Suburban 2500 4WD interior lights won't go off and no daytime dash light. Dome over ride button doesn't affect it. Had to remove bulbs. Have had panel lights sometimes off. Come back on after restart...


Sounds to me like your light switch is faulty, however, check and remove all the door buttons to determine this, ensure that the wire/s are connected on the buttons and that the door is butting against them when closing.{ including the tail gate} Good luck

Nov 19, 2009 | 1999 GMC Suburban

1 Answer

Dashboard lights don't work warning lights are okay


try turning up the brightness of yo inst panel light should around the headlight swhitch or will be a small nob or button with a picture od a light bulb with lines around
Pls rate this solution

Feb 17, 2009 | 2004 Toyota Tacoma

1 Answer

My truck only blows heat through foot when blower turned on


it doesnt sound like a vacuum problem to me. it sounds like your switch in the dash has gone bad. if it was a vacuum it would only affect you selecting which vents you want the air to come out of.

Feb 02, 2009 | 2000 Chevrolet Silverado 2500

1 Answer

Back up lights come stay on when head lights are turned on


Don't have a schematic on this but likely -problem is from lighting control module... However check that trailer harness is properly installed and did not cause initial problem.

Dec 21, 2008 | 2005 Jeep Liberty

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...