Question about Cars & Trucks

Open Question

HOW DO YOU SET UP THE HEATER THAT IS TEMP CONTROLS

Posted by on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

raygin
  • 322 Answers

SOURCE: Heater running at max temp

You need to check the twin solenoid heat control valve found on the RHD side down by the base of the radiator. When these fail they mostly fail in the ''open'' state so hot water is constantly supplied to the heater. Possible causes 1 solenoid valve failed 2 cables and connectors to valve faulty (often suffer from corrosion and damage- inspect carefully) 3 voltage signals to valve from control module missing, the modules can suffer from a blown output transistor or damaged PCB tracks caused by high current shorting - (easily repairable) If its any comfort - I currently have a solenoid failure on one side of my valve so the passenger is roasting whilst I'm okay, good job its winter here ! I have checked all the above and know its a faulty valve so I will have to change it - but its a ***** of a job as there is no room to move !! hope this has helped - good luck !

Posted on Jan 07, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does heater have a fuse


Blower and if you have the automatic temp control the door that controls the temp does have a fuse. If the fuse or door control module is burnt out then the output air will remain the same no matter where you set the temp.

Feb 10, 2014 | 2005 Mercury Mountaineer

1 Answer

How do i take the dash board off my 1999 mercury sable


Hi...i have a 99 Sable..my heat temp only stays on 90...even if the controller is set at 65...the temp always is 90... how do i remove the dashboard to get to the heater/ac controls???

thanks
Michelle

Dec 28, 2010 | 1999 Mercury Sable

2 Answers

I've recently had my A/C recharged but the system still blows hot air. When the A/C is off, the fresh air still blows hot.


make sure the compresser is turning on and off
if not there might be a leak that was missed

Apr 15, 2010 | 2005 Jaguar S-Type

1 Answer

Heater blows cold


Does temp gauge on dash show normal temp? If so problem is with the controls. If sytem cycles through normal controls IE, defroster, floor,bi-level and redirects air properly check to make sure door control is functional for heater core. If door is not opening then you will never get hot air

Feb 11, 2010 | 2000 Volkswagen Passat 4Motion

1 Answer

Does the thermostat control the temp of the air blown by the heater?


It controls the engine water temp so if engine temp low it won't blow hot air
Heater water pipe has an inline control valve that controls heater temp either vacuum controlled or by cable to dash control

Jan 27, 2010 | 1999 Dodge Grand Caravan

2 Answers

WHen we use the auto car starter, it blows cold air, and a lot of it. Its nearing the winter here in New England and I need to know how to set up the starter to blow warm air. Any ideas?


Start the vehcle and let it warm up then set all the controls to heater? Then turn off the car. Use the remote start to start the vehicle and check the controls are still set to heat mode.

Oct 02, 2009 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

2001 Suzuki XL-7. Heater blows hot one side, cold the other.


No ductwork [to the lower vents] under the dash. They are part of the heater core / blower housing is integrated (all one piece).

After reviewing shop manual, we suspect that one of the three damper flaps is not positioning correctly; or debris has blocked one side (which makes more sense given the symptoms).

We're waiting for the temperatures to get back in the plus numbers to check out the physical arrangement.

Jan 19, 2009 | 2001 Suzuki Xl 7

1 Answer

Fully warmed up; blowing hot and cold; Suzuki XL-7


Its just a vent damper plate not operating, it's like a gate which controls the flow of air,,usually they are operated by vacuum, or cables.
Service center time, unless you are handy with your own repairs.

Jan 19, 2009 | 2004 Suzuki Verona

2 Answers

Heater


replace the motor for the fan.it sounds like its weak

Jan 13, 2009 | 1996 Dodge Ram

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...