Question about Mitsubishi Cars & Trucks

Open Question

I overfilled the tranny on 2003 Mitsubishi diamante drained and refilled,still won't go in gear

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

BillB-SA
  • 2761 Answers

SOURCE: 2003 mitsubishi diamante thermostat

You're going to lose some coolant, so have a bucket or other container ready. Follow the upper radiator hose to the point where it's connected to the engine. The hose is clamped to a metal housing which is bolted to the engine. Remove the bolts (not the hose) and lift the housing to expose the thermostat (may require a little prying with a screwdriver or similar tool). Note how the old thermostat is fitted (which end is up), lift it out of the engine, and then remove all traces of gasket from the housing and the engine. Install the new thermostat and gasket, replace the bolts, add coolant as necessary, and you're done.

Posted on Jan 04, 2010

  • 3 Answers

SOURCE: Location of fuel pump on 2003 mitsubishi diamante?

bs it is in the back under the seat dont comment if you dont know
remove four screws pop plate off and there it is it took me 25 mins to change fuel pump beat that

Posted on Jan 19, 2010

  • 3 Answers

SOURCE: where is the fuel filter

It is located in front of the rear driver tire. It is between the frame and gas tank.

Posted on Nov 12, 2010

  • 14036 Answers

SOURCE: how do i make the

TAKE VECHICLE TO ANY AUTO PARTS STORES THEY WILL SCAN CAR FREE AND TELL YOU CODE SO YOU CAN FIX CAR.THE LIGHT WONT TURN OFF UNLESS YOU FIX THE PROBLEM.YOU NEED TO CHECK IT OUT.DRIVING CAR WITH CHECK ENGINE LIGHT COULD HARM CAR.AND IT EMISSION SYSTEM.CAR PCM COULD BE IN LIMP MODE SHUT DOWN MODE YOU NEED TO HAVE CAR SCANNED.YOU DONT WONT NO SURPRISES LIKE CAR SHUT DOWN ON THE ROAD SIDE SOMEWHERE.

Posted on Jan 25, 2011

saailer
  • 1868 Answers

SOURCE: My check engine light is

Hello! It is located below and to the right of the steering column.....


Guru..Saailer

Posted on Mar 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why is it buzzing by my tranny pan when i put it in gear?


needs service.
get it service fast, or it can get worse.
ever price a new tranny?

check level first, dont guess, use the instruction on how to do that.
its not like the engine oil level checks at all , read the method
do not overfill it.
ATF levels check is in most operators guide, if missing that means
its FSM covered.
factory shop manual

Jun 10, 2014 | 2003 Mitsubishi Montero Sport

1 Answer

How to add transmission fluid in 2003 diamonte


the fluid is added via the dipstick tube , you will need a funnel and add a little at a time and check level as dont want it overfilled hope this helps

May 19, 2014 | 2001 Mitsubishi Diamante

2 Answers

Overfilled oil in 1998 Mitsubishi Mirage


if this is engine oil just undo the engine drain plug you will obviously need a large flatish tray to catch it in ,if its the tranny same thing but let it all out and start again with fresh fluid check manual for quantity, the consequences can be quite damaging to the engine if driven and more so for the tranny so do before drivig again

Apr 29, 2014 | 1998 Mitsubishi Mirage

1 Answer

Drain some transmision fluid


Suck it out with a turkey baster with a long hose attached, or a siphon kit for a gas tank.

Apr 20, 2014 | 2001 Mitsubishi Diamante

1 Answer

2003 Mitsubishi Diamante SL i just bout diamante great car only smetimes when i come to stop it kicks down hard into 1st.or 2nd ive check the fluid it looks to be fine but ?????????


Hi your transmission belts and gears are getting to that rebuild the ****** point. Also your lock-up tourqe convertor is starting to mufunction. Amaaco did a great job for me on vehicle, the warranty is worth it.

Aug 16, 2011 | 1994 Mitsubishi Diamante

1 Answer

My 2002 Mitsubishi Diamante starts up fine, but when i put it into drive or reverse the car wont move. Im almost positive it is some sort of transmission problem, but what can i do to fix it?


You will have to replace it.
Pull off the wheels, pull out the half shafts, put a jack under the tranny, unbolt the tranny drop the tranny, remove the water lines if it has them, remove the sensor cables. install the new tranny.

Mar 15, 2011 | 2002 Mitsubishi Diamante

1 Answer

Where is the transmission filter located on the car


that is located inside the tranny you have to take off the tranny pan to get to it

Sep 02, 2010 | 2003 Mitsubishi Diamante

1 Answer

My car doesn't change gears, it's runing in hght gear only.


you need to get a new transmission control module, i had the same problem when i bought my 92 from the auction, i wouldn't shift from 1st to 2nd, so i found a rebuilt unit on the internet and it corrected the problem, you also might want to remove the excess tranny fluid that every one put's in when they have a tranny problem.

Nov 21, 2008 | 1992 Mitsubishi Diamante

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...