Question about Cars & Trucks

Open Question

Where can I get the vinyl decals for a t1200 the ones one the side and along the bonnet

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 98 Ford Taurus my tail,brake and dash lights along with my speedometer quit working. What could the problem be?


There are 2 fuse boxes on that car, one under the hood (bonnet), and one under the dash on the drivers side. Check all the fuses with a test light, while the car is running.

Sep 08, 2015 | Ford Cars & Trucks

2 Answers

Car stereo no power


it could be ground out to something else i had the same problem with my 96 jimmy when i bought it i took it to custom audio and they fixed all my wiring problems

Sep 04, 2013 | Oldsmobile Alero Cars & Trucks

2 Answers

Hi, I have a 1995 Audi coupe, the bonnet is stuck on one side so when I pull the bonnet release the bonnet only pops up on one side. any ideas? thanks


get somone to push down on the bonnet and pull it up while u pull the relise handle. if dont work then strip the front grill and u should be able to open the catch manualy

Jul 10, 2013 | Cars & Trucks

1 Answer

Looking for fuel pump shut off. To reset it.


It should be in the trunk, along one side, behind the liner. Might even be a small decal on the liner indicating its location. Hope this helps.

Aug 10, 2011 | 1995 Lincoln Town Car

1 Answer

Bonet is stuck, put the key in turn it left and its not opening,


Look into the grill at the top you will find the bottom of 6 plastic screws, 4 you get two via the grill slots use a chisel and cut them off, Then one either end of the grill. Place the chisel between two plastic layers, gently lift , check and cut, one each end.
With a wiggle that's the top loose, There are two clips holding the bottom in place Put your fingers through the bottom slot in the grill, push down clip and greatly pull the grill, do both sides, It won't come right out but your aim to loosen it., The lock is held in place in a sleeve with a plastic clips each side, you have push the barrel with a suitable item, this is to push it out of the sleeve and out of its housing, It may need a tap!!
Gently wiggle and pull the grill off
Lock
The lock is a 'lock barrel along a shaft to a white plastic coupling' this fits in to the 'bonnet lock'
The security is at the coupling to bonnet lock in the form of a cross shaped plastic key
The key is fitted and held in place in the coupling, and when installed it's fitted in to the lock, and once it's in the lock part it will not come out, so therefore any jolt, pull, movement dislodges the plastic key from the coupling side and due to its design it will not slot back in so the lock barrel just rotates
To open you have to apply pressure on the shaft towards the left and into the coupling and turn the key in the lock barrel at the same time in a aim to get the coupling to catch the plastic key (take a few minutes) but it opens in the end if this is the fault, (alternatively remove the two bolts that hold the bonnet catch to the bonnet)
Once bonnet open remove the bonnet lock mechanism, then with draw the lock barrel, shaft, coupling, By looking in side you will understand regarding the cross key
Anyway you need to remove one of the catches from the side of the plastic key This way it will fit back in to coupling.
Reassemble

Mar 09, 2011 | 2006 Ford Focus

2 Answers

What coil fires on what cylinder on a 2002 ford taurus 3.0 liter


coil pack should have numbers on it check follow the leads firing order should be under bonnet decal trace them back to the coil pack and number them

Jun 06, 2010 | 2002 Ford Taurus

2 Answers

Where is bonnet catch situated on citreon dispatch


its at the very bottom of the dash line most are orange but I had the peugeot expert ( same van reall) and it was black on the passenger side right under the glove box part, I have seen them on both sides of these vehicles so just look along the very very bottom of the dash. its only small though about 4 inches long and 1 inch wide.

Jan 08, 2010 | 1991 Peugeot 405

2 Answers

Replacing BMW decals on the side of the 1998 BMW Z3 roadster


There is a spray product that I used a long time ago to remove the vinyl letters off a boat. It worked great just can't remember the name. Check with an auto paint supplyer.

May 08, 2009 | 1998 BMW Z3 Roadster

1 Answer

The bonnet on my mx5 is high on one side


Found the problem one of the bonnet hinges was beginning to seize up put loads of wd40 on it moved the bonnet up and down to ease the oil in. Then closed the bonnet and pused down on it where the hinge is so that it became level with the wings. I then just loosend the bonnet nuts slightly closed the bonnet and moved it into the best position carefully opend it and did up the nuts if the headlamps are still a bit low open the bonnet and just pull gently on the back of the head lamp and they wil come into place job done it looks great

Mar 21, 2009 | 1996 Mazda MX-6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...