Question about 1995 GMC Yukon

2 Answers

I have a 1995 GMC YUKON it cranks but won't start

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 4,536 Answers

Fuelpump may b bad..test pressure. Inspect inside of distribuutercap

Posted on Jan 01, 2017

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 1,335 Answers

Have you checked for any codes in the ECM ? May also want to check for spark at the wires/plugs.

Posted on Jan 01, 2017

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

motor1258
  • 6674 Answers

SOURCE: My GMC yukon XL 2001 engine runs after 4 times of cranking.

Try turning key to on only, not start, 2 or 3 times first then try to start. If it starts good first try, then I'd change my fuel filter & then have fuel pressure tested if fuel filter didn't help. You may be looking at a new pump, but lets do filter & test fuel pressure first.

Posted on Jul 06, 2009

csmock132
  • 4669 Answers

SOURCE: 95 yukon won't shift into first gear.

I don't think its plug wires. When you say it won't shift into 1st? It takes off in 2nd? Does it shift to 3rd and 4th? Or is it a shifter problem? Like it won't go into manual 1st


Posted on Jul 21, 2010

  • 5370 Answers

SOURCE: After parking my 1995 GMC

The fuel is not reaching the engine and the gears are bit worn out.They are not engaging.Both the fuel lines and gears need a inspection.---------- --------- The car parked on the hill for so long time has cause the problem to gears, they are not engaging and fuel is also not reaching, when the car is towards uphill.------- I suggest get the fuel pressure and fuel lines inspected, also get the gears checked, if checked out faulty, then get it replaced.--------------- This should help.Thanks.Helpmech.

Posted on Jun 23, 2011

  • 1565 Answers

SOURCE: My 96 yukon wil not

try spraying some carb cleaner into a vaccum hose and see if it will run. If so then you have ignition but no fuel delivery. If not then you have an ignition problem. make sure you hear the fuel pump hum when you turn the key to the run position. It should run for +/- 5 seconds then shut off. remove gas cap and listen for fuel pump operation through the fill hole. If you can hear the pump then you have a fuel injection issue. If the engine starts and runs for a few seconds then shuts off then you can suspect the crank or cam position sensor. The fuel pump runs through the oil pressure switch which could also be an issue.

Are you able to start the truck with application of the gas pedal?

Posted on Sep 22, 2011

airjer995
  • 5332 Answers

SOURCE: 2001 gmc yokon won't restart after running out of gas

On the drivers die of the engine you shoud see the fuel rail. There will be a test port with a black cap on the pressure line near the fuel pressure regulator. With the engine off, remove the cap and press in the schrader valve (be prepared for gas to shout out). If no gas comes out and you have repeatedly tried to start the vehicle than you have most likely ruined the fuel pump.

The fuel pump is cooled by the fuel in the tank. Running them dry especially in a GM is almost guaranteed to burn up the pump.

You can also check to make sure there is power to the pump.

You should be able to find the harness that runs to the tank on the inside of the frame rail on the drivers side. Open up the plastic loom and look for the larger of the two grey wires. The best thing to use is a test lead called a JR Jumper (this will allow you to pierce the wire without ruining the insulation and causing corrosion issues in the future). If one is not available you can use a very small sowing pin to pierce the wire.

If you use the pin apply some liquid black tape or even some silicone to the area to help reseal the wire.

Let me know if you have any questions and I'll be happy to help!

Posted on Jan 05, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On my 95 Yukon, can a faulty i.c.m. cause a total no start situation? And when it died, it just stopped like someone just shut off a switch, and came home hooked to a tow truck.


It is possible, however check if the tachometer works when you crank the engine . if not, probably the crankshaft position sensed is inoperative.

Mar 12, 2016 | 1995 GMC Yukon

1 Answer

What are some of the reasons a 1995 gmc yukon wont start back up right away.


Jessica, Are you saying it will not crank over or cranks over - engine will not run?

Master Tech Lee

Dec 09, 2014 | 1995 GMC Yukon

1 Answer

2002 GMC Yukon XL 5.3 Cold start


What happens if you bring power directly to the starter solenoid? Will it crank then? You need to try to isolate the problem. If it will crank with direct power, the starter is NOT the issue. Let us know what you find.

Jan 04, 2014 | 2002 GMC Yukon XL

2 Answers

Disconnected battery in 2007 gmc Yukon. Dash lights and radio work. Engine won't crank. Remote won't work. How to reset?????


kindly pls check the BCM which is located under the left side of the dashboared i hope that will help.

Mar 30, 2013 | 2007 GMC Yukon

1 Answer

Yukon won't start after sitting for a few days


What are the symptoms ?
Cranks but does not start ?
Cranks for a long time then starts ?
Does not crank without a jump from another battery ?

Feb 22, 2013 | 2000 GMC Yukon Denali

1 Answer

My 1995 Gmc Yukon wont crank when the dash lights dont cme on but when they do it will crank?


My first guess would be the key switch is faulty.
A mechanic would test the circuits at the switch.

Jul 10, 2012 | 1995 GMC Yukon

1 Answer

I have a 1997 gmc Yukon that won't start...I just


It might be the cam or crank shaft senser.They do act like that when going bad

Dec 14, 2011 | GMC Yukon Cars & Trucks

Not finding what you are looking for?
1995 GMC Yukon Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...