Question about 2004 Chevrolet Aveo

Open Question

On 2004 chevy aveo I disconnected positive post to clear check engine light I had to replace oxygen sensor now it won't start just cranks real good

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2000 chevy blazer, truck cranks

Does your battery go dead?

Posted on Dec 18, 2008

Ad
motor1258
  • 6674 Answers

SOURCE: crank shaft position sensor needs replacing in 96 Chevy cavalier

Try this.

c6734a6.jpg

Posted on Sep 05, 2009

  • 770 Answers

SOURCE: 2004 Chevy Aveo cranks but won't start. Where

I believe that what you are saying is that it is turning over but will not crank...(run), not sure what your problem is, but I can help you to narrow it down. In order for your engine tp crank...start...run, you need three things to be right..#1 adequate compression, #2 ample spark, #3 the correct fuel/air mix. The first thing i would check is spark..reason, #1 failure of the 3. You can start by seeing if you have spark at the plug(S)...Just because you have it on one does not mean that you have it on all. 2nd most common failure would be no fuel...improper mix, you are fuel injected, so likely a sensor/computer issue...and the most uncommon of the 3 would be a compression issue. Which would likely not occur on all cylinders so the engine would still run, unless the cause was a broken timing belt. Gives you something to start on. Good Luck.Hope this helps.

Posted on Nov 08, 2009

Testimonial: "Thanks for the feedback, much appreciated!"

  • 72 Answers

SOURCE: how do you change an oxygen sensor on 2006 chevy aveo

There is a special socket for O2 sensors which allow the wires to stick out and not get twisted up. It's not expensive and available at most auto parts stores. Disconnect the sensor from the wiring harness, with the plug and then use the socket to remove and replace the new sensor. Re-connect electrical plug.

Please rate this answer. Thank you.

Posted on Apr 08, 2010

emissionwiz
  • 76848 Answers

SOURCE: Chevy aveo error codes. I have a check engine light on.code p2135

P2135 Throttle Position Sensor (TPS) Property Malfunction, remember this is not a car that is built by GM it is a Korean import.

Posted on Jun 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Hi.. I got a chevy aveo year 2004 with engine check light fail and it won't start.. is it because of cam sensor?


You need to read the code out of the computer. There are so many reasons why the car might not start. You need to get a code reader from your local auto parts store or ebay, amazon, etc. Once you read the code, only then can you make a plan what to replace to get the car running again.

Apr 24, 2015 | 2004 Chevrolet Aveo

4 Answers

2004 Nissan Sentra SE-R cranks but won't start!


It is not a problem of sensor as it is not showing any dashboard light, neither it seems to be a problem of battery as battery gets charged after driving if the alternator is working fine or otherwise it won't start at all after overnight standing. It could be a problem of starter solenoid as it has copper windings and when the copper winding gets old it functions intermittently. I am sharing a video that will explain it better.

Feb 17, 2015 | 2004 Nissan Sentra 2.5

1 Answer

2006 chevy aveo check engine light (code # p0315)


I took it in to a different mechanic and am told that the car will not "learn" the cps. It will clear the CEL but as soon as the key is put in the ignition it comes back on He suggested putting in the original crank sensor but that one is cracked so do I need to get an ac/delco or gm sensor instead of what I got from autozone or how do I get it to recognize the sensor we put in?

We did check the fuses and that is not the problem.

Jan 06, 2013 | 2006 Chevrolet Aveo

1 Answer

2005 Chevy Aveo cranks but won't start.


Chevrolet Aveo 1,6 LS won't start just cranks crank angle sensor ok and coil ok

May 14, 2012 | Chevrolet Aveo Cars & Trucks

3 Answers

I have a Chevy 2006 Aveo. Two codes came up when the engine check light was put on a scanner. Code P0340 and Code P0133. The check engine light has turned off and on by itself several times in the...


P0340 OBD-II Trouble Code - Camshaft Position Sensor Circuit Malfunction

This indicates that a problem was detected in the camshaft position sensor circuit. Since it says circuit, that means the problem could lie in any part of the circuit - the sensor itself, the wiring, or the PCM. Don't just replace the CPS (camshaft position sensor) and think that will definitely fix it.

Symptoms can include:
* Hard starting or no start
* Rough running / misfiring
* Loss of engine power

Causes: A code P0340 could mean one or more of the following has happened:
* a wire or connector in the circuit could be grounded/shorted/broken
* the camshaft position sensor may have failed
* the PCM may have failed
* there exists an open circuit
* the crankshaft position sensor may have failed

Possible Solutions: With a P0340 OBD-II trouble code, diagnosis can be tricky at times. Here are some things to try:
* Visually inspect all the wiring and connectors in the circuit
* Check for continuity in the circuit wiring
* Check the operation (voltage) of the camshaft position sensor
* Replace the camshaft position sensor as required
* Check the crankshaft position circuit as well
* Replace circuit wiring and/or connectors as required
* Diagnose/replace the PCM as required



P0133 OBD-II Trouble Code - Oxygen Sensor Circuit Slow Response (Bank1, Sensor1)

This involves the front oxygen sensor on Bank 1. This code indicates the engine air fuel ratio is not being adjusted by the oxygen sensor signal or the ECM as expected to do so, or not adjusted as often as expected to do so once the engine is warmed or under normal engine use.

Symptoms: You will likely not notice any drivability problems, although there may be symptoms.

Causes: A code P0133 may mean that one or more of the following has happened:
* The oxygen sensor is faulty
* The wiring to the sensor is broken / frayed
* There is an exhaust leak

Possible Solutions: The simplest thing to do is to reset the code and see if it comes back.
If the code comes back, the problem is more than likely the front Bank 1 oxygen sensor. You will likely wind up replacing it but you should also consider these possible solutions:
* Check and fix any exhaust leaks
* Check for wiring problems (shorted, frayed wires)
* Check the frequency and amplitude of the oxygen sensor (advanced)
* Check for a deteriorating / contaminated oxygen sensor, replace if necessary
* Check for inlet air leaks
* Check the MAF sensor for proper operation


Hope this helps (remember to rate this answer).

Feb 09, 2011 | 1999 Chevrolet K1500

1 Answer

How do you change an oxygen sensor on 2006 chevy aveo


There is a special socket for O2 sensors which allow the wires to stick out and not get twisted up. It's not expensive and available at most auto parts stores. Disconnect the sensor from the wiring harness, with the plug and then use the socket to remove and replace the new sensor. Re-connect electrical plug.

Please rate this answer. Thank you.

Apr 07, 2010 | 2006 Chevrolet Aveo

1 Answer

Is not getting fuel to injectors has new cpu and crank sensor and a new cam sensor. motor is new .i was told when it died going down the hiway it needed a new engine, but this is what has been going on...


check the fuel pump and related electrical system and fuses. The aveo doesn't have a fuel filter but only a screen at the bottom of the pump. I had to replace the fuel pump in my 2004 aveo at 80k due to a clogged screen. Hope this helps

Nov 12, 2009 | 2005 Chevrolet Aveo

1 Answer

In my Chevy Optra 2004 the "Check Engine Light" came on. I took it to the dealership and they ran a diagonstic scan. Charged me $70.00 and told me that the Camshaft Positioning Sensor has to be replaced....


If having the light does not affect drivability then keep useing.When the position sensor packs it in completly it may not start but until then,happy motoring.[put a peice of black tape on the dash to make it less annoying.]

Nov 04, 2009 | 2004 Chevrolet Aveo

3 Answers

2005 Aveo; hold light blinking, check engine light on, car chugs


Try a toon-up..
Or might be a sensor.. There are several..
Trying to figure these things out is a process of elimination.. Unless looked at by a shop..

Hope this helps !!
rate me good ;o)

Jul 13, 2009 | 2004 Chevrolet Aveo

3 Answers

Hold light blinking, check engine light on, engine slows down


check tps sensor (throttle position sensor in backside of the throttle cable) and map sensor (manifold absolute pressure on front little 1 inch sensor with vacuum line) make sure there plugged in. the ecm (engine control module driver side inner fender) and tcm (transmission control module under dash) both need the data to know when to upshift and increase fuel/air. Otherwise the computer runs default values and guesses off of other sensors giving poor performance. also disconnect battery for 15 min. usually resets aveo service lights if you dont have a scanner.

Jul 13, 2009 | 2004 Chevrolet Aveo

Not finding what you are looking for?
2004 Chevrolet Aveo Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...