Question about Holden VT

Open Question

My reserve water tank needs to be replaced how do i remove it from 99 VT commodore

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 44 Answers

SOURCE: Vt Holden Commodore stereo wiring diagram

head down to your local auto store and you will be able to pick up a wiring harness adaptor. you wire your stereo to this adaptor then you simply plug it into the wiring loom. no damage to the loom so if you ever need to reinstall the standard stereo its just an unplug and plug back in. its extremely simple and colour coded so there are no mistakes.

Posted on Jun 28, 2009

Ad
  • 56 Answers

SOURCE: bubbling water in the water tank

typically that is caused from a bad head gasket, fluid from the engine will be forces through the radiator then boils over or bubbles. As far at the no gauge reading, you probably need a new one.

Posted on Jan 03, 2010

  • 1244 Answers

SOURCE: i have a 2001 chevy Malibu. Have problems with

Due to the complexity of the newer cars on the raod today!! what you are experiencing is Normal!!! since the coolant systems on the newer cars run at such a higher pressure and a high Rpm the reserve tank which has it's on drain hose for excessive overflow from the radiator allows the extra high pressure release from the radiator to back flow to the reserve tank and then out the reserve tank overflow hose on to the raod

Posted on Jan 17, 2010

tunde007
  • 2382 Answers

SOURCE: how to replace head gasket

Hi, replacing a head gasket is not a DIY job, unless the person has plenty of experience, knowledge, and the proper tools. The fact that a person would even ask, "How to replace a head gasket", would indicate to some that they should not trying to do that repair. To replace a head gasket you must remove the intake manifold, exhaust manifold, valve train, and then the head. This is very involved and requires disconnecting lots of sensors and the ignition system. The head must then be checked to see if it is warped, or cracked, and repaired if necessary. You must then know how to put all this back together and torque all the bolts in the proper sequence. This takes training and skill which the average shade tree mechanic does not have.

Pick up a Haynes or Chilton manual. Either one should give you detailed directions with illustrations.
Or let a mechanic do it...

Posted on Feb 21, 2011

emissionwiz
  • 76682 Answers

SOURCE: how to remove a rear bumper bar on a 2000 VT commodore

It is just bolted on, go under the vehicle and remove the bolts

Posted on Nov 01, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car stays in first gear when driving it's a vt commodore


automatic ?
GM 4L60E transmission.

low oil
faulty shift solenoid

if transmissions shot
approx $350-400 gets a better one from a wrecker

repair manual for the auto is online
and some youtubes made on theses automatics

join this free forum
best VT commodore owners think tank in australia
https://forums.justcommodores.com.au/forums/vt-vx-holden-commodore-1997-2002.10/

Mar 07, 2017 | Cars & Trucks

2 Answers

Why does my 1999 supercharged vt commodore when im traveling down the highway idle up and down when i take my foot off the gas


It may be a problem with the TPS switch (Throttle Position Switch). Go to a local mechanic with a diagnostic tester to confirm.

Jul 27, 2014 | 1998 Holden VT Commodore

1 Answer

When I've being driving for awhile my vt commodore just stalls with no warning and may take half an hour or more before it will restart need help


change your crank sensor
a way to confirm if this is at fault when it stops pour cold water over left side of crank pulley where sensor is and try and restart if it restarts its the sensor

Mar 07, 2014 | 1998 Holden VT Commodore

1 Answer

Vt shifter button


this is not an uncommon problem.
you will need to go to your local holden dealer and purchase a new gear shift button.
To fit the new gear shift button you will need to remove the centre console insert and the screw that holds the t-bar trim in position..

Jul 03, 2013 | 1998 Holden VT Commodore

1 Answer

Remove ignition barrel in vt commodore


you need to have the key in the ignition take the shrouds off there is a small hole underneath the barrell you have to push something small into the hole then pull out the barrell

Apr 09, 2013 | 1998 Holden VT Commodore

2 Answers

I have a 99 Mercury Sable Wagon that keeps boiling the radiator fluid out of the reserve tank. The temp gauge isn't reading hot, though. Any suggestions? Thanks.


Sounds to me like a blown head gasket. Even if your vehicle is not warmed up, if your reserve tank is boiling fluid out of it when the engine is cool, it's most likely losing compression from it all going to your reserve tank. And thats why it's fluids coming out of your reserve tank. BUT, if your radiator is clogged then the same thing could happen. So i would start out cheap before you have to replace a HG. Thanks, James Booth been a mechanic for 6 years

May 17, 2011 | 1999 Ford Taurus

1 Answer

Why is all the fluid staying in reserve tank-none


The line to the reserve tank to the radiator could be plugged up or you have a loose radiator cap or a bad seal causing the tank to hold whats in it. The coolant system is a pressurized system and if a seal is bad or a line is plugged you will experience this problem for the pressure is not there to take whats needed from the tank to deploy in the coolant system

Jan 26, 2010 | 1999 Oldsmobile Silhouette

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Holden Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14380 Answers

Are you a Holden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...