Question about Ford Thunderbird

Open Question

How to remove rear interior side panels on 1997 thunderbird lx

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1986 Answers

SOURCE: How do I remove the passenger side interior rear

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll be able to get to everything.

Posted on Sep 18, 2009

Ad
  • 1986 Answers

SOURCE: need directions to remove driver door interior panel 1997 deville

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls

Posted on Sep 23, 2009

  • 1986 Answers

SOURCE: need to remove inner rear passenger side door

On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you need to pull back the weather seal and then you can access the bolts securing the outer handle

Posted on Nov 05, 2009

  • 255 Answers

SOURCE: how to remove rear door interior door panel

You should obtain a tool made specifically for removing door panels. They are attached by "snap" connectors, and by pulling on the door panel itself will invariably ruin it. Get the tool from a parts place and carefully peer into the slot between the door metal and the door panel. Use the tool slowly with resolution. You should really acquire a manual that guides you for your particular Jag.
Remember, to take the panel completely off, you need to remove the door handle. Look for a plug that has a screw under it. You'll need to pop the door window/lock control panel too, to access screws under there. This can be tricky, so be careful.

Posted on Nov 24, 2009

  • 324 Answers

SOURCE: I need to replace the driver side power mirror on

First screws are on the bottom side of the inside door pull/ arm rest, and after that there may be a few around the edges of the panel. unscrew the up and down locking pin if it has one up there by the window, gently pull out at the bottom to release the plastic push pins and once all pins are pulled out (there are probably 10 to release) reach in between the panel and gently take apart the connections. Lift up and out to free the panel of the window gaskets and there you are, Be easy with it all that stuff breaks easily!!!!

Posted on Jun 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse box for exterior lights


There are two fuse blocks. The one for high power, is in the engine compartment adjacent to the battery. The low voltage fuse block is under the instrument panel on the left side of the dashboard.

May 16, 2014 | 1997 Ford Thunderbird LX

1 Answer

On a 1997 ford thunderbird 4.6 liter V8 - Where is the ignition control module located?


They are plug and play units...passenger side of interior...usually behind a kick plate or bolted to the general area around the heater box

Feb 18, 2013 | 1997 Ford Thunderbird LX

1 Answer

How do i remove the center console from a 1997 thunderbird


CENTER CONSOLE- Disconnect the battery cables to disable air bag. Wait two minutes before working around steering column, instrument panel or impact sensors. 1. Open console lid and remove the two screws you see toward the front. 2. remove the shift lever knob 3. Rotate the rear of the panel forward, disconnect the electrical connectors, then detach the clips at the front edge by pulling upward. Now panel is free to remove it.

Oct 25, 2012 | 1996 Ford Thunderbird LX

1 Answer

Were is the turn signal relay in a 1997 ford thunderbird


The Flasher is located behind LH side of the instrument panel, left of steering column, it i snot a can like the old ones, it is a black box about the 1/2 the size of a pack of cigarettes. See picture.
10_18_2012_11_02_09_pm.jpg

Oct 17, 2012 | 1997 Ford Thunderbird LX

1 Answer

Need to know how to replace the exterior door handle on a 1997 ford thunderbird.


Ever considered you have to remove the inner door
panel just to get to it?

Jul 26, 2011 | 1997 Ford Thunderbird LX

1 Answer

Want to remove the motor from my 1997 ford thunderbird and replace same. Can I remove motor and tranny at same time? I have been told I have to remove motor and tranny seperately...


I have had my engine out (1991 Cougar 5.0), and I did it separately. I do not think both could be removed at the same time with a conventional engine hoist. It is a pain separating them. Be sure to replace the rear main seal!!

Jun 04, 2010 | 1997 Ford Thunderbird LX

2 Answers

I have absolutely no air coming out of my vents in my 1997 Ford thunderbird. I pulled the blower motor and it works just fine. What next?


you have a stock vent valve most of the time the get stock in defrost pull the control panel and check the vacuum lines and regulator

Aug 20, 2009 | 1997 Ford Thunderbird LX

1 Answer

Accessing the speaker on driver side door panel.


You will have to remove the entire door cover. Remove any screws you can see, pop off the cover behind the door handle remove screws behind that, pop off the plastic that holds power window switches and unplug them, then you will have to pull the door panel upwards to remove.

Mar 27, 2009 | 1997 Ford Thunderbird LX

1 Answer

How to remove the door panel on a 96 Ford Thunderbird?


Carefully pull front door trim panel finish panel away from front door trim panel.
Disconnect wires from front door lock switches, outside rear view mirror controls and window regulator control switches, if equipped. Remove front door trim panel finish panel.
Remove front door trim panel retaining screw through front door trim panel finish panel opening.
Remove interior lamp lens cover.
Remove screw through interior lamp opening.
Slide front door trim panel upward to disengage hooks.
Rotate top of front door trim panel away from front door and lift bottom hooks from front door.
Disconnect window regulator jumper wire
Remove front door trim panel.

Feb 21, 2009 | 1996 Ford Thunderbird LX

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...