Question about 2007 Chevrolet Trailblazer

1 Answer

Abslight stays on. How to fix? - 2007 Chevrolet Trailblazer

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Chevrolet Master
  • 1,194 Answers

Have you recently had any work done to your vehicle, like tires or brakes? Possible a connector for the ABS wasn't re-hooked up. OR there's a short.

Posted on Jan 09, 2017


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

After replacing 4 brake pads , rotors and 2 front wheel bearings my brake light and ABSlight stays on

Check bearing connection,if you plug in right,#1 could bent pin is side,#2 broken wire check where loops wires!!!! #3 bad module.

Oct 04, 2015 | 2005 Nissan Murano

1 Answer

How do I switch off my ABS light on my audi a4

I presume you haven't switched off the ESP or anything on the dashboard? Light might be because there is a fault with ABS, so best take to a garage and get them to read off the fault code

Aug 26, 2014 | 2007 Audi A4 1.9

1 Answer

Abslight stay on nd emergency light stay on and service brake sysem on dash stayon

check your brake fluid level. most new cars have a sensor that makes the light come on when the level gets low. and on something of that vintage, that is probably a good indicator that your brakes are worn out.

Sep 28, 2013 | 2002 GMC Envoy

1 Answer

ABS light stays on after new pad install

The ABSlight has nothing to do with the brake pads. It comes on to tell you there is a problem with the ABS system. You best option is to have the ABS computer scanned for trouble codes. This will help narrow down the possibilities. Typical problems include bad speed sensors, bad wheel bearings, or broken exciter rings. If you had posted a Year, make, model, and engine size, I may have been able to help narrow down some possibilities and/or given some tips on what to check. Let me know if you have any questions and I'll do my best to answer them. Thank you for using!

Jan 22, 2012 | Cars & Trucks

1 Answer

I have a 97 chevy suburban1500 myabs and light is on as I excelerate my spedomiter is not working and its not changing gears sounds like trans is goin only when abslight is on when and light is off truck...

If your tack, odometer ,engine light is on and indicator light is not working then it could be the fuse for the ******.It could also be your ignition switch is not suppling power to that fuse.No power to that fuse or if its blown will cause truck to stay in 3rd gear which is like a safe mode for it.

Nov 04, 2011 | 1997 Chevrolet K1500

1 Answer

Abslight stays on no brake lights

Fuse 12 (10 Amps) may be burned out. Its located in "Junction Block". Losing
fuse 12 would kill the ABS systems and light the ABS dashboard light.

Fuse 11 (20 Amps) may be out. Its located in "Power Distribution Center". Losing fuse 11
would kill the brake lights, and light the ABS dashboard light. If fuse 11 is blown,
check your (3) brake light sockets for shorts of any type, or fuse 11 will just blow again.

Here's your ABS Indicator Light wiring diagram:


Feb 20, 2011 | 2000 Dodge Caravan

1 Answer

ABSlight and Brake light come on and off, but

could be, check brake fluid, if you have computer scaned you will be able to pinpoint problem, may be a sensor dirty or going bad, good luck.

Oct 26, 2009 | 1998 Dodge Ram 1500 4WD

2 Answers


Good time to inspect them, but may also be a faulty/dirty sensor.

Sep 04, 2009 | 1996 Volvo 960

1 Answer

Instrument panel not operating

You have a blown fuse. The problem is that there is a cruise control deactivation switch on the master cylinder that gets brake fluid contaminated and shorts out. You will need a new switch and maybe the the connector.

Mar 25, 2009 | 2001 Ford Windstar

1 Answer

1990 jeep cherokee abslight and brake warning light on , abs pump runs constantly, any help would be appreciated

not a good sign any leaks? if not sounds like abs mod is faulty or wiring faulty check relay that may be cycling all the time

Jan 16, 2009 | 1990 Jeep Cherokee Limited

Not finding what you are looking for?
2007 Chevrolet Trailblazer Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides