Question about Cars & Trucks

1 Answer

Working on a 2006 Tundra 4.7 disconnected the battery now no start, lights come on just does crank no click from starter or anything

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Expert
  • 52 Answers

Try a repair manual: http://www.papertownspdf.com/downloads/toyota-tundra-repair-manual-1999-2006/

Posted on Dec 30, 2016

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 95 F150 wont crank

the starter should be replaced. The solenoid is kikcing the pinion out but there is no contact being made to turn the starter motor. I have the exact same truck and before i changed the starter used the old starter tap trick. Tap the starter casing with a hammer and it should start turning again. hope this was helpful for you. Good luck.

Posted on Nov 07, 2008

  • 30 Answers

SOURCE: 2006 Toyota Tundra battery not charging

if you left your key on, and not in the "accessory" position you may have ruined your coil! if your key is turned on, it is charged with alot of electricity.

Posted on Mar 23, 2009

  • 295 Answers

SOURCE: 2006 jeep cherokee will not start it just clicks. Battery fine.

If it just clicks only once from the starter replace the starter comen problem on jeeps.

Posted on Jul 20, 2009

  • 2309 Answers

SOURCE: 2006 yukon wont start. Replaced battery and

check the lead wire to s terminal on the starter, it should have voltage with the key on start

Posted on Oct 26, 2009

  • 85 Answers

SOURCE: what is the average life expectancy for a 2006

First thing you should do is ensure that the battery connections are tight on both ends if you can reach them the negative cable will go to a frame or engine ground and the positive cable should go to the starter maybe via a boosting post, if that doesn't work then remove the battery cables and clean the connections with a terminal brush. Corrosion on the terminals can cause poor performance of the starting system, make sure you do a good job and clean both the battery and the cars terminals or the symptom will still exist. From your description (no battery light after starting indicating a charging problem) if this doesn't solve your problem then you will need a new battery (Try charging the battery first it may work at first but if it happens again the battery is pooched or your locat parts store should be able to load test your battery to tell for sure if it is). Make sure that you have the codes to enter into your radio before you disconnect the battery as the honda's need this every time the battery is disconected. If you don't have it stop by your dealerships service department with your registration and they will be able to quicky run your serial number through Honda online and get you your radio code.

Posted on Dec 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Starter problems, Suggestions???


Starters tend to fail intermittently. Yes, if it started after a "whack", I woul suggest replacing your starter. Make sure all connections are tight and of course clean terminals and cables.

Sep 03, 2016 | Cars & Trucks

1 Answer

Hello, looking for starter location for a 2006 saturn vue 2.2l 4 cylinder.


If it's like every other 2.2 front wheel drive Saturn, it should be at the bottom front of the engine, away from the serpentine belt side.
Look under the car, right side. It should be fairly obvious .
Please disconnect the battery before attempting any removal.

Mar 27, 2015 | 2006 Saturn Vue 2.2

3 Answers

2002 chev impala, will not start. fuel pump and gauge not working on dash. When i go to start all lights go out on dash and than they will come back on in 3 or 4 seconds?


Have the battery tested if no good replace. Check for power at the starter cable and then while someone holds the key in the crank position check for power at the trigger wire of the starter. If you have power but no crank or click then you may have a bid starter or the engine is seized. If no power on the tarter little wire which comes from the ignition switch make sure you fuses and relay is good and that your ignition switch is working. If the battery tests good have your alternator checked as well.

May 14, 2014 | 2002 Chevrolet Impala

1 Answer

06 4.0 v6 tundra won't start tried jumping it it just clicks once I unplugged the cables no power?


jumped with other car running?
if it clicks,
we next hot wire the starter solenoid,
if it clicks now with good battery (or running jump), it's a
1: bad starter. or 2: seized engine (turn by hand? yet)
if it cranks fast now hot wired, the KEY line is dead
ask how to fix either.

Jan 12, 2014 | 2006 Toyota Tundra

2 Answers

My Tundra Starts Intermittently


You have a defective starter solenoid, the heavy contacts are burned in side the solenoid.

Apr 17, 2012 | 2006 Toyota Tundra

2 Answers

My 2006 Equinox won't start. The battery is fine it is just making a lot of clicking noises. What could be the problem?


First question is: Is the battery really fine? Turn on the headlights and see if they stay on while trying to crank the engine.

If they stay on on then yes, the batttery is fine and the problem is likely your starter solenoid.

if not, then you may have a dead cell or two in the battery that provide enough power to light up your interior and run accessories, but cannot turn the engine over. Hope this helps you find the issue. Cliff

Feb 21, 2011 | 2006 Chevrolet Equinox

1 Answer

Sometimes I turn the ignition key to start my 2007 4.7 v-8 tundra pickup & I just here a click after trying several times the starter engages . Not several clicks just one . After checking battery...


The problem is the starter solenoid. It will steadily get worse until it just won't start anymore. The solenoid has corrosion between the contacts. When you turn the key the contacts are not making connection. The corrosion will get a little worse each time you crank it.

Oct 29, 2010 | 2007 Toyota Tundra

1 Answer

My tundra wont start but all the lights and radio


That might be a possibility. Asssuming when you say it wont start you mean it won't crank over. First check battery voltage at the battery with a dvm when you turn the key to the start position. Then check the voltage at the starter when you turn the key to the start position. If both readings are the same and you must have a reading of at least 12dcv. Try turning the ignition key to the on position( not the start) and jump the positive voltage from the starter to the solenoid terminal. The starter should crank over if the proper voltage is present.If the starter just clicks or just attemps to start. yes, you need to replace your starter

Mar 25, 2010 | 2000 Toyota Tundra

3 Answers

What is the average life expectancy for a 2006 honda pilot with remote starter? when starting the starter clicks and the lights on the dash blink on and off then starter clicks again and lights do the same...


First thing you should do is ensure that the battery connections are tight on both ends if you can reach them the negative cable will go to a frame or engine ground and the positive cable should go to the starter maybe via a boosting post, if that doesn't work then remove the battery cables and clean the connections with a terminal brush. Corrosion on the terminals can cause poor performance of the starting system, make sure you do a good job and clean both the battery and the cars terminals or the symptom will still exist. From your description (no battery light after starting indicating a charging problem) if this doesn't solve your problem then you will need a new battery (Try charging the battery first it may work at first but if it happens again the battery is pooched or your locat parts store should be able to load test your battery to tell for sure if it is). Make sure that you have the codes to enter into your radio before you disconnect the battery as the honda's need this every time the battery is disconected. If you don't have it stop by your dealerships service department with your registration and they will be able to quicky run your serial number through Honda online and get you your radio code.

Dec 03, 2009 | 2006 Honda Pilot

1 Answer

96 ford explorer no power no crank no anything


Sounds like a connection problem/error. When you replaced the starter solenoid, do you remember how many wires you disconnected and reconnected?

Was there any indication ( sparks, etc) of accidentally causing a short when you replaced the solenoid?

Your initial problem of no start but hearing the click sound is almost a sure fire indication that the starter is NG. If the solenoid clicks, that means that it is applying 12 volts to the starter.

hope this helps Good luck Loringh

Nov 08, 2008 | 1996 Ford Explorer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...