Question about Dodge Ram 1500

1 Answer

How many QTS trans fluid does it take to fill up 99 dodge ram 1500. 5.9 motor

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Dodge Master
  • 43,095 Answers

I hope you do not put transmission fluid in the motor . check your owners manual or call a dealer ..motor could be around 6 qts with new filter

Posted on Dec 30, 2016

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Monster80
  • 460 Answers

SOURCE: 99 dodge ram 1500 4x4 5.9l tranny problems

Take a look at the down shift cable and make sure its not broken especially were it connects to the throttle linkage.And maybe try cleaning the electrical plug that plugs into the trans.Its about a 7 to 9 wire plug.They tend to collect water and short the wiring out.

Posted on Mar 31, 2009

  • 1 Answer

SOURCE: had u joint repair on 98 dodge ram 1500 v8 now have trans leak?

I just replaced my front ujoint for the 2nd time and yes when you pull the outer axle to replace the u joint and then reinstall the axle it seems to dislodge or screw up the seal. the 1st time i had a shop do it and they fixed the seal but now its on me

Posted on Jul 16, 2009

  • 28 Answers

SOURCE: od/off trans temp light comes on. had fluid and

your trans cooler is restricted. most likely it is part of your radiator and if it is restricted you will either need to replace the radiator or install an aftermarket cooler. have your trans cooler flow checked and go from there

Posted on Jul 27, 2009

  • 412 Answers

SOURCE: 98 dodge 1500 ram speedometer not working sender

ABS LIGHT ON AS WELL?IF SO..I WOULD LOOK AT ABS SENSOR IN REAR DIFFERENTIAL..GETS SPEED SIGNAL FROM THIS SENSOR AS WELL..USES ONE IN TRANS FOR TRANS SHIFTING

Posted on Aug 31, 2009

  • 52 Answers

SOURCE: dodge ram 1500 2001 codes coming up 0753 1757 1762

0753 is shift solenoid A, electrical problem.as for the other codes they should start with a zero not a one. if they started with a 0757 that means shift solenoid B,stuck in on position. 0762 means shift solenoid C,stuck in on position. 0765 means shift solenoid D,malfunction

Posted on Feb 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I refill the torque converter on a 1987 Dodge Ram 50 pickup


filling the transmission fluid through the dipstick tube and run the motor the torque convertor will fill itself. make sure after running the motor and shifting into each gear with foot on brake to pump fluid through out the trans that you check the fluid level.

Aug 16, 2014 | Cars & Trucks

1 Answer

How much transmission fluid for 5.9 ltr 1500


It should be 11 to 12 qts on a completely dry transmission. All the vehicles fluid capacities will be in your owners manual, if you don't have one; check with your local parts store or dealership.

Jun 20, 2014 | 2000 Dodge Ram 1500 Truck

1 Answer

My 2006 dodge ram overheated then was fine then started skipping


check the spark plugs you might have blown a head or headgasket

Mar 24, 2012 | 2006 Dodge Ram 1500

1 Answer

I changed the fluid and filter on my 1997 dodge 1500 and the same day the transmission stopped shifting gears....what could be the problem?


it is possible you either did not add enough fluid, added too much fluid, or the fluid you replaced the old with was the wrong type for the trans. was there a problem with the trans before you replaced the trans fluid? make sure that when you change the trans fluid you are working on a flat surface. if you pull/check the dipstick while the truck is on jack stands, or otherwise elevated, you reading will be off. and you may find that after pouring in the new fluid and setting the truck down to test drive and circulate the new fluid that you have put too much fluid in the pan. this will show up as bubbles on the dipstick, or fluid coming out of the fill tube. also make sure the fluid you use is the right type. chrysler transmissions require different fluid than ford, or chevy. though you did not specify if your trans is manual, or automatic.

Dec 24, 2010 | 1997 Dodge Ram 1500 Club Cab

1 Answer

Replaced front seal on my '97 Dodge Ram 1500, V6


Assembly of converter to trans and then tunit to engine? The torque converter must engage and slide into the front pump. The seal is easily damamaged if not properly fitted.Once the trans is against the engine the converter can be slid forward to bolt the flex plste.There should not be more than approx. 1/4 inch between the converter and trans bell housing if the converter is properly mated to the trans. Good Luck, Ned.

Jun 01, 2010 | 1997 Dodge Ram 1500 Club Cab

1 Answer

I have a 2001 dodge ram 1500 sport 4x4 and the transmission slips between first and second gear, I have replaced the filter and fluid and am still experiencing the slip, what could be the cause?


Most important is making sure the trans is full, especially after doing a
trans service, since the torque convertor needs to be under a load when filling it, to completely be full. If you had the vehicle running and shifted
it through the gears while filling it up with tranny fluid, your good, but if
not, check it again.

Mar 30, 2010 | 1999 Dodge Ram

1 Answer

How do add fluid to a 1997 Dodge Ram 1500 standard


if you go under the truck you will find a 3/4" pipe plug on the side of the trans case, revoce it, fill the trans to just below the threads of that plug, use your pinky to check the level..

Sep 29, 2009 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Trans fluid capacity?


fluid filter change

4l60e 5.0 qts most 1/2 ton trucks
4l80e 7.7 qts most ld 3/4 tons and some hd 3/4 ton trucks

Sep 22, 2009 | 1999 Chevrolet Silverado 1500

2 Answers

Transmission fluid


If your vehicle has the 5.2 liter,aka 318 cubic inch engine,there is only one transmission model applicable and it is the 42 RE which used to be designated the A500.It is a 4speed overdrive transmission.If installing a rebuilt trans and new remanufactured dry torque convertor.You add 4 quarts initially,then fire the engine and add another 5-6 quarts for a total capacity of 9-10 quarts.Fluid level is checked with the trans in Neutral.If you are only dropping the pan,you will replace roughly 4 quarts.The transfer case fills separately,but uses the same automatic transmission fluid.Capacity for the transfer case is about 2 quarts/fill to the bottom of the fill plug hole.Good luck.

Sep 15, 2008 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...