Question about 2002 Ford Taurus SES

Open Question

Where is oil sending unit on ford taurus 2002 ses

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 373 Answers

SOURCE: air bag code

Hi, ON your 2002 ford taurus, The Flashing code 33 ( B 2292 )

This code refer to : Driver side seat belt pretentioner ( seat belt bucklet) problem.

Check the conecctions under the driver seat.
Repair as need, and recheck if thi code is present.

But if you had an accident on you taurus. You need to replace the Seat belt Pretentioner ( seat belt bucklet)

OK. I hope this information work for you.

Than's.

Posted on Jul 11, 2008

Ad
  • 142 Answers

SOURCE: Air Bag Code

Code 52 relates to low voltage detected in a capacitor inside the airbag module. 45 seconds after key on, this capacitor should have a voltage of around 23 volts.

This capacitor stores energy to deploy the airbag in the case of a collision.

Because your airbag light is on, your system is deactivated (cannot deploy)

In your case, the airbag computer detects less than 23 volts at that capacitor 45 seconds after key on, and disables the system.

There is a diagnostic procedure involved in fixing this problem, but usually means a bad airbag module (computer)

This should only be checked by a qualified technician, as airbag service can be dangerous and there are strict procedures to follow so the bags don't inflate suddenly and cause injury.

Posted on Aug 27, 2008

  • 3 Answers

SOURCE: PCV valve location

if i know what you are asking, look at where you put your oil in. on the valve cover to the top right should be a plug with a tubeing runs to your air clear tube where the air mass sensor and carb is located. i think that is what you are looking for.

Posted on Nov 07, 2008

rtpflh
  • 546 Answers

SOURCE: exact location of oil sending unit on a 95 ford

on OHV engine,at rear of engine block,just ahead of transaxle
on OHC on forward side above oil filter.

Posted on Oct 16, 2009

ZJLimited
  • 17970 Answers

SOURCE: where is the oil sending unit on a 1996 ford

On 3.0L OHV engines, the oil pressure sensor is located on the left side of the engine block above the flywheel. On 3.0L DOHC engines the sensor is located on the left side of the engine block above the oil filter. On 3.4L DOHC engines the sensor is screwed into the oil filter adapter. The oil pressure sensor operates the oil pressure warning lamp.

71f6e37.jpg
Fig. 1: Location of the oil pressure sensor-3.0L OHV engines


046f42b.jpg Fig. 2: Location of the oil pressure sensor-3.0L DOHC engines

69cce3e.jpg

Fig. 3. The oil pressure sensor-3.0L OHV engine

Hope help with this (remember rated this help). Good luck.

Posted on Feb 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

SE w/A/T. Why does it go only 10 to 25 mph?


2002 Ford Taurus SES won't go over 30MPH and it won't pass first ...

www.taurusclub.com > ... > Maintenance and Repair
Dec 30, 2011 - Drives: 2002 Ford Taurus SES 3.0L V6 Automatic. Posts: 2 ... I tried your advice about 10 minutes ago and drove on 1, backed out of my driveway on to the main road. Once it .... Goes to 3000 4000 rpm's and only 40 mph. Shake at 60 mph and up
Jan 1, 2013
Wont rev over 3500 or go over 25mph
Jan 9, 2012
Will Changing The Throttle Position Sensor Fix My Problem ...
Feb 2, 2008
Top Speed 45 Mph?
Apr 19, 2004
More results from www.taurusclub.com

94 taurus will not go faster than 15 mph - CarGurus


Jan 01, 2016 | 2002 Ford Taurus

1 Answer

Ses


Do you know if the wire going to the oil pressure switch is plugged in ? And not grounded anywhere ?

Jul 17, 2013 | 2002 Ford Taurus

1 Answer

I own a 2002 ford taurus ses. My dashboard light was out, but I just had my car fully serviced last month. I noticed may car was over heating. I drove home. No coolant whatsoever inside it. I cannot...


Personally, I would pour water in, it is a lot cheaper and if there is no leaks then you could drain it out and put coolant in.

BUT before you start it check your oil dipstick and make sure that you don't have coolant on your oil dipstick.

Aug 28, 2011 | 2002 Ford Taurus

1 Answer

Belt diagram for a 2002 ford taurus ses


You normally can find the diagram on a sticker on the underside of the hood directly above the alternator on a 3.0 OHV motor 2002 Ford Taurus. I copied one from the Internet and taped it above the headlight on my car so it was easier to view and use. If you send me an email address I can post an image to you that shows the routing diagram or you can use this:

http://www.daycoproducts.com/daycoweb.nsf/DaycoSerpentineBeltGuide.pdf

V6 182 3.0L FI (VIN S)
Multiple Accessory, w/A.C. illust. 5-7 (page 86)

V6 182 3.0L FI (VIN U) (OHV 3.0)
Multiple Accessory illust. 7-12 (page 87)

V6 182 3.0L FI Flex (VIN 2)
Multiple Accessory illust. 7-12

Jun 27, 2010 | 2002 Ford Taurus

1 Answer

My 2002 ford taurus ses starts and shift gears but


HAVE CAR SCANNED TO CHECK FOR TRANSMISSION FAULT CODES.

Feb 01, 2010 | 2002 Ford Taurus

1 Answer

Where is the oil sending unit located on a 93 ford taurus??


The oil pressure sending unit is located behind the oil filter.

Jan 31, 2009 | 1997 Dodge Avenger

1 Answer

Oil chandes and oil light


Sounds like you may not have gotten a full amount of oil in the car, or you may have a faulty oil sending unit. Regardless of that though, you most definitely do NOT need to change your oil every month. Do another oil change and make sure the proper amount of oil is put in (the capacity is listed in your owner's manual in the specifications section). Try it out and see if you continue to have this problem. If you do, it's possible that the sensor is bad and is telling you that you have less oil than you really do.

Oct 12, 2008 | 2002 Ford Taurus

1 Answer

Ford taurus automatic gearbox


sorry, none. We did not use this engine in Europe. And automatic transmissions are not popular in Europe.

Aug 16, 2008 | 1992 Ford Aerostar Extended

1 Answer

Air bag code


Hi, ON your 2002 ford taurus, The Flashing code 33 ( B 2292 )

This code refer to : Driver side seat belt pretentioner ( seat belt bucklet) problem.

Check the conecctions under the driver seat.
Repair as need, and recheck if thi code is present.

But if you had an accident on you taurus. You need to replace the Seat belt Pretentioner ( seat belt bucklet)

OK. I hope this information work for you.

Than's.

Jul 11, 2008 | 2002 Ford Taurus

Not finding what you are looking for?
2002 Ford Taurus SES Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...