Ford taurus 1993 transmission electrical sensor how many are them

Standard Motor Products NS58 Neutral Backup Switch
This is what it looks like, it should be located where the shift cable attaches at the transmission

If it is a front wheel drive care, which I think it is there is a good chance that it is the position selector sensor on the transmission.

it is not recomended! that u do this task ur self! very dangerous! u have to remove the h frame ! nothing will b holding the engine! it can fall out!

make sure all lines on each pully are facing the number 1 cylender at top dead center

I dont think that will work ....1988 was aod and aode trans

The AXOD-E was renamed AX4S in 1993. In addition to the name change, improvements in the lubrication of the gearset and capacity upgrades were made. A centrifugal piston assembly was implemented in the intermediate clutch position to improve 1st-2nd and 2nd-1st shift quality and an increase in the clutch's durability was made on some models. High energy friction materials were also introduced. A new twin piston torque converter clutch (TCC) was introduced with the AX4S and the AX4N on some models. The transaxle pan on this model will sometimes read "AXOD Metric" since it's based on the AXOD transaxle. The data plate code for this transmission is "L."
Applications:

• 1993–1994 Lincoln Continental
• 1993–2003 Ford Taurus
• 1993–2003 Mercury Sable
• 1995–2000 Ford Windstar

The Ford AX4S automatic transmission is a four-speed electronic overdrive transmission used in 1995 to 2000 Ford Windstar minivan. The transmission is also used in 1991 to 2003 Ford Taurus and Mercury Sable, and 1993 to 1995 Ford Taurus SHO models. The AX4S is a second-generation version of the AXOD and AXOD-E transmissions used in 1986 to 1991 Ford Taurus.

How many miles? Get the transmission serviced. Get the filter changed and get new fluid put in. Ford transmissions arent that great, but try getting the transmission serviced. I got a ford taurus that was said to have a bad trans. I changed the filter and put a new filter in. Voila, a 500 dollar car turned into a 3000 dollar car. : )

It is inside the that box on top of radiator with large wire plug. it cannot be replaced by itself. You must replace the whole unit.

The ford taurus is know for having a weak transmission, however if the transmission is serviced regularly you can avoid problems.

i Have 96 Taurus, may help you. May be a little different on 93. good luck. please rate if this is what you need.
-----------------------------------------------------------------------------
3.0L (2V) and 3.0L (4V) Engine
The vehicle speed sensor (VSS) (9E731) is:

• a Hall-effect pickup that sends a signal to the powertrain control module (PCM) (12A650).
• able to provide the VSS signal which tells the powertrain control module vehicle speed.

Vehicle Speed Sensor (VSS) (Except SHO) Removal and Installation

1. Disconnect battery ground cable (14301) and positive battery cable.
   

1. Raise and suitably support vehicle on hoist. Refer to Section 00-02 .
   

1. Remove three bolts, seven nuts and Y-pipe assembly from vehicle.
   

1. Disconnect vehicle speed sensor electrical connector.
   

1. Remove vehicle speed sensor retaining bolt and vehicle speed sensor (VSS) (9E731) from transaxle.
   

1. To install, reverse Removal procedure. Tighten VSS retaining bolt to 3.4-4.5 Nm (31-39 lb-in). Tighten Y-pipe assembly nuts and bolts to 34-46 Nm (26-34 lb-ft).