Question about Cars & Trucks

Open Question

The remotes don't open only works with wallmounted switchworks

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Back hatch won~t open with remote or inside door locks will open manually nothing stuck or jammed?


Found this wiring diagram for lift gate, if that is what we're talking about? Not only check the fuses, check fuse circuit for voltage. Use a testlite.
26171360-b5nbw0bij3qhlohrlmfokh55-1-0.jpg

Apr 21, 2016 | 2008 Pontiac Torrent

1 Answer

I have 2004 and the back hatch will not open,only use remote control to open ok,before I can manual open don';t need use remote control.


I have one doing the same thing right now you have to pull the inside cover off and free up the latch system it is probably the locking part of the latch

Oct 19, 2014 | 2004 Buick Rendezvous

1 Answer

My remote door opener don t work


You will need to reprogram them to your door opener.
Its about a $50.00 service call from an authorized service tech, or you can simply call the manufacturer and they would talk you through it.
You can also try the manufacturers web page and look for a manual for your particular unit.

Jan 13, 2014 | 2002 Pontiac Bonneville

1 Answer

Chrysler town and country electric door locks don't work


Do the windows work? Does the door lock work on either front door?

Oct 06, 2012 | 2005 Chrysler Town & Country

1 Answer

Yaris hatchback wont open


The remote may have a bad battery or the system has lost programming, refer to the owner's manual to change the battery in the remote and if that doesn't cure it the dealer must use a special tool to reprogram the system to the remote frequency. This solution is based on the fact that both the remotes don't work, the remote can be bad, this is esp true if it has been dropped.

Jul 27, 2012 | 2008 Toyota Yaris

1 Answer

Can a keyless entry remote work properly after dropping in a bucket of water?


As with just about any electronics, they don't mix well with water. The best thing to do would be to not push any buttons and remove the battery and open the remote so it can fully dry out before seeing if it still works.

Sep 10, 2011 | Nissan Altima Cars & Trucks

1 Answer

The remote control don´t open the rear door,


IT SHOULD OPEN WITH THE KEY ALSO.












TIM

Dec 20, 2010 | 2006 Chevrolet Equinox

2 Answers

Emergancy flashers work but turn signals dont in a 1994 oldsmobile cutlass supreme sl


Check fuses , they operate on different circuits, ie ignition or battery dependant on switchwork. But unlikely to be a short in indicator circuit seen as 4way works fine but still may be a fault in a shared circuit . You may be down another electrical componant but are unaware at the moment ! Good luck

Oct 26, 2009 | 1994 Oldsmobile Cutlass Supreme

2 Answers

I can't lock the car using the remote key. the light flashes on the key but does not lock the doors


try reprograming the remote, if that doesn't work u may need a new remote these are the factory instructions.
1. Switch ignition on with a key (don’t start the engine!); leave key in the ignition.
2. Mechanically lock vehicle at left front door, using second key.
3. On remote unit, press "Open" button once. A short horn signal will sound.
he "Open" button is pressed once for programming the first, or a single,
remote unit.
�� When programming additional remote units for the second, third or fourth
memory addresses, press the "Open" button two, three or four times, in
one-second intervals.
�� Example: press the "Open" button once, wait 1 second, then press once
again to program the second remote unit.
�� After 6 seconds, press "Open" button once to activate the coding ocess.

4. The remote unit will now be coded, and it can be used to unlock the central
locking system. Switch ignition off.

The key must be removed from the ignition before the remote unit can be used to lock
the vehicle.The coding process can be repeated up to 4 times for additional remote units.
In between each remote unit coding, the ignition must be switched off.

Apr 10, 2009 | 2004 Volkswagen Jetta

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...