Question about Cars & Trucks

Open Question

Sandlelford ES20 N15115 I lost code, but I could not open the door with the keys, any suggestion please

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have lost the key to my Mazda 626, I have a spare key but this only opens the door. It does turn the car over but because of immobiliser it won't start car. Going to cost $500 to get a new key through...


Without having a spare key with the chip, its going to be expensive.
A locksmith may be able to make a roadside service call and get it done, but probably not much cheaper than the dealer.

Jan 21, 2014 | Cars & Trucks

1 Answer

Key Duplicated won't open door works with ignition only


Your duplicate key may be a valet key which would not let a parking lot attendant into the trunk or the doors. If you don't have the original master key, you may have to get a locksmith involved. I doubt the dealer would have key codes for a model that old.

Jul 25, 2013 | 1999 Honda Accord

1 Answer

Help I lost my keys yesterday at work, got my spare keys but the reomte doesnt work. Now I can open the door, but the alars starts going off and the engine wont start!


Hi Jolli Nurse,

I'd guess and say the spare key was not the one which came with the vehicle? I believe you'll have to go to the closest agent and have them re code the key....Take the relevant engine, chassis and VIN numbers with you. they should be able to sort out the problem for you very quickly....when they quote the price, argue with them until it becomes reasonable for you....An additional suggestion is while there get another key and have it coded at the same time....Don't store with your mobile phone though.

Regards

Johngee10

Jan 25, 2011 | 2006 Kia Sedona

2 Answers

Replaced the Battery in the Key. It was not bad just replaced it as a preventative measure. The Ingnition wil not turn now. I can open the doors and hatch. I can place the key in the doorlock and turn...


You need to re-sync the Remote...

The remote handset uses a "rolling code" algorithm, meaning the code is changed every time remote locking or unlocking is performed. If you have removed the battery - then that Rolling code was lost.

If the normal Synchronization does not work, Possibly you will need to use the EKA Proceedure (Emergency Key Access).

Use this link to the appropriate information to aid you in solving your issues.

Oct 25, 2010 | 2005 Land Rover Range Rover

1 Answer

My sparekey will remotely open the doors and light up the dash, but will not start the car. There are no problems starting the car with my main key. We have wittled down the problem to the one key. As it...


the key has a coded magnet inbuilt and it has possibly lost its primary code(long story)so you will need to take all the keys to a dealer and have them all recoded.(change the remote batteries at the same time)droping or leaving keys next to the tv/microwave are the most common causes.

Aug 06, 2010 | 2001 BMW 5 Series

4 Answers

Lost car keys, how to replace ignition/door locks


Can u open the doors using the ignigtion key or is it two seperate keys?

May 03, 2009 | 1996 Ford Contour

1 Answer

Recode a key 4 bmw 318i cenral locking


To carry out this procedure you need to have one working key and one key which requires programming. It may help sometimes to hold the key close to the rear view mirror as this is where the sensor is located in most models. 1. With both keys, get in the car and close all windows and doors. 2. Put working key into the ignition and turn to position 1 (the accessories should turn on) (try also position 2) 3. Turn the key back to position 0 and take the key out of the ignition. 4. Using the working key, hold down the unlock button, press the BMW logo (lock button) 3 times, and release the unlock button. Doors should lock and unlock. 5. With the new key, hold down the unlock button and press the BMW logo (lock button) 3 times and let go of the unlock button. Doors should lock and unlock and you're done!! If not working try the following PREPARATION 1. Close all doors, trunk, hood and sunroof. 2. The security system must be in 'disarm' mode. The key must be removed from the ignition key slot. ENTER CODE LEARNING MODE 3. Open trunk and leave it opened. 4. Open the drivers door and sit in the drivers seat. 5. Close the drivers door. 6. Cycle the ignition switch 5 times between the 'OFF' position and position 2,(ignition 'ON', all dash warning lamps will illuminate). The red status LED will illuminate continuously, and the siren will 'chirp' once, to indicate that the code-learning mode has been initiated. ?Do No start the engine.? The Ignition switch cycling in step #6 must be performed within 10 seconds. The sequence in steps #1-#6 must be performed within 45 seconds. REGISTER/DELETE ID CODE(S) 7. Open drivers door, (remain seated in the drivers seat) 8. Close the drivers door. 9. Press and release any button on the remote you wish to register in the system. The status LED will shut off momentarily to indicate that one code has been registered. 10. Repeat steps 7 thru 9 to register the three ID codes. It is possible for the system to memorize a total of 4 different ID codes. As a new code is initialized into the memory, the oldest code is automatically deleted. If you had lost your remotes and wished to delete the lost remote ID codes from the memory, you could initialize the ID codes from a newly purchased replacement transmitter four times thereby deleting the previous ID codes from the system memory. EXITING CODE - LEARNING MODE: 11. Open drivers door, and exit from the vehicle, leaving the door opened. 12. Close trunk. 13. Close drivers door. The LED will turn off and the siren will 'chirp twice. 14. The initialization procedure is now completed; Test all remotes to confirm operation. If this doent work your alarm/central lock needs to be reset

Mar 28, 2009 | 1996 BMW 318

1 Answer

Side door lock on 2000 VW Beetle


the dealer gave you a ignition key, instead of valet key.
valet key should open the driver door and ignition. nothing else. if the key can't ope the door. try the trunk. if it open the trunk, the it is a wrong key.

Mar 25, 2009 | 2000 Volkswagen Beetle

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...