Question about 2004 Pontiac Montana

Open Question

To bypass 2004 Pontiac Montana pass key three

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

dgjtex
  • 405 Answers

SOURCE: 2004 Pontiac Montana blows cold air in defrost

There is a mix damper inside your duct that controls the heat over heater core and ac evaporator that to your floor and one to your defrost. it is probable an electric actuator, that is not functioning properly. If yu can locate it and manually move it, you might have to remove the actuator motor first, you should be able to figure out your problem, I hope this helps! merry Christmas!

Posted on Dec 22, 2008

  • 7 Answers

SOURCE: 2005 Pontiac SV6 Montana key fob unlocks doors but will not lock

For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.

Posted on Feb 14, 2009

hunterd777
  • 14 Answers

SOURCE: 1999 pontiac montana doors will not unlock with

your door lock actuators are bad.there electronic and are right costly

Posted on Apr 22, 2009

jandjdist
  • 45 Answers

SOURCE: my 2004 pontiac montana sv6 won't start. We get a

vacuum hose disconnected or leaking.

Posted on Dec 18, 2009

  • 8 Answers

SOURCE: Pontiac Montana SV6

For instructions on how to program remotes and keys check website below, I use these and they are usually very accurate. This website does state that on your vehicle, special equipment is needed to program a key fob, as there is no onboard programming for it. However, there are programming instructions for transponder keys.
http://www.programautokeys.com/

http://www.programautokeys.com/

Posted on Feb 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can i deactivate the anti theft system in my 2000 pontiac montana van or put a bypass on it?


I think this has 2 small diameter white wires that send a signal to allow it to start. if you look under the dash by the steering column you should see the wires. you can try to cut the wires and join the two wires that do not go up the column together to see if this will by pass the key switch.

Oct 11, 2014 | 2000 Pontiac Montana

1 Answer

How can I by pass the pass key code on my 99 pontiac montana


computer needs that chip in key. this is to prevent theft

Oct 07, 2014 | Cars & Trucks

1 Answer

1999 pontiac montana need new key only have pass key


Sorry but you will have to go the the dealer and have them cut and program a new key, good luck.

Mar 19, 2014 | 1999 Pontiac Montana

1 Answer

Our 99 Pontiac Montana will not start at all now. At first my husband thaught the fuel pump went out. and in the process of trying to get it home the starter went out of it. he replaced the starter pressed...


This is a pretty common problem on GM vehicles. Actually PASSLOCK is the MOST common problem on GM vehicles. Can be expensive to fix but yet rather cheap and perminant to bypass. If he is handy with cars at all, he can do this himself. Check out this link for info DO IT YOURSELF solutions.

http://vatspasslockpasskeysecurityhelp.yolasite.com/

Jun 14, 2011 | 1999 Pontiac Montana

1 Answer

Won't start checked to see if pass key fuse wasblowen its not


2002 pontiac montana won't start after driven ,wait about a hour and it will start up.what would cuase thi anybody know why it is doind this.put on scanner and it shows no codes. HELP!!!!!!!!!!!!!

Feb 17, 2010 | 2002 Pontiac Montana

1 Answer

2004 Pontiac Montana blows cold air in defrost


There is a mix damper inside your duct that controls the heat over heater core and ac evaporator that to your floor and one to your defrost. it is probable an electric actuator, that is not functioning properly. If yu can locate it and manually move it, you might have to remove the actuator motor first, you should be able to figure out your problem, I hope this helps! merry Christmas!

Dec 22, 2008 | 2004 Pontiac Montana

2 Answers

Command start on 2004 Montana not working


bypass it easiest way and cheapest

Nov 15, 2008 | 2002 Pontiac Montana

Not finding what you are looking for?
2004 Pontiac Montana Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...